Inhaltszusammenfassung zur Seite Nr. 1
SAMSUNG Home Appliance Service
Model:
SIDE-BY-SIDE REFRIGERATOR
RS2544
RS2622
RS2644
RS2666
RS2777
Inhaltszusammenfassung zur Seite Nr. 2
WARNING IMPORTANT SAFETY NOTICE The service guide is for service men with adequate backgrounds of electrical, electronic, and mechanical experience. Any attempt to repair a major appliance may result in personal injury and property damage. The manufacturer or dealer cannot be responsible for the interpretation of this information. SAMSUNG ELECTRONICS AMERICA, INC. Technical Service Guide Copyright ⓒ2002 All rights reserved. This service guide may not be reproduced in whole or in part in any form
Inhaltszusammenfassung zur Seite Nr. 3
Contents 1. Introduction ········································ 4 ········································ 2. Installation 5 ·······································6 3. Nomenclature ·······································7 4. Specifications ···································8 5. Warranty information ·····························9 6. Interior Views and Dimensions ················· 7. Refrigeration Cycle and Cool Air Circulation Route 11 ································ 8. Mechanical Disass
Inhaltszusammenfassung zur Seite Nr. 4
1. INTRODUCTION ● ● SAMSUNG side by side refrigerator has the following characteristics. 1) Twin Cooling System ·The refrigerator and the freezer have two evaporators. Given this independent system, the freezer and the refrigerator are cooled individually as required and are, therefore, more efficient. Food odor from the refrigerator does not affect food in the freezer due to separate air flow circulation. 2) Multi-Flow System ·Cool air circulates through multiple vents on every shelf le
Inhaltszusammenfassung zur Seite Nr. 5
2. INSTALLATION 1) To protect refrigerator in movement Use padded hand truck as shown. If entrance width is 〃 less than 39 , remove doors prior to installation and reattach doors according to procedure below. 2) Remove all protective tape and pad in refrigerators. Connect water lines and power cord. Adjust the clearance between the doors. 3) Set the temperature control to the temperature and wait for an hour. The refrigerator should get slightly chilled and the motor runs smoothly. 4) Once
Inhaltszusammenfassung zur Seite Nr. 6
3. Nomenclature 2002 Models R S 25 44 SW / XAA Company Name COLOR ; SBS SW-SNOW WHITE SL-NOBLE STAIN BMF SW-SNOW WHITE SL-NOBLE GRAY OPTION ; 25 Cu.ft 44-GOOD 26 Cu.ft 22-GOOD 44-BETTER 66-BEST 27 Cu.ft 77-BEST Capacity ; CU. FT Family ; S - SIDE BY SIDE (SBS) TM H - HomePAD (SIDE BY SIDE) B - BOTTOM MOUNTED FREEZER (BMF) Product ; R - REFRIGERATOR Label Location 6
Inhaltszusammenfassung zur Seite Nr. 7
4. Specifications ELECTRICAL SPECIFICATIONS Freezer Refrigerator Defrost Control From 24 to 32 hrs Thermo-Bimetal 54℉(off)/23℉(on) Defrost Thermistor(502AT) 50℉(off) Electrical Rating AC115V 60Hz, 4.8 Amps Maximum Current Leakage 0.25 mA Maximum Ground Path Resistance 0.1 Ohm Energy Consumption KWH/mo. NO LOAD PERFORMANCE Ambient Temperature 70℉ 90℉ Refrigerator,℉ 34∼46 34∼46 F Fan Fan an F Fan Fan an Freezer,℉ -14∼8
Inhaltszusammenfassung zur Seite Nr. 8
5. Warranty information 8
Inhaltszusammenfassung zur Seite Nr. 9
6. Interior Views and Dimensions 6-1) Shelves and Bins Freezer S2544/2622 Model S2777/2666 Model RS2644 Model TM TM ith CoolSelectZone with CoolSelectZone Refrigerator RS2666/2777) RS2666/2777) RS2644/2666/2777) Chilled Bin)(RS2777) 9
Inhaltszusammenfassung zur Seite Nr. 10
Interior Views and Dimensions 6-2) Dimensions of Refrigerator (Inches) A D B C TM Beverage Station (RS2666/RS2777) - Dimensions Model - Dimensions Model 28 RS2544 47.2 RS2544 A D 30 RS2622/2644/2666/2777 49.2 RS2622/2644/2666/2777 35 RS2544 54.2 RS2544 B E 37 RS2622/2644/2666/2777 56.3 RS2622/2644/2666/2777 1.97 RS2622/2644/2666 C 3.35 RS2544/2777 10 D E
Inhaltszusammenfassung zur Seite Nr. 11
7. Refrigeration Cycle and Cool Air Circulation Route 7-1) Refrigerant Route in Refrigeration cycle Compressor → Sub-condenser → Side Cluster Pipe(FRE) → Side Cluster Pipe(REF) → Hot Pipe → Dryer → Capillary Tube → Refrigerator Evaporator → Freezer Evaporator→ Suction Pipe → Compressor Refrigerator Evaporator SIDE CLUSTER PIPE ACCUMULATOR Freezer Evaporator Dryer Hot Pipe SUCTION PIPE SUB-CONDENSER Capillary Tube Muffler Compressor Hot Pipe 11
Inhaltszusammenfassung zur Seite Nr. 12
