Inhaltszusammenfassung zur Seite Nr. 1
GEAppliances.com
Safety Instructions . . . . . . . . . . .2–4
Owner’s Manual
and Installation
Operating Instructions
Models 21, 23, 25, 27, and 29
Additional Features . . . . . . . . . . . .11
Automatic Icemaker . . . . . . . . . . .13
Care and Cleaning . . . . . . . . . .15, 16
CustomCool™ . . . . . . . . . . . . . . .6, 7
Profile Côte à Côte
Ice and Water Dispenser . . . . .14, 15
Refrigerator Doors . . . . . . . . . . . .11
Réfrigérateurs
Replacing the lightbulbs . . . . . . . .17
Shelves an
Inhaltszusammenfassung zur Seite Nr. 2
IMPORTANT SAFETY INFORMATION. READ ALL INSTRUCTIONS BEFORE USING. WARNING! Use this appliance only for its intended purpose as described in this Owner’s Manual. SAFETY PRECAUTIONS When using electrical appliances, basic safety precautions should be followed, including the following: n This refrigerator must be properly installed n Keep fingers out of the “pinch point” areas; n n and located in accordance with the Installation clearances between the doors and between Instructions before it is us
Inhaltszusammenfassung zur Seite Nr. 3
Safety Instructions Operating Instructions Installation Instructions Troubleshooting Tips Consumer Support www.GEAppliances.com DANGER! RISK OF CHILD ENTRAPMENT PROPER DISPOSAL OF THE REFRIGERATOR Child entrapment and suffocation are not problems CFC Disposal of the past. Junked or abandoned refrigerators are Your old refrigerator may have a cooling system still dangerous…even if they will sit for “just a few that used CFCs (chlorofluorocarbons). CFCs are days.” If you are getting rid of your o
Inhaltszusammenfassung zur Seite Nr. 4
IMPORTANT SAFETY INFORMATION. READ ALL INSTRUCTIONS BEFORE USING. WARNING! HOW TO CONNECT ELECTRICITY Do not, under any circumstances, cut or remove the third (ground) prong from the power cord. For personal safety, this appliance must be properly grounded. The power cord of this appliance is equipped with This provides the best performance and also a 3-prong (grounding) plug which mates with a prevents overloading house wiring circuits which standard 3-prong (grounding) wall outlet to could cau
Inhaltszusammenfassung zur Seite Nr. 5
Safety Instructions Operating Instructions Installation Instructions Troubleshooting Tips Consumer Support About the temperature controls. www.GEAppliances.com The temperature controls are preset in the factory at 37°F for the refrigerator compartment and 0°F for the freezer compartment. Allow 24 hours for the temperature to stabilize to the preset recommended settings. The temperature controls can display both the SET temperature as well as the actual temperature in the refrigerator and freeze
Inhaltszusammenfassung zur Seite Nr. 6
™ About CustomCool. How it Works The pan is tightly sealed to prevent the pan’s The CustomCool™ feature is a system of dampers, a fan, a temperature thermistor, temperature from causing temperature fluctuations in the rest of the refrigerator. and a heater. Depending on the function selected, a combination of these will be The controls for this pan are located at the used to quickly chill items, thaw items or top of the refrigerator with the temperature hold the pan at a specific temperature. co
Inhaltszusammenfassung zur Seite Nr. 7
Safety Instructions Operating Instructions Installation Instructions Troubleshooting Tips Consumer Support www.GEAppliances.com CustomCool™ Chart NOTE: Results may vary depending on packaging, starting temperature, and other food traits. 0.5 Lbs. (4 hours) 15 Minutes Citrus Setting (43°F) n Hamburger Patties (0.5 lb) n 1 Beverage Can (12 oz) n Oranges, Lemons, Limes, Pineapple, Cantaloupe n Individually Wrapped n 2 Small Juice Boxes (6–8 oz each) Filet Mignon (0.5 lb) n Beans, Cucumbers, Tomatoe
Inhaltszusammenfassung zur Seite Nr. 8
™ About the water and FreshSaver filters. Run water from the dispenser for Water Filter Cartridge 1 3 minutes (about 1 ⁄2 gallons) to clear The water filter cartridge is located in the the system and prevent sputtering. back upper right corner of the refrigerator compartment. Press and hold the RESET WATER FILTER pad on the dispenser for 3 seconds. When to Replace the Filter NOTE: A newly-installed water filter There is a replacement indicator light for cartridge may cause water to spurt from
Inhaltszusammenfassung zur Seite Nr. 9
Safety Instructions Operating Instructions Installation Instructions Troubleshooting Tips Consumer Support About the shelves and bins. www.GEAppliances.com Not all features are on all models. Refrigerator Door Bins and Freezer Door Tilt-Out Bins Snugger Large Bins The snugger helps prevent tipping, spilling or sliding of small items stored on the door The larger refrigerator door bins and shelf. Place a finger on either side of the freezer tilt-out door bins are adjustable. snugger near the re
Inhaltszusammenfassung zur Seite Nr. 10
About the shelves and bins. Not all features are on all models. Slide-Out Spillproof Shelf The slide-out spillproof shelf allows you to reach items stored behind others. The special edges are designed to help prevent spills from dripping to lower shelves. To remove: Press tab and pull shelf Slide the shelf out until it reaches the stop, forward to remove then press down on the tab and slide the shelf straight out. To replace or relocate: Line the shelf up with the supports and slide it into pl
