Inhaltszusammenfassung zur Seite Nr. 1
2 0 1 0
300
O W N E R ’ S M A N U A L S R T
Inhaltszusammenfassung zur Seite Nr. 2
TABLE OF CONTENTS SECTION PAGE 1 INTRODUCTION ............................................................3 1 2 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE ..............................9 2 3 UNDERSTANDING THE FEATURES OF YOUR VEHICLE ............................. 85 3 4 UNDERSTANDING YOUR INSTRUMENT PANEL .................................. 183 4 5 STARTING AND OPERATING ................................................ 271 5 6 WHAT TO DO IN EMERGENCIES ...........................................
Inhaltszusammenfassung zur Seite Nr. 3
Inhaltszusammenfassung zur Seite Nr. 4
INTRODUCTION 1 CONTENTS Introduction ........................... 4 Vehicle Identification Number .............. 6 How To Use This Manual .................. 4 Vehicle Modifications/Alterations ............ 7 Warnings And Cautions ................... 6
Inhaltszusammenfassung zur Seite Nr. 5
4 INTRODUCTION INTRODUCTION When it comes to service, remember that your authorized Congratulations on selecting your new Chrysler Group dealer knows your vehicle best, has factory-trained tech- LLC vehicle. Be assured that it represents precision nicians and genuine MOPAR parts, and cares about workmanship, distinctive styling, and high quality - all your satisfaction. essentials that are traditional to our vehicles. HOW TO USE THIS MANUAL This Owner’s Manual has been prepared with the assis-
Inhaltszusammenfassung zur Seite Nr. 6
INTRODUCTION 5 1
Inhaltszusammenfassung zur Seite Nr. 7
6 INTRODUCTION WARNINGS AND CAUTIONS This Owner’s Manual contains WARNINGS against op- erating procedures that could result in an accident or bodily injury. It also contains CAUTIONS against proce- dures that could result in damage to your vehicle. If you do not read this entire manual, you may miss important information. Observe all Warnings and Cautions. VEHICLE IDENTIFICATION NUMBER The Vehicle Identification Number (VIN) is on the left front corner of the instrument panel. The VIN is visible
Inhaltszusammenfassung zur Seite Nr. 8
INTRODUCTION 7 VEHICLE MODIFICATIONS/ALTERATIONS 1 WARNING! Any modifications or alterations to this vehicle could seriously affect its roadworthiness and safety and may lead to an accident resulting in serious injury or death.
Inhaltszusammenfassung zur Seite Nr. 9
Inhaltszusammenfassung zur Seite Nr. 10
THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 2 CONTENTS A Word About Your Keys ................. 12 Vehicle Security Alarm — If Equipped ........ 17 ▫ Wireless Ignition Node (WIN) ............ 12 ▫ Rearming Of The System ................ 17 ▫Key FOB ........................... 13 ▫ To Arm The System ................... 17 ▫ Removing Key FOB From Ignition ......... 14 ▫ To Disarm The System ................. 18 ▫ Key-In-Ignition Reminder ............... 15 Illuminated Entry — If Equipped ...
Inhaltszusammenfassung zur Seite Nr. 11
10 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE ▫ Using The Panic Alarm ................. 22 ▫ Wind Buffeting ....................... 40 ▫ Programming Additional Transmitters ...... 23 Trunk Lock And Release ................. 40 ▫ Transmitter Battery Replacement .......... 23 Trunk Safety Warning ................... 41 ▫ General Information ................... 24 ▫ Trunk Emergency Release ............... 42 Remote Starting System — If Equipped ....... 24 Occupant Restraints ..............