Refrigeration Cycle and Cool Air Circulation Route 7-2) Cool Air Circulation Freezer Refrigerator 12
Inhaltszusammenfassung zur Seite Nr. 13
8. Mechanical Disassembly 8-1) Refrigerator Disassembly Control Panel ········································ 14 Door Handle ········································ 14 TM Beverage Station ····································· 14 Door Gasket ········································· 14 Refrigerator Door Light Switch ······························ 15 Refrigerator Light ······································ 15 Tempered Glass Shelf ··································· 15 Plastic Drawers in Refrige
Inhaltszusammenfassung zur Seite Nr. 14
88.. M Meecchhaanniiccaall D Diissaasssseem mb bllyy 8-1) Refrigerator Disassembly TM Control Panel Beverage Station TM The beverage station allows access to the 1. Insert a flat-blade screwdriver on the slot as shown, refrigerator without opening the refrigerator door. and unlock the tabs. TM 1. Open the door beverage station 2. Disconnect the wire connector in the back of control 2. With a small flat-blade screwdriver,take out the panel. rubbercap, then put it into the small hole and
Inhaltszusammenfassung zur Seite Nr. 15
M Meecchhaanniiccaall D Diissaasssseem mb bllyy Refrigerator Door Light Switch The refrigerator has a door light switch located in the upper right corner for the refrigerator. 1. Use a small flat-blade screwdriver to unlock the locking tab and pull the switch out until the wire connector is visible. Plastic Drawers in Refrigerator Drawers are designed for storage of fruits, vegetables, and deli items. The drawers are located in the lower portion of the refrigerator. 1. Pull out the drawer as f
Inhaltszusammenfassung zur Seite Nr. 16
M Meecchhaanniiccaall D Diissaasssseem mb bllyy Water Filter The water filter is located in the upper right-hand corner of the refrigerator. The water filter filters water for the ice maker and the water dispenser. 1. Turn the water filter 1/2 turn counterclockwise and pull it down. 2. To install the filter, align the indication mark (unlock position) and push it up while turning 1/2 turn clockwise until the lock position is aligned. Do not over tighten. Upper Ductwork 1. Remove the screw
Inhaltszusammenfassung zur Seite Nr. 17
M Meecchhaanniiccaall D Diissaasssseem mb bllyy Evaporator in Refrigerator Refrigerator Thermistor Refrigerator Thermistor Evaporator is located in the bottom of refrigerator. 1. Take off the ductwork in refrigerator. The refrigerator thermistor is located inside of the 2. Disconnect the wire connector.(Heater and upper light cover of the refrigerator. Thermistor) 3. Desolder the capillary tube and the suction line Thermistor from the evaporator. 4. Remove the evaporator. 5. With a file, score
Inhaltszusammenfassung zur Seite Nr. 18
M Meecchhaanniiccaall D Diissaasssseem mb bllyy 8-2) Freezer Disassembly Door Bin in Freezer The door bins allow storage of perishable items. 1. Push the bin up and slide it out. Freezer Shelf The shelves slide out for easy access for frozen items. 1. Slide the shelf out until it reaches its stop. Freezer Door Light Switch 2. Tilt down and slide it out of the compartment. This switch is located in the left-hand portion of the freezer and sends a signal to the processor. 1. With a small flat-blad
Inhaltszusammenfassung zur Seite Nr. 19
M Meecchhaanniiccaall D Diissaasssseem mb bllyy top of the liner, and slide the ice maker in. 5. Tighten the screws (2) of the ice maker support. Auger Motor Case This shelf is designed to support the ice maker ＆ TM The ice maker is located inside of the ice dispenser ice dispensed and Xtra Space . TM assembly. 1. Remove the Xtra Space cover to push it down 1. Remove ice maker support screws (2), and slide out. near the partition. 2. Disconnect the ice maker wire connector. 2. Slide the partit
Inhaltszusammenfassung zur Seite Nr. 20
M Meecchhaanniiccaall D Diissaasssseem mb bllyy Freezer Light Upper Ductwork The freezer light is located in the bottom of the 1. Remove the screw cap and screw. auger motor case. The light is covered by an opaque 2. Slide the upper fan ductwork out while cover. disconnecting the wire connector (Lamp and 1. Remove the screw and the light cover. Thermistor). Evaporator Cover in Freezer 1. Pull out the screw caps and remove screws (6). 2. Remove the ductwork of the evaporator fan in the Evapor
