Inhaltszusammenfassung zur Seite Nr. 1
LRSC21951ST
Inhaltszusammenfassung zur Seite Nr. 2
Table of contents Introduction Entry 3 Important safety instruction 3 Identification of parts 4 Where to install 5 Installation Door removal 6 Door replacement 7 Feed water pipe installation 7 Water connection instruction guide 8 Operation instruction guide 10 Height adjustment 12 Operation Starting 13 Adjusting the temperatures and functions 13 Shelf (Applicable to some models olny) 19 Wine holder (Applicable to some models olny) 19 Egg box 20 Humidity control in the vegetable compartment 20 Co
Inhaltszusammenfassung zur Seite Nr. 3
Introduction Entry The model and serial numbers are found on the inner case or back of refrigerator compartment of this unit. These numbers are unique to this unit and not available to others. You should record requested information here and retain this guide as a permanent record of your purchase. Staple your receipt here. Date of purchase : Dealer purchased from : Dealer address : Dealer phone no. : Model no. : Serial no. : Important safety instruction Before it is used, this refrigerator mus
Inhaltszusammenfassung zur Seite Nr. 4
Introduction Child entrapment DANGER: Risk of child entrapment. Before you throw away your old refrigerator or freezer: warning Take off the doors but leave the shelves in place so that children may not easily climb inside. The appliance is not intended for use by young children or infirm persons without supervision. Young children should be supervised to ensure that they do not play with the appliance. Don’t store or use gasoline or other flammable vapor and liquids in the vicinity of this or
Inhaltszusammenfassung zur Seite Nr. 5
Installation Where to install 1. Place your appliance where it is easy to use. Select a good location 2. Avoid placing the unit near heat sources, direct sunlight or moisture. 3. To avoid vibrations, the appliance must be leveled. 4. Don't install the appliance below 5°C. It may cause affect the performance. 5
Inhaltszusammenfassung zur Seite Nr. 6
Installation Door removal Warning Electric Shock Hazard Disconnect electrical supply to refrigerator before installing. Failure to do so could result in death or serious injury. If your access door is too narrow for the refrigerator to pass through, remove the Lower cover refrigerator door and pass the refrigerator laterally. Remove lower Remove the lower cover by lifting upward, and cover and then pull up the feed water tube while pressing Feed water tube area shown in the figure to the ri
Inhaltszusammenfassung zur Seite Nr. 7
Installation Pass the Pass the refrigerator laterally through the access refrigerator door as shown in the right figure. Max 5 4 3 2 FR 1 Z 1 2 3 4 5 T R E EF M P M Door replacement Mount them in the reverse sequence of removal after they pass through the access door. Feed water pipe installation Before Automatic ice maker operation needs water pressure of 147~834 kPa (1.5~8.5 2 kgf/cm ) (That is, an instant paper cup (180 cc) will be fully filled within 3 sec.). installation 2 If water pres
Inhaltszusammenfassung zur Seite Nr. 8
Installation Water connection instruction guide Connecting Read all directions carefully before you begin. the refrigerator to a water source Warning Connect to potable water supply only. IMPORTANT • If operating the refrigerator before installing the water connection, turn ice maker to the OFF position to prevent operation without water. • All installations must be in accordance with local plumbing code requirements. • Use copper tubing and check for leaks. • Install copper tubing only in are
Inhaltszusammenfassung zur Seite Nr. 9
Installation Connect 1. Unplug refrigerator or disconnect power. the tubing to 2. Turn OFF main water supply. Turn ON nearest faucet long enough to empty water line water pipes. 3. Find a 1/2 - inch to 1-1/4 - inch vertical COLD water pipe near the refrigerator. NOTE • Horizontal pipe will work, but the following precaution must be taken: Drill on the top side of the pipe, not the bottom. This will help keep water away from the drill. This also keeps normal sediment from collecting in the valve
Inhaltszusammenfassung zur Seite Nr. 10
Installation Operation instruction guide Connect the tubing to Before making the connection to the the refrigerator refrigerator, be sure the refrigerator Copper tubing power cord is not plugged into the wall (Provided) Compression nut outlet. (Provided) 1. Remove the plastic flexible cap from Ferrule (sleeve) the water valve. 2. Place the compression nut and ferrule (sleeve) onto the end of the tubing as shown. Water valve 3. Insert the end of the copper tubing into the water valve connection
Inhaltszusammenfassung zur Seite Nr. 11
Installation When ice maker Ice is clumped together does not operate When ice is clumped together, take the ice clumps out of the ice storage bin, smoothly break them into small pieces, and then place them into the ice storage bin again. When the ice maker produces too small or clumped ice, the amount of water supplied to the ice maker need to adjusted. Contact the service center. If ice is not used frequently, it may clump together. Power failure Water may drop into the freezer compart
