Inhaltszusammenfassung zur Seite Nr. 1
D y Mo e D y Mor e T me
Cool down Less T me Loude On
Cus omer A to D y Off
Extend trumble Bulky ems u Softe
Less D y Timed D y Off
Rack DRY W inkle
Cycle Ca e
Heavy Du y Casual Timed Signal
Cycles Cycles
Towels Co on Delica e
r r r Time On( Hour) i Power
On/Off
GDZ22-2 High Delay i r
t Start Start
Medium It r r Pause
r Low Normal r
Air Only(No Heat) r
Dryness r
Level t
Temp
/ tt t
Time Re ma n i n i g (Mn i )
Cycl e compl eted
Electric
Dryer
User Manual-
Model #
GDZ22-2
Inhaltszusammenfassung zur Seite Nr. 2
1. 2. Do not dry articles that have been previously cleaned in,washed in, soaked in,or spotted with gasoline, dry-cleaning solvents, or other flammable or explosive substances, as they give off vapors that could ignite or explode. 3. Do not allow children to play on or in the appliance. Close supervision of children is necessary when the appliance is used near children. 4. Before the appliance is removed from service or discarded, remove the door to the drying
Inhaltszusammenfassung zur Seite Nr. 3
16. This dryer must be properly installed in accordance with the installation instructions before it is used. See grounding instructions in the installation section. 17. Proper grounding must be ensured to reduce the risk of electric shock and fire. Check with a qualified electrician or service personnel if you are in doubt as to whether the dryer is properly grounded. 18. Use the dryer only for its intended purpose, drying clothes. 19. Always disconnect dryer from elect
Inhaltszusammenfassung zur Seite Nr. 4
Tables Of Contents PAGE Safety Instructions ............................................................................ 1 OPERATING INSTRUCTIONS ............................................................ 4 Understanding the Control Panel .......................................................... 4 Preparations before drying .................................................................. 6 Load clothes into dryer ...................................................................... 7 Auto
Inhaltszusammenfassung zur Seite Nr. 5
OPERATING INSTRUCTIONS Understanding the Control Panel Time Remaining(Min) More Time Power Dry More Dry Time On(Hour) On/Off Cool down On High Delay Less Time Louder Cycle completed Start GDZ22-2 Start Off Medium Customer Auto Dry Softer Pause Extend tumble Normal Bulky Items Low Timed Dry Off Less Dry Wrinkle Air Only(No Heat) Rack Dry Care Cycle Dryness Heavy Duty Casual Level Timed Signal Temp Cycles Cycles Cotton Delicate 12 Time Remaining(Min) More Time Power Dry More Dry Time On(Hour) On/
Inhaltszusammenfassung zur Seite Nr. 6
Cycle Signal Button: (4) Used to select buzzing volume or turn off the buzzer. Timed/Cycles Button: (5) "Timed/Cycles" button will let you select your desired dry mode. Auto Dry: automatically set "Dryness Level", "Temp", "Cycle Signal", "Wrinkle Care" buttons status according to clothes loaded. Timed Dry: you can set status of "Temp", "Cycle Signal" and "Wrinkle Care" buttons and dry time with "More Time" and "Less Time" buttons by yourself. Rack Dry: the program used to dry article like spor
Inhaltszusammenfassung zur Seite Nr. 7
Status lights: (11) Status lights give notification of which part of the cycle the machine is in. Nixie display: (12) Indicate remaining time (min) during cycle operation. Indicate remaining reserved time (hr) during reservation. Note: if door opened during cycle running, displays "E2" and alarms. Understanding the Function Light Indicator: The function "display light" indicates selected feature is "ON" or the cycle is about to begin. During the dry cycle, "flashing light" indicates current r
Inhaltszusammenfassung zur Seite Nr. 8
Load clothes into dryer Auto Dry cycle and Timed Dry cycle The appropriate load shall be 1/3 ~ 1/2 of the drum volume. Avoid too much load, for a certain space is needed to allow clothes free rotation for uniform and wrinkle- proof drying. When drying big articles, only 2-3 pieces shall be loaded at a time and supplemented with middle and small articles. For elaborate clothes or less load, two towels without lint falling may be added to get better drying and wrinkle-proof effects. Do not exce
Inhaltszusammenfassung zur Seite Nr. 9
Various button initial status for "Normal program" Cycle Signal Softer Wrinkle Care Off Normal Cycles Nixie display Indicate current program remaining time Temp High More Dry Dryness Level Timed/Cycles Auto-program 2. Press "Cycles" button to select a suitable full automatic cycle The Normal program will be automatically selected after powering on. If other full automatic program is desired, press "Auto-program Selection" button until corresponding indicator turns on. Customer Normal Bulky I
Inhaltszusammenfassung zur Seite Nr. 10
3. Press "Dryness Level" button to select a suitable drying time After powering on, the clothes dryer automatically sets dryness at "More Dr y", which means the normal drying time. If other drying time is desired, press "Dryness Level" button to select a shorter time. 4. Press "Temp" button to set a suitable drying temperature After switching on, the dryer sets corresponding temperature adapting to different program selected. If other drying temperature is wanted, press "Temp" button to ena
Inhaltszusammenfassung zur Seite Nr. 11