Inhaltszusammenfassung zur Seite Nr. 12
THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 11 ▫ Supplemental Restraint System (SRS) — ▫ Transporting Passengers ................ 79 Airbags ............................ 53 ▫ Exhaust Gas ......................... 80 ▫ Airbag Deployment Sensors And Controls . . . 60 ▫ Safety Checks You Should Make Inside The 2 ▫ Event Data Recorder (EDR) .............. 67 Vehicle ............................. 81 ▫ Child Restraints ...................... 69 ▫ Periodic Safety Checks You Should Make Outside The Vehi
Inhaltszusammenfassung zur Seite Nr. 13
12 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE A WORD ABOUT YOUR KEYS NOTE: With Keyless Go, the Electronic Vehicle Infor- Your vehicle uses a keyless ignition system. This system mation Center (EVIC) will display the ignition switch consists of a Key Fob with Remote Keyless Entry (RKE) position (OFF/ACC/RUN). Refer to “Electronic Vehicle transmitter and a Wireless Ignition Node (WIN) with Information Center (EVIC)” in “Understanding Your integral ignition switch. You can insert the Key Fob into
Inhaltszusammenfassung zur Seite Nr. 14
THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 13 Key Fob To remove the emergency key, slide the mechanical latch The Key Fob operates the ignition switch. It also contains at the top of the Key Fob sideways with your thumb and the Remote Keyless Entry (RKE) transmitter and an then pull the key out with your other hand. emergency key, which stores in the rear of the Key Fob. 2 NOTE: If your vehicle is equipped with Passive Entry/ Keyless Go (PEKG), the Key Fob will also contain a special receiver t
Inhaltszusammenfassung zur Seite Nr. 15
14 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE Removing Key Fob From Ignition and power outlets will remain active for up to 60 min- Place the shift lever in PARK. Turn the Key Fob to the utes after the ignition switch is placed in the OFF OFF position and then remove the Key Fob. position. Opening either front door will cancel this feature. The time for this feature is programmable. With the Passive Entry/Keyless Go system, the EVIC will Refer to “Electronic Vehicle Information Center display t
Inhaltszusammenfassung zur Seite Nr. 16
THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 15 SENTRY KEY CAUTION! The Sentry Key Immobilizer System prevents unautho- An unlocked car is an invitation to thieves. Always rized vehicle operation by disabling the engine. The remove the Key Fob from the ignition and lock all system does not need to be armed or activated. Operation 2 doors when leaving the vehicle unattended. is automatic, regardless of whether the vehicle is locked or unlocked. Key-In-Ignition Reminder The system uses Key Fob wi
Inhaltszusammenfassung zur Seite Nr. 17
16 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE If the Vehicle Security Light turns on during normal CAUTION! vehicle operation (vehicle running for longer than 10 sec- onds), it indicates that there is a fault in the electronics. • Always remove the Key Fobs from the vehicle and Should this occur, have the vehicle serviced as soon as lock all doors when leaving the vehicle unat- possible by an authorized dealer. tended. • For vehicles equipped with Keyless Go, always NOTE: The Sentry Key Immobi
Inhaltszusammenfassung zur Seite Nr. 18
THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 17 Customer Key Programming the following audible and visible signals: the horn will Programming Key Fobs or RKE transmitters may be pulse, the headlights, park lamps and/or turn signals performed at an authorized dealer. will flash, and the Vehicle Security Light in the instru- ment cluster will flash. 2 General Information The Sentry Key system complies with FCC rules Part 15 Rearming of the System and with RSS-210 of Industry Canada. Operation is I
Inhaltszusammenfassung zur Seite Nr. 19
18 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE time, the Vehicle Security Light will flash. If it does not To Disarm the System illuminate, the Vehicle Security Alarm is not arming. In Vehicles Not Equipped with Keyless Go addition, if you open a door during the arming period, Either press the UNLOCK button on the RKE transmitter the Vehicle Security Alarm will cancel the arming pro- or insert a valid ignition key into the ignition switch and cess. If you wish to rearm the Vehicle Security Alarm
Inhaltszusammenfassung zur Seite Nr. 20
THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 19 The Vehicle Security Alarm is designed to protect your further information), press the Keyless Go Start/Stop vehicle; however, you can create conditions where the button (requires at least one valid Key Fob in the vehicle), Vehicle Security Alarm will give you a false alarm. If one or insert a valid Key Fob into the ignition switch (if the of the previously-described arming sequences has oc- Start/Stop button is removed) and rotate it to the RUN 2 c
