Inhaltszusammenfassung zur Seite Nr. 1
Security & Convenience
6/96 CHANGE:
®
For DEI O5F Chip
Expansions
Here we have listed only some of the many expansion options available.
Please consult your dealer for a complete explanation of all the options
available to you.
Field Disturbance Sensor: An invisible dome of coverage is established by
the 508T “radar” sensor. Your system can react to any intrusions into this field
with the triggered sequence. Model 1000
Backup Battery: The 520T keeps the system armed, triggers the alarm and
keep
Inhaltszusammenfassung zur Seite Nr. 2
Glossary of Terms Control Unit The “brain” of your system. Usually hidden underneath the dash area of the vehicle. It houses the microprocessor which monitors your vehicle and controls all of the alarm's functions. ® FailSafe Starter Kill An automatic switch controlled by the security system which prevents the vehicle’s starter from cranking whenever the system is armed. The vehicle is never prevented from cranking when the system is disarmed, in valet mode, or should the starter kill switch
Inhaltszusammenfassung zur Seite Nr. 3
change to a continuous blast. Table of Contents TM System Maintenance ...................................2 Nuisance Prevention Circuitry .................... 8 From this point on, when the ignition key is turned off, the Your Warranty ...............................................2 Diagnostics ................................................... 8 ® ® VRS will immediately turn on the FailSafe starter kill. This will prevent the vehicle from being restarted, thus immobilizing it at that What Is
Inhaltszusammenfassung zur Seite Nr. 4
Transmitter Channels The optional Vehicle Recovery System is armed and disarmed using a hidden push button switch. If the system has been installed, make sure you ® LED are aware of the location of the VRS button. Channel I Channel II ® Arming the VRS ® To arm the VRS , push the button once. This can be done before driving or while driving the vehicle. Once the system is armed, it will go into its Channel III triggered sequence (see below) if any door is opened and closed. If you are forced fr
Inhaltszusammenfassung zur Seite Nr. 5
"sees" you leave the vehicle by opening and closing a door. Whenever the system is in its 30-second passive arming countdown, the Status LED will flash twice as fast as it does when the system is armed. NOTE: If any protected entry point (such as a door or a switch-protected trunk or hood) is open, the system will not passively arm (unless forced passive arming is programmed on. See Programming Options section). Additionally, Vehicle Recovery each time a sensor is triggered during the arming cou
Inhaltszusammenfassung zur Seite Nr. 6
the key is turned off. Note: If the door is open when the ignition is turned High Security Disarm on, the doors will not lock. Your system includes a High Security Disarm feature. During the trigger Panic mode enabled/disabled with the ignition on. (Some states have laws • sequence, using the transmitter to disarm the system will only stop the trigger against siren capability in a moving vehicle). sequence (the siren will stop and the parking lights will stop flashing). How- ever, the system wi
Inhaltszusammenfassung zur Seite Nr. 7
Panic Mode ™ Code Hopping If you are threatened in or near your vehicle, you can attract attention by triggering the system with your transmitter! Just press button I for 1.5 seconds, EXPLAINED and you will enter Panic Mode. The siren will sound and the parking lights will flash for 30 seconds. To stop Panic Mode at any time, press button I on the transmitter again. The receiver and transmitters each use a mathematical formula called an algorithm to change their code each time the transmitter is
Inhaltszusammenfassung zur Seite Nr. 8
TM The system will ignore the input that was active when it was armed until it Nuisance Prevention Circuitry goes away. Three seconds later it will monitor that input normally. For ex- Your system has DEI's Nuisance Prevention Circuitry™ (NPC™). It prevents ample, if your car has interior light exit delay, and you arm the system before annoying repetitive trigger sequences due to faulty door pin switches or the interior light goes out, you may get Bypass Notification. Three seconds environmental
