Inhaltszusammenfassung zur Seite Nr. 1
KDC-5026
KDC-5026G
CD-RECEIVER
INSTRUCTION MANUAL
© B64-2697-00/00 (MW)
Inhaltszusammenfassung zur Seite Nr. 2
Contents Safety precautions 3 Menu system 17 Menu System Notes 5 Security Code Touch Sensor Tone About CDs 6 Manual Clock Adjustment DSI (Disabled System Indicator) General features 7 Switching Display Type Power Contrast Adjustment Selecting the Source CRSC (Clean Reception System Circuit) Volume Text Scroll System Q Basic Operations of remote 20 Audio Control Speaker Setting Loading and Replacing the battery Switching Display Basic operations Station/Disc Naming (SNPS/DNPS) In Tuner source Au
Inhaltszusammenfassung zur Seite Nr. 3
Safety precautions 2WARNING 2CAUTION To prevent injury or fire, take the To prevent damage to the machine, take following precautions: the following precautions: • Insert the unit all the way in until it is fully locked • Make sure to ground the unit to a negative 12V in place. Otherwise it may fall out of place when DC power supply. jolted. • Do not open the top or bottom covers of the unit. • When extending the ignition, battery, or ground • Do not install the unit in a spot exposed to dire
Inhaltszusammenfassung zur Seite Nr. 4
Safety precautions About CD players/disc changers NOTE connected to this unit • If you experience problems during installation, KENWOOD disc changers/ CD players released in consult your Kenwood dealer. 1998 or later can be connected to this unit. • If the unit fails to operate properly, press the Reset Refer to the catalog or consult your Kenwood button. The unit returns to factory settings when dealer for connectable models of disc changers/ the Reset button is pressed. If the unit stil
Inhaltszusammenfassung zur Seite Nr. 5
Notes Cleaning the Unit The marking of products using lasers If the faceplate of this unit is stained, wipe it with a (Except for some areas) dry soft cloth such as a silicon cloth. If the faceplate is stained badly, wipe the stain off CLASS 1 with a cloth moistened with neutral cleaner, then wipe neutral detergent off. LASER PRODUCT The label is attached to the chassis/case and says • Applying spray cleaner directly to the unit may affect its that the component uses laser beams that have
Inhaltszusammenfassung zur Seite Nr. 6
About CDs Handling CDs Removing CDs • Don’t touch the recording surface of the CD. When removing CDs from this unit pull them out horizontally. CDs that can’t be used • CDs that aren’t round can’t be used. • CD-R and CD-RW are easier to damage than a normal music CD. Use a CD-R or a CD-RW after reading the caution items on the package etc. • Don’t stick tape etc. on the CD. • CDs with coloring on the recording surface or that Also, don’t use a CD with tape stuck on it. are dirty can’t be use
Inhaltszusammenfassung zur Seite Nr. 7
General features Release button SRC Q/AUD FM AM SCAN RDM REP M.RDM 4 ¢ FM AM VOL DISP/NAME.S Power Volume Turning ON the Power Increasing Volume Press the [SRC] button. Turn the [VOL] knob clockwise. Decreasing Volume Turn the [VOL] knob counterclockwise. • When the power is ON, the 'Security Code' (page 18) is displayed as "CODE ON" or "CODE OFF". Turning OFF the Power Press the [SRC] button for at least 1 second. Selecting the Source Press the [SRC] button. Source required Display Tuner "TUNE
Inhaltszusammenfassung zur Seite Nr. 8
General features System Q You can recall the best sound setting preset for • Volume offset: Each source's volume can be set as a different types of music. difference from the basic volume. • Loudness: Compensating for low and high tones 1 Select the source to set during low volume. Press the [SRC] button. 5 Exit Audio Control mode 2 Select the Sound type Press the [AUD] button. Press the [Q] button. Each time the button is pressed the sound setting switches. Sound setting Display Speaker S
Inhaltszusammenfassung zur Seite Nr. 9
In CD & External disc source Information Display Disc title (In External disc source) "D-TITLE" Track title (In External disc source) "T-TITLE" Track number & Play time "P-TIME" Disc name "DNPS" Clock In Auxiliary input source Information Auxiliary input name Clock • If the Disc title or Track title is selected when the disc which does not have Disc title or Track title is played, track number and play time are displayed. English | 9
Inhaltszusammenfassung zur Seite Nr. 10
General features Station/Disc Naming (SNPS/DNPS) Auxiliary Input Display Setting Attaching a title to a Station or CD. Selecting the display when this device is switched to Auxiliary input source. 1 Receive/play the station/disc you want to attach a title to 1 Select Auxiliary input source Press the [SRC] button. Select the "AUX1" display. • A title can't be attached to an MD. • Refer to the 'Switching Display' (page 8) and select 2 Enter Auxiliary input display setting mode either "DNPS" or
Inhaltszusammenfassung zur Seite Nr. 11
