Inhaltszusammenfassung zur Seite Nr. 1
MODEL SF-140
Steam Mop
by Top Innovations
Please read all instructions before use.
Mail in your warranty registration card.
KEEP YOUR RECEIPT FOR WARRANTY PURPOSES.
Inhaltszusammenfassung zur Seite Nr. 2
Letter fmor the Ceo Dear Valued Customer, Congratulations on purchasing your new SF-140 Steam Mop. This product is designed to effectively replace the messy old mop and bucket as a simple, natural, and effective floor cleaning solution. Just add water and turn on your Steam Mop – in minutes you are ready to clean your hard surface floors, without the mess and hassle of conventional mopping. Use it on all types of hard floors – tile, marble, linoleum, sealed hardwood and more. High temperat
Inhaltszusammenfassung zur Seite Nr. 3
IMPORTANT SAFETY INSTRUCTIONS WARNING: To reduce risk of fire, electrical shock or injury, the following basic safety precautions should always be followed when using an electrical appliance. WARNING: To reduce risk of electrical shock, this appliance has a two- pronged electrical plug with one prong that is larger than the other. This plug will fit into a wall outlet only one way. If the plug does not fit fully in the outlet, contact a licensed electrician to install a proper outlet. DO
Inhaltszusammenfassung zur Seite Nr. 4
IMPORTANT SAFETY INSTRUCTIONS 10. If red Power Indicator Light does not illuminate when unit is plugged in and Foot-Controlled On/Off Switch is pressed, unit is not operating normally. Immediately disconnect cord from power supply, then refer to troubleshooting guide on Page 13 of this manual for assistance. 11. Turn unit off and unplug power cord before filling Boiler with water. 12. Do not use unit where aerosol-based products are being used, or where oxygen is being admin
Inhaltszusammenfassung zur Seite Nr. 5
Produ Ct Intormaf Ion The following features and accessories are included with your Steam Mop. Carefully inspect the packing material for all parts listed below. To obtain possible missing parts, refer to the Customer Support section on Page 14 of this manual. UNIT FEATURES & ACCESSORIES 1. Handle 2. Telescopic Pole 2A. Extension Lock 3. Cord Brackets 4. Foot-Controlled On/Off Switch 5. Power Indicator Light (Red) 6. Heating Indicator Light (Green) 7. Mop Head 8. Pad Grips 9. Steam Nozzle 10
Inhaltszusammenfassung zur Seite Nr. 6
Produ Ct Inftrmao Ion The Handle (1) connects to the top of the Telescopic Pole, and is designed for maximum grip and • user comfort. The Telescopic Pole (2) connects the Mop Head to the Handle, and can be extended and retracted • for comfortable use and quick storage. The Extension Lock (2A) is used to adjust the length of the Telescopic Pole. • The Cord Brackets (3) provide a convenient way to neatly wrap the power cord for storage. • The Foot-Controlled On/Off Switch (4), located
Inhaltszusammenfassung zur Seite Nr. 7
a ssemb LIng the Stema m op TELESCOPIC POLE 1. Connect Handle to thicker (upper) end of Telescopic Pole. To do this, simply slide Handle onto Pole until it snaps in place (FIGURE 1-A). NOTE: Once connected, the Handle cannot be removed from Telescopic Pole. 2. Insert thinner (lower) end of Telescopic Pole into bracket on top side of Mop Head. When inserting, make sure release button located on Pole faces towards back side of bracket as illustrated (FIGURE 1-B). Note small
Inhaltszusammenfassung zur Seite Nr. 8
a ssemb LIng the Stema m op MICROFIBER CLOTHS 1. Lay one Microfiber Cloth on flat surface, with two velcro strips facing upward. 2. Align Mop Head above Microfiber Cloth. Make sure Mop is oriented with Cloth as shown, and centered as best as possible (FIGURE 2-A). 3. Press Mop Head firmly down onto Microfiber Cloth. Velcro strips will adhere to Pad Grips on underside of Mop. Cloth should now be attached and ready for use (FIGURE 2-B). 4. To remove, use your foot to press down on Micr
Inhaltszusammenfassung zur Seite Nr. 9