Inhaltszusammenfassung zur Seite Nr. 11
Safety Instructions Operating Instructions Installation Instructions Troubleshooting Tips Consumer Support About the additional features. www.GEAppliances.com Not all features are on all models. Removable Beverage Rack The beverage rack is designed to hold To install: a bottle on its side. It can be attached to Line up the large part of the slots on any slide-out shelf. the top of the rack with the tabs under the shelf. Then slide the rack back to lock it in place. 1 2 About the refrigerator
Inhaltszusammenfassung zur Seite Nr. 12
T S E D L O C About the crispers and pans. Not all features are on all models. Fruit and Vegetable Crispers Excess water that may accumulate in the bottom of the drawers should be wiped dry. On some models the bottom drawer has a cover that slides back as the drawer is opened. This allows full access to the drawer. As the drawer is closed, the cover will slide forward into its original position. Adjustable Humidity Crispers HI LO Slide the control all the way to the HI setting Slide the control
Inhaltszusammenfassung zur Seite Nr. 13
Safety Instructions Operating Instructions Installation Instructions Troubleshooting Tips Consumer Support www.GEAppliances.com About the automatic icemaker. A newly-installed refrigerator may take 12 to 24 hours to begin making ice. If ice is not used frequently, old ice cubes Automatic Icemaker Power Switch will become cloudy, taste stale and shrink. Icemaker The icemaker will produce seven cubes If ice cubes get stuck in the icemaker, the per cycle—approximately 100–130 cubes green power l
Inhaltszusammenfassung zur Seite Nr. 14
About the ice and water dispenser. To Use the Dispenser Select CUBED ICE , CRUSHED ICE Dispenser Light or WATER . This pad turns the night Press the glass gently against the top of light in the dispenser the dispenser cradle. on and off. The light also comes on when The spill shelf is not self-draining. the dispenser cradle is To reduce water spotting, the shelf and pressed. If this light its grille should be cleaned regularly. burns out, it should be If no water is di
Inhaltszusammenfassung zur Seite Nr. 15
Safety Instructions Operating Instructions Installation Instructions Troubleshooting Tips Consumer Support www.GEAppliances.com Ice Storage Drawer on Dispenser Models Rotate To remove: Set the icemaker power switch to the 0 (off) position. Pull the drawer straight out and then lift past the stop position. To replace: Drive When replacing the drawer, be sure to Mechanism press it firmly into place. If it does not go all the way back, remove it and rotate the drive mechanism 1/4 turn. Then push
Inhaltszusammenfassung zur Seite Nr. 16
Care and cleaning of the refrigerator. Behind the Refrigerator Be careful when moving the refrigerator When pushing the refrigerator back, make sure away from the wall. All types of floor you don’t roll over the power cord or icemaker coverings can be damaged, particularly supply line. cushioned coverings and those with embossed surfaces. Pull the refrigerator straight out and return it to position by pushing it straight in. Moving the refrigerator in a side direction may result in damage to th
Inhaltszusammenfassung zur Seite Nr. 17
Safety Instructions Operating Instructions Installation Instructions Troubleshooting Tips Consumer Support T S E D L O C Replacing the lightbulbs. www.GEAppliances.com Setting the controls to OFF does not remove power to the light circuit. Refrigerator Compartment—Upper Light Unplug the refrigerator. After replacing the bulb with an appliance bulb of the same or lower The bulbs are located at the top of the wattage, replace the light shield and compartment, inside the light shield. Tabs screws (
Inhaltszusammenfassung zur Seite Nr. 18
Trim kits and decorator panels. ™ For CustomStyle models Read these instructions completely and carefully. Before You Begin Some models are equipped with trim kits that allow you to install door panels. You can order pre-cut black, white, almond, bisque, or stainless steel decorator panels from GE Parts and Accessories, 800.626.2002, or you can add wood panels to match your kitchen cabinets. Panels less than 1/4† (6 mm) thick When installing wood panels less than 1/4† (6 mm) thick, you need to
Inhaltszusammenfassung zur Seite Nr. 19
Safety Instructions Operating Instructions Installation Instructions Troubleshooting Tips Consumer Support Dimensions for Custom Wood Panels Freezer Panel Freezer Panel Without Dispenser With Dispenser Fresh Food Panel Cut 1/8† Cut 1/8† 1/8† Cut out (3 mm) out (3 mm) (3 mm) out 5/16† 1 (8 mm) 1 1 11 ⁄4† 11 ⁄4† 11 ⁄4† 1 1 1 5/16† (28.6 cm) 5/16† (28.6 cm) (28.6 cm) 1 ⁄8† 1 ⁄8† 1 ⁄8† (8 mm) (8 mm) (2.9 cm) (2.9 cm) (2.9 cm) 1 1 1 2 ⁄2† 2 ⁄2† 2 ⁄2† 7 17 ⁄8† (6.4 cm) (6.4 cm) (6.4 cm) (45.4 cm) 5 5
Inhaltszusammenfassung zur Seite Nr. 20
Inserting the door panels. Read these instructions completely and carefully. Loosen the Top Trim on the Freezer and Fresh Food Doors. Using a T-20 Torx driver, loosen the two screws attaching the Top Trim about 1/4† (6 mm). Insert the Freezer Panel and Fresh Food Panel. If your model has a dispenser and/or a Lift the Top Trim up 1/4† (6 mm) and carefully push the freezer panel in until it slides into the slot Refreshment Center, this step only applies to the top panels. behind the door handle.