Timed Dry cycle Time Remaining(Min) More Time Power Dry More Dry Time On(Hour) On/Off Cool down On High Delay Less Time Cycle completed Louder Start Start Off Customer Medium Auto Dry Softer Extend tumble Pause Normal Bulky Items Low Timed Dry Less Dry Off Wrinkle Air Only(No Heat) Rack dry Care Cycle Dryness Heavy Duty Casual Level Timed Signal Cycles Temp Cycles Cotton Delicate 4 5 2 6 7 8 1 3 1. Press "Power On/Off" button to power on 2. Press "Timed/Cycles" button and select "Timed Dry" cycl
Inhaltszusammenfassung zur Seite Nr. 12
1. Press "Power On/Off" button to power on 2. Press "Timed/Cycles" button and select "Rack Dry" cycle After powering on, press "Timed/Cycle" button to select "Rack Dry" program. 3. Press "More Time" And "Less Time" buttons to set a suitable time After setting "Timed/Cycle" to "Rack Dry" , you can press these two buttons to increase or decrease drying time as you desires. 4-7. Press buttons "Temp", "Cycle Signal", "Delay Start", and "Wrinkle Care" to define your desired program Notes
Inhaltszusammenfassung zur Seite Nr. 13
Normal Operating Sounds The following sounds are normally heard during the operation of the dryer. Tumbling sounds: This is normal as the heavy wet clothes in the dryer are continuously being tossed around. Air rushing noise: This happens as the dryer drum spins at very high RPM and the air is rushing through the dryer drum. Tips For bestdrying results, cleanthelint filter beforeandafter every use. Do not overload the dryer. Balance the dryer load, evenly Throughout the dryer for the best resu
Inhaltszusammenfassung zur Seite Nr. 14
Care and Cleaning Guide Lint filter needs to be cleaned before and after each use for your unit to Operate at optimum efficiency. The filter can be slid out, by pulling on The tab located on the inside of the dryer door. The filter may be Washed or vacuumed. Remove the excess water from the filter by Gently shaking the filter. This will remove dust and particles trapped in The filter. Lint build-up in screen restricts airflow, which causes longer Drying times. After cleaning, slide the filter
Inhaltszusammenfassung zur Seite Nr. 15
Troubleshooting Dryer does not operate: Check if unit is plugged in. The plug may have come loose. Check if the electrical wall socket is the correct voltage. Check if the circuit breaker needs to be reset or if the fuse needs to be replaced. Check if the unit is in Off mode. Press Power On/Off button again. Check if door is open or not in place. Open and close the door slightly and make sure in place. Dryer is working but not drying the clothes: Unit may be over loaded. The dryer drum should
Inhaltszusammenfassung zur Seite Nr. 16
INSTALLATION INSTRUCTIONS Select a suitable location for the dryer on a hard even surface away from direct sunlight or heat source e.g. radiators, baseboard heaters, cooking appliances etc. Any floor unevenness should be corrected with the leveling legs located on the bottom of the dryer. Tools and Materials Required Phillips head and flathead screwdrivers Channel-lock adjustable pliers 1/2 inch open end wrench Spirit level Measuring tape (12ft. Min.) Duct tape Rigid or flexible metal 4 inch (1
Inhaltszusammenfassung zur Seite Nr. 17
Exhaust System Connections Requirements and Instructions 1. Do not use plastic flexible duct to exhaustthe dryer. Excessive lint can build up inside system and create a fire hazard and restrict air flow. Restricted air exhaust flow will increase dryer times. If your present system is made up of plastic duct or metal foil duct, replace it with a rigid or flexible metal duct. Ensure present duct is free of any lint prior to installing dryer duct. 2. If the dryer is not exhausted out doors, some f
Inhaltszusammenfassung zur Seite Nr. 18
Materials Use only 4 inch (10.2 cm) diameter (minimum) rigid or flexible metal duct and approved vent hood which has a swing-out damper cover open when the dryer is in operation. When the dryer stops, the dampers automatically close to prevent drafts and the entrance of insects and rodents. To avoid restricting the outlet, maintain a minimum of 12 inches (30.5 cm) clearance between the vent hood and the ground or any other obstruction. The vent flap should be able to move freely. MAXIMUM EXHAUST
Inhaltszusammenfassung zur Seite Nr. 19
After installation is completed, the following method must be used to determine if the exhaust system is acceptable: 1. Connect an inclined or digital manometer between the dryer and the point the exhaust system connects to the dryer. 2. Set the dryer cycle and temperature to cool down, and start the dryer. 3. Read the measurement on the manometer. 4. The system back pressure must not be higher than 0.75 inches of water column. If the system back pressure is less than 0.75 inches of water
Inhaltszusammenfassung zur Seite Nr. 20
Location of Your Dryer Do Not Install Your Dryer: In an area exposed to dripping water or outside weather conditions. In an area where it will come in contact with curtains, thick carpet, or anything that will obstruct the flow of combustion and ventilation air. On carpet. Floor must be solid with a maximum slope of 1inch (2.54 cm). Installation in Recess or Closet: A dryer installed in a bedroom, bathroom, recess or closet, must be exhausted outdoors. Your dryer needs the space around it for p
