Inhaltszusammenfassung zur Seite Nr. 1
SANTO
Built-In Refrigerator
Operating and Installation instructions
U 9 60 40-4 i
Inhaltszusammenfassung zur Seite Nr. 2
Dear customer, Before switching on your new appliance please read these operating instructions carefully. They contain important information for safe use, for installation and for care of the appliance. Please keep these operating instructions for future reference. Pass them on to possible new owners of the appliance. These operating instructions are for use with several technically com- parable models with varying accessories. Please observe the notes which apply to your model. Notes which are
Inhaltszusammenfassung zur Seite Nr. 3
Contents Important Safety Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4 Disposal . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .6 Appliance Packaging Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .6 Disposal of old Appliances . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .6 Remove transport packaging . . . . . . . . . . . . . . .
Inhaltszusammenfassung zur Seite Nr. 4
Important Safety Instructions These warnings are provided in the interests of your safety. Ensure you fully understand them before installing or using the appliance. Your safety is of paramount importance. If you are unsure about the meaning of these warnings contact the Customer Care Department for assistance. Intended use • The refrigerator is intended for use in the home. It is suitable for the cooling, freezing and storing of frozen food, as well as for making ice. If the appliance is used f
Inhaltszusammenfassung zur Seite Nr. 5
Important Safety Instructions Please make old appliances unusable prior to disposal. Pull out the mains plug, cut off the mains cable, break or remove spring or bolt catches, if fitted. By doing this you ensure that children cannot lock themselves in the appliance when playing (there is risk of suffoca- tion!) or get themselves into other dangerous situations. Often children cannot recognise the hazards present in household appliances. It is therefore important that you ensure adequate super
Inhaltszusammenfassung zur Seite Nr. 6
Under no circumstances should you attempt to repair the appliance yourself. Repairs carried out by inexperienced persons may cause injury or serious malfunctioning. Contact your local AEG Service Force Centre. Disposal Appliance Packaging Information All materials are environmentally sound! They can be disposed of or burned at an incinerating plant without danger. About the materials: The plastics can be recycled and are identified as follows: >PE< for polyethylene, e.g. the outer covering and
Inhaltszusammenfassung zur Seite Nr. 7
contact your local city office, your household waste disposal service or the shop where you purchased the product. Remove transport packaging The appliance and the interior fittings are protected for transport. 1. Pull off the adhesive tape on the left and right side of the door. 2. Remove all adhesive tape and packing pieces from the interior of the appliance. Installation Installation Location The appliance should be set up in a well ventilated, dry room. Energy use is affected by the ambien
Inhaltszusammenfassung zur Seite Nr. 8
Installation It is necessary to avoid overheating of the refrigerator by maintaining adequate distances from heat sources and by the use of a suitable thermal insulation plate. Proper ventilation of the appliance must also be ensured. Grid preparation The side at which the door opens can be changed from the right side (as supplied) to the left side, if the installation site requires. Warning! When changing the side at which the door opens, remove plug from the mains. Left door opening: 1. Remove
Inhaltszusammenfassung zur Seite Nr. 9
Installation 6 Reversing the door 4 The side at which the door 1 opens can be changed from the right side (as supplied) to the left side, if the installation site requires. 5 To reverse the opening direction of the door, pro- 6 2 ceed as shown in the fig- ures: 3 1 6 7 8 2 6 10 Warning! After completion of the door reversing operation, 13 check that the door gasket adheres to the cabinet. If the ambient temperature is cold (i.e. in Winter), the gasket may not fit perfectly to the 9 cabinet. In
Inhaltszusammenfassung zur Seite Nr. 10
600 550 min. Installation Changing over the freezer compartment door Building the appliance in under a worktop The dimensions of the recessed installation area must correspond with those indicated in the figure. DO013 10 600
Inhaltszusammenfassung zur Seite Nr. 11
Installation Installation kit Two cabinet securing brackets are supplied with the installation pack. They need to be assembled onto the cabinet prior to cabinet being pushed into the Kitchen aperture. 1. To fit these brackets remove the two a) screws at the top left and right hand front corners of the cabinet. 2 2. Position the two brackets b) as shown in the figure and replace the two securing screws. Left hand bracket Right hand bracket 2 11
Inhaltszusammenfassung zur Seite Nr. 12
Installation Push the appliance into place. The plug socket necessary for connection of the appliance to the elec- tricity supply should be positioned, so that the plug is not placed in the recess. 3. To adjust the height proceed as follows: Loosen or tighten the two front feet. The rear feet are adjusted by turning the screw in the front kick plate to the left or right. If necessary, pads (E) are supplied for the rear feet to make sliding the appliance in and out of the rece
Inhaltszusammenfassung zur Seite Nr. 13
Installation 5. Push the appliance into place and retain the cabinet with screws (I) through the securing brackets into the worktop or adja- cent woodwork as necessary. 6. To mount the furniture door proceed as shown in the fig- ures: 13
Inhaltszusammenfassung zur Seite Nr. 14
Installation Upper part of kitchen furniture panel
14
Inhaltszusammenfassung zur Seite Nr. 15
Installation 7. Refit the covering strip. 15
Inhaltszusammenfassung zur Seite Nr. 16
Installation Fitting the plinth Important! For the efficient operation of the appliance, it is important that the original ventilation grid is used. For an opening height dimension A=820 mm and a plinth height dimension a=100 mm, the plinth may be fitted without adjustments. The same applies to an opening height dimension B=870 mm and a plinth height dimension b=150 mm. For plinth heights greater than a=100 mm, b=150 mm, a cut should be made in the plinth, 580 mm wide, in the cen
Inhaltszusammenfassung zur Seite Nr. 17
Installation The mains cable may only be changed by a qualified electrician or competent person. If your appliance needs repairing, please contact your local AEG Service Force Centre. Electrical Connection Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. WARNING – THIS APPLIANCE MUST BE EARTHED The manufacturer declines any liability should these safety mea- sures not be observed. Before switching on, make sure the elect
Inhaltszusammenfassung zur Seite Nr. 18
Description of the appliance View of the appliance ➆➆ ➀➀ ➅➅ ➁➁ ➄➄ ➃➃ ➂➂ 1 Butter/cheese compartment 2 Sliding shelf 3 Bottle shelf 4 Vegetable drawers 5 Storage shelves 6 Thermostat 7 Freezer compartment Prior to Initial Start–Up Please clean the appliance interior and all accessories prior to initial start-up (see section: “Cleaning and Care”). 18
Inhaltszusammenfassung zur Seite Nr. 19
Starting up and temperature regulation Important! Only use the appliance when built–in! 1. Connect the appliance to the mains electricity supply. When the refrigerator compartment door is opened, the internal light- ing is switched on. The temperature control knob is located on the right hand side of the refrigerator compartment. Setting “0” means: Off. 2. Turn the control knob clockwise past “1”. The refrigerating unit is now on and operates automatically. Setting “1” means: Hightest te
Inhaltszusammenfassung zur Seite Nr. 20
If this happens, turn the thermostat knob back to a warmer setting (position “3” to “4”). At this setting the compressor will be switched on and off as usual and automatic defrosting recommenced. Switching off the appliance To switch off the appliance, turn the temperature regulator to position "0". If the appliance is not going to be used for an extended period: 1. Remove all refrigerated and frozen packages. 2. Switch off the appliance by turning the thermostat knob to position "0". 3. Rem