• The faceplate is a precision piece of equipment and can be damaged by shocks or jolts. For that reason, keep the faceplate in its special storage case while detached. • Do not expose the faceplate or its storage case to direct sunlight or excessive heat or humidity. Also avoid places with too much dust or the possibility of water splashing. Reattaching the Faceplate 1 Align the shaft on the unit with the depression on the faceplate. 2 Push the faceplate in until it clicks. The faceplat
Inhaltszusammenfassung zur Seite Nr. 12
Tuner features SRC FM AM SCAN RDM REP M.RDM 4 ¢ FM AM 1–6 AUTO/AME Preset station number ST indicator Frequency display Band display Tuning Mode 3 Tune up or down band Press the [4] or [¢] button. Choose the tuning mode. Press the [AUTO] button. • During reception of stereo stations the "ST" indicator Each time the button is pressed the Tuning is ON. mode switches as shown below. Tuning mode Display Operation Auto seek "AUTO 1" Automatic search for a station. Function of remote Preset station
Inhaltszusammenfassung zur Seite Nr. 13
Canceling Direct Access Tuning Frequency Step Setting Press the [DIRECT] button on the remote. Changing the tuning frequency step. The original setting is FM band 50 kHz, and AM band 9 kHz. While pressing the [1] and [5] button, press Station Preset Memory the Reset button. The frequency step changes to FM band 200 kHz, Putting the station in the memory. and AM band 10 kHz. 1 Select the band Press the [FM] or [AM] button. • When the same operation is repeated, it returns to the 2 Select the
Inhaltszusammenfassung zur Seite Nr. 14
CD/External disc control features Release button SRC 38 FM AM SCAN RDM REP M.RDM DISC+ DISC– 4 ¢ SCAN RDM REP M.RDM DISP Disc number IN indicator Pause and play Playing CD Press the [38] button. Each time the button is pressed it pauses and When there is no disc inserted plays. 1 Drop open the faceplate Press the Release button. Eject the disc 2 Insert a disc. 1 Drop open the faceplate Press the Release button. 3 Press the faceplate on the left side, and return it to its former position. 2 Eje
Inhaltszusammenfassung zur Seite Nr. 15
Playing External Disc Track Search Playing discs set in the optional accessory disc Selecting the song you want to hear. player connected to this unit. Press the [4] or [¢] button. Press the [SRC] button. Select the display for the disc player you want. Display examples: Function of disc changer Display Disc player Disc Search "CD2" CD player Selecting the disc you want to hear. "DISC CH" CD changer/ MD changer Press the [DISC–] or [DISC+] button. Pause and play Press the [38] button. Each time
Inhaltszusammenfassung zur Seite Nr. 16
CD/External disc control features Function of disc changer Track/Disc Repeat Magazine Random Play Replaying the track/disc you're listening to. Play the songs on all the discs in the disc changer Press the [REP] button. in random order. Each time the button is pressed the Repeat Play switches as shown below. Press the [M.RDM] button. Each time the button is pressed the Magazine Repeat play Display Random Play turns ON or OFF. Track Repeat "(T-)REP ON" When it's ON, "MRDM ON" is displayed. Dis
Inhaltszusammenfassung zur Seite Nr. 17
Menu system SRC MENU FM AM SCAN RDM REP M.RDM 4 ¢ FM AM Menu display Menu System 4 Exit Menu mode Press the [MENU] button. Setting during operation beep sound etc. functions. The Menu system basic operation method is • When other items that are applicable to the basic explained here. The reference for the Menu items operation method above are displayed afterwards their setting content chart is entered. (Normally the and their setting content is after this operation uppermost setting in the
Inhaltszusammenfassung zur Seite Nr. 18
Menu system In Standby mode "APPROVED" is displayed. The unit can be used. Security Code Because authorization by the Security Code is • If an incorrect code is input, "WAITING" is displayed, required when it's removed from the vehicle, and the input prohibited time shown below is personalizing this unit is by using the Security generated. Code is a help in preventing theft. After the input prohibited time lapses, "CODE" is displayed, and input can be done. • When the Security Code functi
Inhaltszusammenfassung zur Seite Nr. 19
DSI (Disabled System Indicator) Text Scroll A red indicator will blink on the unit after the Setting the displayed text scroll. faceplate is removed, warning potential thieves. Display Setting Display Setting "SCL AUTO" Repeats scroll. "DSI ON" LED flashes. "SCL MANU" Scrolls when the display changes. "DSI OFF" LED OFF. • The text scrolled is shown below. - CD text - MD title Switching Display Type Setting the Display type. Display Setting "DISP C" Demonstration. "DISP A" Normal display ty
Inhaltszusammenfassung zur Seite Nr. 20
Accessory of the KDC-5026 Basic Operations of remote SRC SRC VOL. ATT ATT 38 VOL. 38 FM+ FM/AM/DISC+/DISC– DISC 4 AM– ¢ 4/¢ DNPP DNPP DIRECT /SBF /OK Not Used DIRECT/OK ABC DEF GHI JKL MNO [0] — [9] PRS TUV WXY QZ Loading and Replacing the battery Basic operations Use two "AA"-size batteries. [VOL.] buttons Slide the cover while pressing downwards to Adjusting the volume. remove it as illustrated. [SRC] button Insert the batteries with the + and – poles aligned Each time the button is pressed
