Bedienungsanleitung Emerson 203-5751

Inhaltszusammenfassung zur Seite Nr. 1

Wal Wall l- -M Mo ou un nt ted ed RH Se RH Sen ns so or r an and d RH/ RH/Temp Tempe er ra at tu ur re Se e Sen ns so or r
203-5751
Pro Produ duc ct t I In nfo for rmat mati io on n S She hee et t
Overview Mounting
CPC specs a wall-mounted relative humidity (RH) 1. Insert a screwdriver into the gap in the plastic
sensor (P/N 203-5751) and/or RH and temperature on the bottom side of the sensor enclosure,
sensor (P/N 203-5752) for use in building control and and pry the fro

Inhaltszusammenfassung zur Seite Nr. 2

Wall-Mounted RH Sensor and RH/Temperature Sensor 203-5751 Product Information Sheet RH Sensor Wiring RH/Temp Sensor Wiring 1. Use Belden #8771 shielded three-conductor RH wiring is the same as the RH wiring shown in cable or equivalent. the diagram(Figure 2). For temp sensor wiring, follow the steps below: NOTE: Seat the connector on the back plate if it 1. Use Belden #8761 shielded two-conductor becomes dislodged. cable or equivalent. 2. Connect the RED, BLACK, and W

Inhaltszusammenfassung zur Seite Nr. 3

Wall-Mounted RH Sensor and RH/Temperature Sensor 203-5751 Product Information Sheet Figure 3 – Sensor and Input Board Wiring Finishing the Installation Once the back plate of the sensor is mounted and the sensor and board wiring is complete: 1. Attach the sensor circuit board enclosure to the mounting plate. Push the top of the front part onto the mounting plate so the hooked mounting tabs fit underneath the circuit board enclosure, and push the bott