Inhaltszusammenfassung zur Seite Nr. 1
REFRIGERATOR
ZI 9155 A
ZI 9225 A
INSTRUCTION BOOKLET
2222748-77
Inhaltszusammenfassung zur Seite Nr. 2
Important Safety Instructions These warnings are provided in the interests of your safety. Ensure that you understand them all before installing or using this appliance. Your safety is of paramount importance. If you are unsure about any of the meanings of these warnings contact the Customer Care Department. Prior to Installation General Safety Check the appliance for transport damage. Under This appliance contains hydrocarbons in its no circumstance should a damaged appliance be cooling uni
Inhaltszusammenfassung zur Seite Nr. 3
At the end of the Appliance Life When disposing of your appliance use an authorised disposal site. The symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherw
Inhaltszusammenfassung zur Seite Nr. 4
Operation Before use Remove all securing tapes. Wash inside the Meat can only be stored safely in this way for one appliance with lukewarm water and bicarbonate of or two days at the most. soda (5 ml to 0.5 litre of water). Do not use soap or Fruit & vegetables: these should be thoroughly detergent as the smell may linger. Dry thoroughly. cleaned and placed in the bottom salad bin. Butter & cheese: these should be placed in special airtight containers or wrapped in aluminium foil or Setting the
Inhaltszusammenfassung zur Seite Nr. 5
Normal operating sounds You may hear faint gurgling or bubbling sounds when the refrigerant is pumped through the coils or tubing at the rear, to the cooling plate. When the compressor is on, the refrigerant is being pumped round, and you will hear a whirring sound or pulsating noise from the compressor. A thermostat controls the compressor, and you will hear a faint click when the thermostat cuts in and out. For more thorough cleaning, the top door shelf and the bottle shelf can be removed by
Inhaltszusammenfassung zur Seite Nr. 6
Defrosting The refrigerator automatically defrosts every time the compressor stops. The water is discharged, via the pipe, into a tray located at the back of the appliance above the compressor, where it evaporates. Important To avoid defrost water overflowing into the fridge, periodically clean the water discharge hole in the centre of the V shaped drip collector at the back of the refrigerator compartment behind the salad bin. Use the special cleaner provided which you will find already inserte
Inhaltszusammenfassung zur Seite Nr. 7
Something not Working? Before contacting your local Service Force Centre check the following points. IMPORTANT: If you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or installation, a charge will be made even if the appliance is under guarantee. Symptom Solution No power to appliance - Check there is power at the socket. - Check there is not a power cut by checking the household lights. - Check the fuse has not blown. The light does not come on - Ensu
Inhaltszusammenfassung zur Seite Nr. 8
Service and Spare Parts In the event of your appliance requiring service, or if For Customer Service in Ireland please contact us at you wish to purchase spare parts, please contact the address below: your local Service Force Centre by telephoning:- Zanussi 08705 929929 Electrolux Group (Irl) Ltd Long Mile Road Dublin 12 Your telephone call will be automatically routed to the Republic of Ireland Service Force Centre covering your post code area. Tel: + 353 1 4090751 For the address of your loca
Inhaltszusammenfassung zur Seite Nr. 9
Guarantee Conditions Standard guarantee conditions We, Zanussi, undertake that if within 24 months of the date of purchase this Zanussi appliance or any part thereof is proved to be defective by reason only of faulty workmanship or materials, we will, at our option repair or replace the same FREE OF CHARGE for labour, materials or carriage on condition that: The appliance has been correctly installed and used only on the electricity supply stated on the rating plate. The appliance has been u
Inhaltszusammenfassung zur Seite Nr. 10
Technical specifications ZI 9155 A ZI 9225 A POWER SUPPLY VOLTAGE AND FREQUENCY 220-240 V / 50 Hz 220-240 V / 50 Hz TOTAL POWER ABSORBED 110 W 140 W AVERAGE DAILY UNITS ELECTRICITY (*) 0,41 kWh 0,44 kWh GROSS CAPACITY 158 l 230 l NET CAPACITY 154 l 228 l (*) This figure is based on standard test results in accordance with European Standard EN153. Actual consumption will depend on how the appliance is used and where it is located. Installation The appliance should be located in a dry Warning atmo
Inhaltszusammenfassung zur Seite Nr. 11
Door reversal The appliances door has been locked in position for transport by means of pins on both sides. According to the door opening direction, remove the relevant A pins at the top and at the bottom. Attention After completion of the door reversing operation, check that the door gasket adheres to the cabinet. If the ambient temperature is cold (i.e. in Winter), the gasket may not fit perfectly to the cabinet. In that case, wait for the natural fitting of the gasket or accelerate this proc
Inhaltszusammenfassung zur Seite Nr. 12
Electrical Connection If you fit your own plug, the colours of the wires in the WARNING mains lead of your appliance, may not correspond THIS APPLIANCE MUST BE EARTHED. with the markings identifying the terminals in your The manufacturer declines any liability plug, proceed as follows: should this safety measure not be Connect the Green and the Yellow (earth) wire to the observed. terminal in the plug which is marked with the letter If the plug that is fitted to your appliance is not «E» or the
Inhaltszusammenfassung zur Seite Nr. 13
50 Building in Dimensions of the recess ZI 9155 A ZI 9225 A Height of housing (1) mm 880 1225 1 Depth of housing (2) mm 550 550 Width of housing (3) mm 560 560 2 D022 3 1. Fit the appliance in the niche by making sure that it stands against the interior surface of the unit on 1 2 the side where the door hinges of the appliances are fitted. Insert the appliance until the upper strip butts up against the unit (1) and make sure that the lower hinge is in line with the surface of the unit (2). PR0 I
Inhaltszusammenfassung zur Seite Nr. 14
21 mm 21 mm Ha C D Hc PR33 E B 7. Fix cover (Hc) on guide (Ha) until it clips into place. 4. Snap vent grill (B) and hinge cover (E) into position. Apply blanking covers (C-D) as indicated. 8mm Hb Ha Ha Hc Hb PR167 Hd 8. Open the appliance door and the furniture door at PR266 90°. Insert the small square (Hb) into guide (Ha). Put together the appliance door and the furniture 5. Separate parts Ha, Hb, Hc, Hd as shown in the door and mark the holes as indicated in the figure. figure. ca. 50 mm 90
Inhaltszusammenfassung zur Seite Nr. 15
Hb PR168 10. Place the small square on the guide again and fix it with the screws supplied. Should the alignment of the furniture door be necessary, use the clearance of slots. At the end of this procedure, it is necessary to check if the door of the furniture closes properly. Hb Hd PR167/1 11. Fix cover (Hd) on the small square (Hb) until it clips into place. 15
Inhaltszusammenfassung zur Seite Nr. 16
© Electrolux plc 2006