u s Ing the Steam m op A FILLING WITH WATER 1. Make sure Foot-Controlled On/Off Switch is set to “Off” position (red Power Indicator Light will not be illuminated) and power cord is unplugged. If unit has been in use, allow a minimum of 5 minutes cooling time. 2. Carefully remove Boiler Cap by unscrewing it in a counter-clockwise direction (FIGURE 3-A). 3. Fill included Measuring Cup with 8.5 oz. (250 ml.) water, and pour into Boiler through Boiler Fill Hole (
Inhaltszusammenfassung zur Seite Nr. 10
u s Ing the Stmae m op OPERATING THE STEAM MOP Before operating, make sure Microfiber Cloth is properly attached (Page 8) and Boiler is filled with water (Page 9). 1. For first-time use, remove protective plastic cover that is shipped on electrical plug. Plug power cord into a convenient electrical outlet. 2. Place Resting Pad on floor, so that textured side faces upward. Rest Mop Head on top of Pad, in order to help protect floor surface from excess heat and moisture during heat-up p
Inhaltszusammenfassung zur Seite Nr. 11
u s Ing the Steam m op FLOOR SURFACES Below is a listing of some of the most common floor surfaces that the Steam Mop is ideal for cleaning. If you have a question about a floor surface that isn’t listed below, please contact our Customer Service Department: customerservice@topinnovations.com or (800) 711-6617 or (816) 584-9700, ext. 130 or 131. The Steam Mop is perfect for these hard floor surfaces: • Sealed Hardwood • Sealed Laminate • Linoleum • Ceramic • Granite • Marble • Slate • Tile IMP
Inhaltszusammenfassung zur Seite Nr. 12
Care & s torage g u Ide LInes PROPER STORAGE Preparing your Steam Mop for storage is quick and simple. When you have finished your mopping tasks, follow the steps listed below. 1. Gently press down on Foot-Controlled On/Off Switch until it clicks – Power Indicator Light will turn off. Unplug power cord from electrical outlet. 2. Allow unit to cool for 30 minutes. 3. Remove Microfiber Cloth from Mop Head. If Cloth is dirty you may wash it, either by hand or in a washing machine. All
Inhaltszusammenfassung zur Seite Nr. 13
t roub Lteshoo Ign g u Ide PROBLEM POSSIBLE CAUSE SOLUTION Unit fails to heat up. Red Power Unit is not plugged in. Plug power cord into electrical Indicator Light DOES NOT outlet. illuminate. Foot-Controlled On/Off Switch has Press down on Foot-Controlled On/ not been pressed. Off Switch until it clicks. Household circuit breaker / ground Reset circuit breaker / ground fault fault interrupter has tripped or interrupter, or replace fuse. If you blown a fuse. need assistance, contact a lice
Inhaltszusammenfassung zur Seite Nr. 14
Customer s u PPort / Produ Ct s Pe CIf ICat Ions CUSTOMER SUPPORT For problems with your Steam Mop, please refer to the troubleshooting guide located on Page 13 of this manual. Additional inquiries should be directed to our customer support services through our Web site, www.steamfast.com, on the Contact Us Web page. If you do not have internet access, you may also contact our Customer Service Department by telephone, at (800) 711-6617 or (816) 584-9700, ext. 130 or 131. NOTE: In order for
Inhaltszusammenfassung zur Seite Nr. 15
W arranty Itforman Ino Before returning any product for any reason, you MUST call or e-mail Top Innovations Warranty Service at (800) 711-6617 or customerservice@topinnovations.com to obtain a Return Authorization Number. 30-DAY MONEY BACK POLICY If any item purchased directly from Top Innovations does not meet your expectations, it may be returned within 30 days of the date of purchase for either a replacement or full refund of the purchase price less any shipping charges. In some circumst
Inhaltszusammenfassung zur Seite Nr. 16
Top Innovations 6655 Troost Ave. Kansas City, MO 64131 • TEL: (800) 711-6617 / (816) 584-9700 FAX: (816) 584-9066 www.steamfast.com customerservice@topinnovations.com PRINTED IN CHINA V090323
