Inhaltszusammenfassung zur Seite Nr. 1
TM
Owner’s Manual
read and understand this entire manual before riding!
DO nOT reTurn TO sTOre!
nOTe: Manual illustrations are for demonstration purposes only.
Illustrations may not reflect exact appearance of actual product.
specifications subject to change without notice.
Item Number:
Version 1_01/10
Blue 15120040
Inhaltszusammenfassung zur Seite Nr. 2
cOnTenTs Safety Warnings .................................................................................1 Troubleshooting Guide .................................................................... 7-8 Before You Begin .................................................................................2 Pocket Rocket Parts ....................................................................... 9-10 Assembly and Set-Up ...................................................................... 3-4 Saf
Inhaltszusammenfassung zur Seite Nr. 3
BefOre yOu BegIn Remove contents from box. Remove the foam separators that protect the components from damage during shipping. Inspect the contents of the box for scratches in the paint, dents or kinked cables that may have warnIng: occurred during shipping. Because the Pocket Rocket is 95 percent assembled and packed at the factory, Do not use your Pocket Rocket there should not be any problems, even if the box has a few scars or dents. for the first time until you have charged the b
Inhaltszusammenfassung zur Seite Nr. 4
asseMBly anD seT -up q attaching the Handlebars warnIng: Failure to properly tighten both sides may cause the handlebars to dislodge while riding and may cause you to lose control and fall. When correctly tightened, the handlebars will not rotate out of alignment under normal circumstances. 1 Swing the handlebars 2 Using a 6mm hex key wrench, outward as shown. You may tighten both the left have to loosen the clamps and right side handlebar clamps to allow the bar to pivot on by
Inhaltszusammenfassung zur Seite Nr. 5
asseMBly anD seT -up q charging the Battery warnIng: Your electric motor bike may not have a fully charged battery; therefore it is a good idea to charge the Always disconnect your electric battery prior to use. motor bike from the charger • Initial charge time: 18 hours • Run time: Up to 40 minutes of continuous ride time before cleaning with liquid. • Recharge time: up to 12 hours, • A verage battery life: 250 charge/discharge cycles depending on the level of depletion
Inhaltszusammenfassung zur Seite Nr. 6
repaIr anD MaInTenance q chain and rear Tire replacement Tools required: 10mm wrench, two (2) 8mm wrenches, and two (2) 17mm wrenches. 2 With a 10mm wrench, 1 Loosen screws and remove 3 With two 8mm wrenches, 4 Loosen and remove both axle chain guard. loosen the brake cable anchor loosen brake housing anchor adjuster nuts. and disconnect the cable. and disconnect. Keep the spacer and washers together. 5 With two 17mm wrenches, 7 Install the new chain or 6 Pull the wheel out. Note th
Inhaltszusammenfassung zur Seite Nr. 7
repaIr anD MaInTenance q chain and sprocket warnIng: The chain will typically have a “loose spot” and “tight spot” corresponding with a particular sprocket To avoid a pinch or injury, keep rotational position. This is normal and common to all chain-driven products due to run-out tolerances of the fingers away from moving freewheel and sprocket. The chain should be adjusted to the ideal tension with chain in the tightest spot. sprockets and chain. Proper chain alignment must be main
Inhaltszusammenfassung zur Seite Nr. 8
TrOuBlesHOOTIng guIDe problem possible cause solution Motor bike does not run Undercharged battery Charge the battery. A new battery should have been charged for at least 18 hours before using the motor bike for the first time and up to 12 hours after each subsequent use. Check all connectors. Make sure the charger connector is tightly plugged into the charging port, and that the charger is plugged into the wall. Make sure power flow to the wall outlet is on. Charger is not working You may
Inhaltszusammenfassung zur Seite Nr. 9
TrOuBlesHOOTIng guIDe problem possible cause solution Loose wires or connectors Check all wires around the motors and all connectors to make sure Sometimes the motor they are tight. bike doesn’t run, but other times it does Motor or electrical switch damage Contact your local Razor authorized service center for diagnosis and repair. Brake is not adjusted properly Refer to instructions on page 4 of this manual to properly adjust Motor bike does not brake. stop when applying the bra
Inhaltszusammenfassung zur Seite Nr. 10
pOckeT rOckeT p ar Ts Keep your Pocket Rocket running for years with genuine Razor parts. Visit our web site or e-mail us for more information on spare part availability. (Specifications subject to change without notice.) 1. Handlebar Grip (Right/Left) 11. Motor (24V 250W) 1-1. Handlebar End Cap/Extender Holder 12. Kickstand 1-2. Valve Stem Extender/Inflator 13. Control Module 2. Single Speed Twist Grip Throttle 14. Battery Cover (Right/Left) 2-1. Sleeve 15. Charger Por
Inhaltszusammenfassung zur Seite Nr. 11
pOckeT rOckeT p ar Ts 10
Inhaltszusammenfassung zur Seite Nr. 12
SB 1918 (CALIFORNIA) DECLARATION YOUR INSURANCE POLICIES MAY NOT PROVIDE COVERAGE FOR ACCIDENTS INVOLVING THE USE OF THIS SCOOTER/ELECTRIC RIDE-ON PRODUCT. TO DETERMINE IF COVERAGE IS PROVIDED, YOU SHOULD CONTACT YOUR INSURANCE COMPANY OR AGENT. 11
Inhaltszusammenfassung zur Seite Nr. 13
safeTy reMInDers pre-rIDe cHecklIsT loose parts Tire Inflation There should not be any unusual rattles or sounds from Periodically inspect the tires for excess wear and replace as q q loose parts or broken components. If you are not sure, ask required, and regularly check the tire pressure and re-inflate an experienced mechanic to check. as necessary. If you get a flat tire, the inner tube can be patched or a new tube can be purchased from Razor or an authorized repair center. Brake Check