Inhaltszusammenfassung zur Seite Nr. 12
Installation Height adjustment If the freezer Level the door by inserting flat ( - type) driver into the groove of the left height adjusting screw and rotate it clockwise (). compartment door is lower than the refrigerator compartment door If the freezer Level the door by inserting flat ( - type) driver into the groove of the right height compartment door adjusting screw and rotate it clockwise (). is higher than the refrigerator compartment door After leveling the The refrigerator doors w
Inhaltszusammenfassung zur Seite Nr. 13
Operation Starting When your refrigerator is first installed, allow it to stabilize at normal operating temperatures for 2-3 hours prior to filling it with fresh or frozen foods. If operation is interrupted, wait 5 minutes before restarting. Adjusting the temperatures and functions MIN MAX LOCK FRZ TEMP LOCK ON MIN MAX REF TEMP SUPER FRZ OFF ROOM TEMP DISPENSER WATER CRUSHED CUBED Dispenser selection button. Super freezer. Temperature adjustment button for refrigerator compartment. Lock button
Inhaltszusammenfassung zur Seite Nr. 14
ON DISPENSER SUPER FRZ MIN TEMP REF LOCK MIN TEMP FRZ MAX MAX OFF Operation You can adjust temperature of and freezer room and refrigerator room. How to adjust the temperature in the freezer compartment How to adjust the temperature in the refrigerator compartment ❇ Whenever pressing button, setting is repeated in the order of (Middle) ➔ (Middle Strong) ➔ (Strong) ➔ (Weak) ➔ (Middle Weak). The actual inner temperature varies depending on the food status, as the indicated setting temperature
Inhaltszusammenfassung zur Seite Nr. 15
Operation Operation The automatic ice maker can automatically make 8 pieces of ice cube at a time, Automatic ice maker 80 pieces a day. But these quantities may be varied according to various conditions including how many times the refrigerator door opens and closes. Ice making stops when the ice storage bin is full. If you don't want to use automatic ice-maker, change the ice-maker switch to ON - OFF. If you want to use automatic ice-maker again, change the switch to OFF-ON. NOTE • It i
Inhaltszusammenfassung zur Seite Nr. 16
DISPENSER SUPER FRZ MAX MIN TEMP REF MIN LOCK MAX FRZ EMP DISPENSER SUPER FRZ MAX MIN TEMP REF LOCK MIN FRZ EMP MAX DISPENSER SUPER FRZ MAX MIN TEMP REF LOCK MAX MIN TEMP FRZ ON OFF ON Operation Operation The other Ambient temperature display window. functions ROOM Temperature is displayed only by 16°F~ 120°F. TEMP Temperature less than 14°F is indicated with ‘LO’ and temperature more than 122°F is indicated with ‘HI’. Temperature may differ from the actual ambient temperature as it is
Inhaltszusammenfassung zur Seite Nr. 17
Operation NOTE • Crushed ice will be automatically selected after a power failure or when the power plug is connected again. • Place glasses or other containers near the ice outlet otherwise ice is likely to be dropped on the floor. • A snap sound will be heard in 5 seconds after ice is fully dispensed. This sound is made when the ice outlet is closed. • Please leave your glass near the ice outlet for 2-3 seconds after releasing your glass from pressing the push switch to allow any left over
Inhaltszusammenfassung zur Seite Nr. 18
Operation Cautions Throw away the ice (about 20 pieces) and water (about 7 glasses) first made after refrigerator installation. The first ice and water may include particles or odor from the feed water pipe or feed water box. This is necessary in case that the refrigerator has not been used for a long time. Keep children away from the dispenser. Children may push switch incorrectly bad or damage lamps. Be careful that food is not block the ice passage. If foods are placed at the entrance of ic
Inhaltszusammenfassung zur Seite Nr. 19
Operation Shelf (Applicable to some models only) You can store taller items such as a gallon container or bottles by simply pushing Silde-Under in front half of shelf underneath back half of shelf. Pull toward you to return to a Shelf full shelf. Wine holder (Applicable to some models only) Wine holder Bottles can be stored laterally with this wine corner. This can be attached to any adjustment shelf. 2 In case of inserting the wine holder : Pull the wine holder downward as in after inserting
Inhaltszusammenfassung zur Seite Nr. 20
Operation Egg box You can move the egg box to a place you want and select another form of box according to the amount of eggs. [Normal] [For Many Eggs] NOTE • Never use the egg box as an ice storage bin. It can break. • Never store the egg box in the freezer compartment or fresh compartment. Humidity control in the vegetable compartment The humidity can be controlled by adjusting the humidity control switch to the left/right when storing vegetabes or fruits. High humidity Close Open Low humidity
