Inhaltszusammenfassung zur Seite Nr. 1
KF-FT
Functional t rainer
Owner’s Manual
215-00216
03/07 Rev A
Inhaltszusammenfassung zur Seite Nr. 2
Table Of Contents Before You Start 3 Important Safety Information 4 Assembly 5-11 Weight Stack Sticker Placement 1 Parts List 13 Exploded View 14 Warranty Information 15
Inhaltszusammenfassung zur Seite Nr. 3
Before You Start THANK YOU for making this unit a part of your exercise program. Keys Fitness assures the very best in value, appearance, durability and biomechanics. This manual will guide you through the assembly process. If at any time you are having trouble with the assembly or use of this product, then please contact us at our Keys Fitness Help line. We have trained service technicians on site to take care of you, our valued customer. REGISTRATION CARd To avoid unnecessary delays in
Inhaltszusammenfassung zur Seite Nr. 4
Important Safety Information Prior to assembly, remove components from the box and verify that all the listed parts were supplied. Read all precautions and instructions in this manual before using this equipment. WARNING! Before using this unit or starting any exercise program, consult your physician. This is especially important for persons over the age of 35 and/or persons with pre-existing health problems. Keys Fitness Products LP assumes no responsibility for personal injury or pr
Inhaltszusammenfassung zur Seite Nr. 5
Assembly NOTE: Hand tighten bolts and nylon nuts until machine is fully assembled. Connect Left Frame (1) and Right Frame () with the two Rear STEP 1 Beams (4) using Bolts M10X80 (55), Washers M10 (60), and Nylon Nuts M10 (64). 5
Inhaltszusammenfassung zur Seite Nr. 6
Assembly NOTE: Hand tighten bolts and nylon nuts until machine is fully assembled. Attach Main Beam (3) to Left and Right Frames (1 & ) using Bolts STEP 2 M10X105 (5), Washers M10 (60), and Nylon Nuts M10 (64). 6
Inhaltszusammenfassung zur Seite Nr. 7
Assembly NOTE: Hand tighten bolts and nylon nuts until machine is fully assembled. Slide the Guide Rods (19) into the holes located on the Left and Right STEP 3 Frames (1 & ). Now apply the Lithium Grease included with your bolt pack onto the Guide Rods (19). Next, slide a Weight Bumper (37) onto each Guide Rod (19). Slide the Weight Plates according to the appropriate configuration as shown on Page 1. Last, slide the Top Plate (34) onto the guide rods. Note: Be sure the weight pin hol
Inhaltszusammenfassung zur Seite Nr. 8
Assembly NOTE: Hand tighten bolts and nylon nuts until machine is fully assembled. Slide Left Frame Slip (5) onto Left Slip Tube (13). STEP 4 Install Left Slip Tube (13) into the Left Frame (1). Note: Make sure the numbers on the slip tube face to the front of the unit. Secure the assembly using Bolt M10X80 (55), Washers M10 (60), Nylon Nut M10 (64) on the bottom and Bolt M10X95 (54), Washers M10 (60), Nylon Nut M10 (64) on the top connection. Repeat this step to complete the right side. 8
Inhaltszusammenfassung zur Seite Nr. 9
Assembly End Start 5 Start by threading one end of the Pulley Cable (8) into Left Slip STEP 5 Frame (5). Remove hardware and ball from the other end of the cable. Follow the diagram above to complete the cable installation. Note: When installing the cable, make sure the cable is centered on the pulley and is not rubbing against any part of the frame or any hardware. Repeat this step to complete the right side. 9
Inhaltszusammenfassung zur Seite Nr. 10
Assembly NOTE: Hand tighten bolts and nylon nuts until machine is fully assembled. Slide Weight Shrouds (11) in between the Frame and the Weight STEP 6 Stack as shown above. Loosely attach Shroud Brackets (1) onto the Weight Shrouds (11) and Left Frame (1) using Bolts M8X15 (58), Bolt M10X100 (53), Spring Washers M8 (63), Washers 9X16X1.6 (6), Washers M10 (60), and Nylon Nut M10 (64). Repeat this step to complete the right side. 10 10
Inhaltszusammenfassung zur Seite Nr. 11
Assembly Tighten all hardware securely. Congratulations! You have completed the assembly of your new KF-FT 11 11
Inhaltszusammenfassung zur Seite Nr. 12
Weight Stack Sticker Placement Your new unit can be purchased with either a 00 LB or 50 LB weight stack. Depending on which weight stack you have purchased will determine which weight stack sticker numbers will be used. The weight stack images below show which weight stack sticker numbers are to be used on your weight stack. Please note that these stickers should not be put on until the entire unit has been assembled and all bolts and nuts have been tight- ened. 200 LB Stack 250 LB S
Inhaltszusammenfassung zur Seite Nr. 13
Parts list KF-FT Parts list Rev A Ref # Part # description Qty 1 3-0107 FRAME , LEFT KF-FT 1 3-0106 FRAME , RIGHT KF-FT 1 3 3-010 BEAM , MAIN TOP KF-FT 4 3-0103 BEAM , REAR KF-FT 5 3-0104 FRAME , SLIP LEFT KF-FT 1 6 3-0105 FRAME , SLIP RIGHT KF-FT 1 7 0-00770 SPACER , PULLEY LONGER KF-FT 8 8 9-00117 CABLE , PULLEY KF-FT 9 06-00503 GRIP , HANDLE TOP KF-FT 10 06-00504 GRIP , HANDLE SLIP KF-FT 11 3-0101 SHROUD , WEIGHT KF-FT 4 1 10-0068 BRACKET , SHROUD 8
Inhaltszusammenfassung zur Seite Nr. 14
Exploded View 14 32 32 8 57 57 55 57 8 55 57 60 32 60 60 32 61 60 16 61 52 16 61 60 16 32 32 7 60 7 64 60 60 43 7 33 52 61 44 53 60 7 4 65 60 60 43 33 55 55 44 60 64 60 16 19 19 19 19 64 60 54 57 60 65 53 30 53 60 7 3 60 57 64 60 60 64 60 54 9 9 23 53 57 7 30 64 47 56 56 57 60 60 1 22 2 35 34 25 60 13 32 47 14 36 35 60 32 34 4 64 60 38 56 60 36 56 60 63 64 63 62 62 64 58 58 62 58 38 63 63 63 58 60 63 58 58 33 12 37 58 62 63 58 12 33 37 51 62 42 37 42 51 59 42 42 53 12 60 62 53 59 32 53 37 62 32
Inhaltszusammenfassung zur Seite Nr. 15
Warranty Information KEYS FITNESS PROdUCTS, l.P. lIFETIME WARRANTY This Warranty applies in the United States and Canada to products manufactured or distrib- uted by Keys Fitness Products, LP (“Keys”) under the KEYS brand name. The warranty is non- transferable and valid only to the original purchaser. Keys warrants that the Product you have purchased for non-commercial, personal, family, or household use from Keys or from an authorized Keys reseller is free from defects in materi- als or workm
Inhaltszusammenfassung zur Seite Nr. 16
Keys Fitness Products, l.P. 4009 distribution drive, Suite 250 Garland, Texas 75041 Customer Service: 1-888-340-0482
