Bedienungsanleitung Siren Players SFGH-100

Inhaltszusammenfassung zur Seite Nr. 1

SFGH-100 SIREN & FLASHING LIGHT SYSTEM
Installation & Operation
The SFGH-100 is a precision built, full function 100 watt siren system that incorporates both an alternating
headlight and grille light flasher in the same unit. The SFGH-100 draws no current unless a function is
selected, so there is no battery drain. The Amplifier/Flasher unit mounts in the trunk. Quick connection
allows the remotely controlled siren, public address system, air horn, and flashers to be installed easily
a

Inhaltszusammenfassung zur Seite Nr. 2

E. Butt connect the battery cable wires to the red and red/black wires on the power cable. Route cable to the battery and connect to the positive (+) terminal, or an auxiliary terminal block as provided some vehicles. F. WHITE WIRE (Ignition Sense) is routed to the fuse block or other ignition source. This wire must see +12 volts when the key is turned on or the SFGH-100 will not operate. CAUTION: The battery cable connector and ignition sense lead are both fused for the SFGH-100’s pr

Inhaltszusammenfassung zur Seite Nr. 3

HDLPS & ALT LTS In the ALT LTS. (Down) position the grille or other lights are flashing. In the HDLPS & ALT LTS (Up) position the headlights are also flashing. When the flasher is in the ALT. LTS. or OFF position the Headlights will function normally. When the Headlights are flashing, using the bright lights will override the flashers operation. An indicator above the switch shows when either flasher is on. RADIO Provides radio rebroadcast through the SFGH-100 siren speaker. Rebroadcast vol

Inhaltszusammenfassung zur Seite Nr. 4

4

Inhaltszusammenfassung zur Seite Nr. 5

5