Bedienungsanleitung Harbor Freight Tools CENTRAL PNEUMATIC 47407

Inhaltszusammenfassung zur Seite Nr. 1

2 Gallon, 100 PSI oIlleSS
aIr ComPreSSor
model 47407
aSSembly and oPeratIon InStruCtIonS
Due to continuing improvements, actual product may differ slightly from the product described herein.
®
3491 Mission Oaks Blvd., Camarillo, CA 93011
Visit our website at: http://www.harborfreight.com
t o PreVent SerIouS Injury, read and underStand
all warnInGS and InStruCtIonS before uSe.
© ®
Copyright 2002 by Harbor Freight Tools . All rights reserved. No portion of this manual
or any artwork contained

Inhaltszusammenfassung zur Seite Nr. 2

Specifications Power Requirement 120 V~, 2.2 A 2 gallon, 0.3 SCFM @ 90 PSI; 0.58 SCFM @ 40 Tank Capacity PSI Cut-in at 73 PSI; shuts off automatically at 100 PSI Pressure Switch (150 sec. on, 350 sec. off) Piston Diameter 30 mm Air Outlet 1/4 inch, 18 NPT Pressure Tank Gauge 0 ~ 150 PSI x 1-3/4 inch diameter Regulator Gauge 0 ~ 150 PSI x 2 inch diameter Power Cord 78 inches; 3-prong plug Air Hose 25 foot, coil with chuck Oil-less, direct drive, thermal overload protection; Features carrying h

Inhaltszusammenfassung zur Seite Nr. 3

6. dress properly. Do not wear loose clothing or jewelry as they can be caught in moving parts. Protective, electrically non-conductive clothes and non-skid footwear are recommended when working. Wear restrictive hair covering to contain long hair. 7. use eye and ear protection. Always wear ANSI approved impact safety goggles. Wear an ANSI approved dust mask or respirator when working around metal, wood, and chemical dusts and mists. 8. do not overreach. Keep proper footing and balance

Inhaltszusammenfassung zur Seite Nr. 4

capability (up to 50 feet), with wire size rated at 18 awG . Longer extension cords require larger size wire. If you are using the tool outdoors, use an extension cord rated for outdoor use (signified by “WA” on the jacket). 20. Pacemaker safety warning. People with pacemakers should consult with their physician(s) before using this product; operation of equipment in close proximity to a heart pacemaker could cause interference or failure of the pacemaker. 21. drain compressor every day. Do

Inhaltszusammenfassung zur Seite Nr. 5

assembly 1. Attach the Coil Air Hose to the Air Outlet as shown below. Regulator Pressure Gauge I (46) Regulator Pressure Gauge II (50) Pressure Release Valve Coil Air Hose Regulator Adjusting Knob (53) 2. Attach the Blow Gun (with desired tip), tire chuck, or other user supplied attachment to the other end of the Coil Air Hose. operation t urning Compressor on 1. Plug the power cord into an electrical outlet with a grounding prong. note: only use a 115V electrical source (± 10% maximum varia

Inhaltszusammenfassung zur Seite Nr. 6

empty air and Condensation The water spill valve Petcock (11) is located underneath the Air Tank (shown in the photo on page 4). It must be used daily to release all trapped moisture from the tank. It will also get rid of any condensation that may cause tank corrosion. warning: do not open the water Spill Valve so that more than four threads are show- ing. 1. Push the On/Off Switch to turn the compressor off. 2. Unscrew the water spill valve Petcock (11) two to three turns only. 3. When all p

Inhaltszusammenfassung zur Seite Nr. 7

Parts list Part description Part description Part description 1 Handle 21 Screw, M4x10 41 Motor Drive 2 Shroud 22 Screw, M3x5 42 Gasket 3 Switch 23 Washer 43 Cover 4 Screw 24 Frame for Circle Board 44 Screw, Stun 5 Fan 25 Circle Board 45 Rubber Frame 6 Nut, M3 26 Screw Regulator Pressure 46 Gauge I 7 Screw, M3x10 27 Cylinder Heat 47 Connector II 8 Air Pressure Switch 28 O-Ring 48 Connector III 9 Base Plate & Tank 29 Spring Plate 49 Safety Valve 10 Drainage Valve 30 Plate Regulator Pressure 11

Inhaltszusammenfassung zur Seite Nr. 8

assembly drawing Limited 1 Year arrantY w Harbor Freight Tools Co. makes every effort to assure that its products meet high quality and durability standards, and warrants to the original purchaser that this product is free from defects in materials warranty and workmanship for the period of one year from the date of purchase. This warranty does not apply to damage due directly or indirectly to misuse, abuse, negligence or accidents; repairs or alterations outside our facilities; or to lack