Inhaltszusammenfassung zur Seite Nr. 1
11 cu.ft.
Tall Larder
Fridge
TLDA 567
BEKO plc
Beko House
Caxton Way
Watford
Hertfordshire
WD18 8UF
Tel: 0845 6004911
Printed in Turkey
Fax: 0845 6004922
e-mail: service@beko.co.uk
Part no: 48 6204 00 02
website: www.beko.co.uk
Inhaltszusammenfassung zur Seite Nr. 2
Congratulations on your choice of a quality Appliance which has been designed to give you CONTENTS PAGE service for many years. WARNING ! IMPORTANT ! DO NOT connect your appliance to the electricity supply until all packing and transit protectors have SAFETY FIRST / ELECTRICAL REQUIREMENTS 3 been removed. • Leave to stand for at least 4 hours before switching on to allow compressor oil to settle if transported horizontally. TRANSPORTATION INSTRUCTIONS 4 • If you are discarding
Inhaltszusammenfassung zur Seite Nr. 3
ELECTRICAL REQUIREMENTS TRANSPORTATION INSTRUCTIONS Before you insert the plug into the wall socket make sure that the voltage and the 1. The appliance should be transported only in a vertical upright position. The frequency shown in the rating plate inside the appliance corresponds to your packing as supplied must be intact during transportation. electricity supply. Rating plate is affixed on the left hand side of inner liner 2. If during the course of transport the appliance has to be transpor
Inhaltszusammenfassung zur Seite Nr. 4
SIDE FITTING HANDLE If you would prefer, we can supply free of charge a side fitting handle that because of it‘s more central location might make opening the door easier, if you find the current and integrated handle design too high for you. Also, if you have purchased the matching freezer (TZDA568F) and obtained a handle for that, you might want to make it so the two models look the same. INSTRUCTIONS TO OBTAIN & FIT THE OPTIONAL SIDE FITTING HANDLE: To fit the handle, simply remove the two pla
Inhaltszusammenfassung zur Seite Nr. 5
IMPORTANT GETTING TO KNOW YOUR LARDER FRIDGE INSTALLATION INSTRUCTIONS 1. The space in the room where the appliance is installed must not be smaller than 10 cubic metres. 2. If possible avoid placing the appliance near cookers, radiators or in direct sunlight as this will cause the compressor to run for long periods. If installed 9 3 next to a source of heat or refrigerator, maintain the following minimum side clearances: 10 1 9 2 From Cookers 2" (50 mm) 3 From R
Inhaltszusammenfassung zur Seite Nr. 6
TEMPERATURE CONTROL AND ADJUSTMENT The following guidelines and recommendations are suggested to obtain the best results and storage hygiene. Operating temperatures are controlled by the thermostat (see 1.The larder fridge is suitable for the short term storage of fresh food and drinks. 5 diagram). Settings may be made from 1 to 5, the coldest position. 2.Cooked dishes must be stored in airtight covered containers. 3.Fresh wrapped produce can be placed on the shelf. Fresh fruit and When the
Inhaltszusammenfassung zur Seite Nr. 7
STARTING CLEANING AND CARE Final Check ** We recommend that you switch off the larder refrigerator at the socket outlet Before you start using the refrigerator check that: and pull out the mains plug before cleaning. 1. The front feet have been adjusted so the appliance is level. ** Never use any sharp instruments or abrasive substances, soap, household 2. The interior is dry and air can circulate freely. cleaner, detergent and wax polish for cleaning. 3. Clean the interior as recommend
Inhaltszusammenfassung zur Seite Nr. 8
REPLACING THE INTERIOR LIGHT BULB (See diagram) DO'S AND DON'TS Should the light fail to work switch off at the socket outlet and pull out the mains Do- Clean your larder refrigerator regularly. plug. Follow the instructions below to check if the light bulb has worked itself loose. Do- Keep raw meat and poultry below cooked food and dairy products. Do- Keep food for as short a time as possible and adhere to 'Best Before' and If the light still fails to work obtain a replacement E14 s
Inhaltszusammenfassung zur Seite Nr. 9
(12) REVERSING THE DOOR We recommend that you reverse the door before switching on for the first time. Tools required: Small and medium size flat and cross-headed screwdrivers, a pair of pliers. Spare Parts supplied in the plastic bag: The following parts, which are exclusively for left hand side fitted hinge operation are supplied in a plastic bag with the appliance: - Door top trim hinge covers – there are 2 different parts, one for each side of top trim. 5 We suggest you keep all the parts su
Inhaltszusammenfassung zur Seite Nr. 10
HOW TO OBTAIN SERVICE GUARANTEE DETAILS Please keep your purchase receipt or other proof of purchase in a safe place; you will need to have it should the product require attention under guarantee. Your new Beko product is guaranteed against the cost of breakdown repairs for twelve months from the date of the original purchase. You should also complete the details below; it will help us assist you when requesting service. (The model number is printed on the Instruction Booklet and the serial Wha