Inhaltszusammenfassung zur Seite Nr. 1
EN
User manual
Fridge Freezer
ZRB934PW
ZRB934XL
Inhaltszusammenfassung zur Seite Nr. 2
Contents Safety information _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 2 Care and cleaning _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 5 Operation _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 4 Technical data _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 6 First use _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 4 Installation _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 7 Daily use _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 4 Environmental concerns _ _ _ _ _ _ _ _ _ _ _ _ _ _ 9 Helpful hints and tips _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Inhaltszusammenfassung zur Seite Nr. 3
squashed or damaged power plug may overheat Care and cleaning and cause a fire. • Before maintenance, switch off the appliance and dis- 3. Make sure that you can come to the mains plug connect the mains plug from the mains socket. of the appliance. • Do not clean the appliance with metal objects. 4. Do not pull the mains cable. • Do not use sharp objects to remove frost from the ap- 5. If the power plug socket is loose, do not insert pliance. Use a plastic scraper. the power plug. There is a ris
Inhaltszusammenfassung zur Seite Nr. 4
Environment Protection bish. The insulation foam contains flammable gases: the appliance shall be disposed according to the appli- This appliance does not contain gasses which cable regulations to obtain from your local authorities. could damage the ozone layer, in either its refrig- Avoid damaging the cooling unit, especially at the rear erant circuit or insulation materials. The appliance shall near the heat exchanger. The materials used on this ap- not be discarded together with the urban ref
Inhaltszusammenfassung zur Seite Nr. 5
Small pieces may even be cooked still frozen, directly Thawing from the freezer: in this case, cooking will take longer. Deep-frozen or frozen food, prior to being used, can be thawed in the refrigerator compartment or at room tem- perature, depending on the time available for this opera- tion. Helpful hints and tips • The thermic dilatation might cause a sudden crack- Normal Operating Sounds ing noise. It is natural, not dangerous physical phe- • You may hear a faint gurgling and a bubbling sou
Inhaltszusammenfassung zur Seite Nr. 6
Defrost the freezer when the frost layer reaches a thick- • switch on the cabinet and replace the frozen foodstuff. ness of about 3-5 mm. It is recommended to operate the appliance at the high- To remove the frost, follow the instructions below: est position of the thermostatic control for some hours so that it can reach the sufficient storing temperature as • pull out the plug from the wall socket or switch off soon as possible. the appliance • remove any stored food, wrap it in several layers
Inhaltszusammenfassung zur Seite Nr. 7
Installation Caution! Read the "Safety Information" carefully Warning! This appliance must be earthed. for your safety and correct operation of the The manufacturer declines any liability should appliance before installing the appliance. these safety measures not be observed. Positioning 1 2 Install this appliance at a location where the ambient tem- perature corresponds to the climate class indicated on the rating plate of the appliance: Climate Ambient temperature class SN +10°C to + 32°C 3
Inhaltszusammenfassung zur Seite Nr. 8
The appliance is supplied with a 13 amp plug fitted Removing the shelf holders 2 . In the event of having to change the fuse in the Your appliance is equipped with shelf retainers that plug supplied, a 13 amp ASTA approved (BS 1362) make it possible to secure the shelves during transpor- fuse must be used. tation. Warning! A cut off plug inserted into a 13 amp To remove them proceed socket is a serious safety (shock) hazard. Ensure as follows: that it is disposed of safely. 1. Move the shelf h
Inhaltszusammenfassung zur Seite Nr. 9
• Open the doors. Un- • Unscrew the lower • Remove the plugs (1) • Unscrew the upper screw the middle hinge hinge (b1) on the upper side of hinge pivot and place it (m2). Remove the plas- both doors and move on the opposite side. • Remove the left-hand tic spacer (m1). them to the other side. cover pins (b4) and • Fit the upper door on • Remove the spacer move to the other side. • Re-insert the lower the upper door pivot. (m6) and move to the door on the lower hinge • Re-screw the lower • Re-ins
Inhaltszusammenfassung zur Seite Nr. 10
10
Inhaltszusammenfassung zur Seite Nr. 11
11
Inhaltszusammenfassung zur Seite Nr. 12
www.zanussi.com/shop 210621291-26052010
