Bedienungsanleitung ETA Systems ETA-S20

Inhaltszusammenfassung zur Seite Nr. 1

ETA-S20
AC Power Distribution Unit & Surge Suppressor
ETA-S20
AC Power Distribution Unit &
Surge Suppressor
1601 Jack McKay Blvd. • Ennis, Texas 75119 U.S.A.
Telephone: 800-321-6699 • Fax: 800-996-3821
– 1 – ETAsys.com
Specifications are subject to change without notice.

Inhaltszusammenfassung zur Seite Nr. 2

ETA-S20 AC Power Distribution Unit & Surge Suppressor TABLE OF CONTENTS Important Safety Instructions .................................................................................................................. 3 Introduction ........................................................................................................................................... 5 Key Features ............................................................................................................

Inhaltszusammenfassung zur Seite Nr. 3

ETA-S20 AC Power Distribution Unit & Surge Suppressor SAFETY INSTRUCTIONS The lightning flash with arrowhead symbol within an equilateral triangle, is intended to alert the user to the presence of uninsulated “dangerous voltage “ within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing)

Inhaltszusammenfassung zur Seite Nr. 4

ETA-S20 AC Power Distribution Unit & Surge Suppressor WARNING – WHEN THE DEVICE IS IN USE • T o prevent electric shock, do not remove the product cover as there are high voltage components inside. Refer all servicing to ETA Systems. • Should any of the following irregularities occur during use, immediately switch off the power , disconnect the power cord from the AC outlet and contact ETA Systems. Do not to attempt to continue operation with the product as this may cause fire or

Inhaltszusammenfassung zur Seite Nr. 5

ETA-S20 AC Power Distribution Unit & Surge Suppressor INTRODUCTION Thank you for purchasing the ETA Systems ETA-S20 AC Power Distribution & Surge Suppressor Unit. The ETA-S20 has been designed to meet most installation requirements for AC power distribution and equipment power protection. The ETA-S20 features noise filtering for unwanted Radio Frequency Interference (RFI) that is commonly introduced into AC lines by nearby radio transmitters or wireless products. The benefit of these filters

Inhaltszusammenfassung zur Seite Nr. 6

ETA-S20 AC Power Distribution Unit & Surge Suppressor FRONT PANEL FEATURES 1 4 5 2 3 1. Unswitched AC Outlet The 120V AC 20A NEMA 5-20R outlet is always live when the ET A-S20 power cord is plugged into an AC Mains power source and voltage is present. Note: The AC Mains power switch does not affect the Unswitched AC Outlet. The Unswitched Outlet is protected by the surge protection circuitry. 2. AC Mains Breaker The 120V AC 20A 2500W rated breaker will open if

Inhaltszusammenfassung zur Seite Nr. 7

ETA-S20 AC Power Distribution Unit & Surge Suppressor INSTALLATION Before installing, we strongly suggest you read the entire manual to ensure you benefit from all the features of the ET A-S20. The ETA-S20 can be placed on a shelf or rack mounted in a standard 19" width rack. When rack mounted, placement within the rack is flexible however the ET A-S20 should be within 6' of a dedicated 20A AC outlet. When rack mounting, use Rack Rail type screws which 10 are ⁄32" x 1". Always make sure the

Inhaltszusammenfassung zur Seite Nr. 8

ETA-S20 AC Power Distribution Unit & Surge Suppressor LIMITED WARRANTY All products manufactured by ETA Systems are warranted to the original dealer/installer, industrial or commercial purchaser to be free from defects in material and workmanship and to be in compliance with our published specifications, if any. This warranty shall extend from the date of purchase for a period of one year. Additionally, fuses and lamps carry no warranty. ETA Systems will solely at its discretion, replace at