Inhaltszusammenfassung zur Seite Nr. 1
EU155N Series - 230V 50Hz
Ice and Water Dispensers
Installation, Operation and Service Manual
Automatic load units
with one icemaker
Automatic load units
with two icemakers
Following installation, please forward this manual
to the appropriate operations person.
801 Church Lane • PO Box D, Easton, PA 18044
®
00120303R00
Cool Ideas For Ice Management (610) 252-7301 • FAX (610) 250-0696 • www.follettice.com
Inhaltszusammenfassung zur Seite Nr. 2
Inhaltszusammenfassung zur Seite Nr. 3
Table of contents Welcome to Follett. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Before you begin. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3 Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Electrical requirements. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Plumbing and clearance requirements. . . .. . . .. . . . . . . . . . . . .
Inhaltszusammenfassung zur Seite Nr. 4
Welcome to Follett Follett ice and water dispensers enjoy a well-deserved reputation for excellent performance, long-term reliability and outstanding after-the-sale support. To ensure that this dispenser delivers that same degree of service, we ask that you take a moment to review this manual before beginning the installation of the dispenser. Should you have any questions or require technical help at any point, please call our technical service group at (610) 252-7301. Before you begin • After
Inhaltszusammenfassung zur Seite Nr. 5
Plumbing Dispenser 3/4" PVC slip joint for hopper drain 3/4" PVC pipe nipple for beverage drain pan 3/8 ID red line tubing for water in Note: Drains should be hard piped and insulated. Maintain at least 6mm per 304mm run slope on drain line run Icemaker Refer to Icemaker Installation Manual packed with icemaker for installation instructions Clearance and access information • 1296mm above counter • 305mm on side opposite tower, below counter • Counter front or rear panel must be removable for se
Inhaltszusammenfassung zur Seite Nr. 6
Field wiring: Model Circuits required EU155N 230V 50Hz, (1) circuit required Field wiring diagrams Automatic load units IMPORTANT Field wiring diagram is intended to aid electrician or technician in understanding how equipment works. Electric supply 230V 50Hz Electric supply 230V 50Hz EU155N ER400A/W Dispenser ice machine GND L2 L1 Junction box GND Electric supply 230V 50Hz L2 optional second ER400A/W L1 GND Junction box L2 L1 Connections to complete Junction box 5
Inhaltszusammenfassung zur Seite Nr. 7
Installation Installing EU155N dispenser in counter All EU155N dispensers must be installed level in both directions and supported from below with 153 – 229mm adjustable legs provided, or channels installed on site. DO ! NOT hang dispenser on flange of counter. 1. Check that dispenser location meets all requirements in this manual and cut counter as shown. 2. Block up area below counter cut-out to support dispenser when lowered into place. 3. For automatic load dispensers, disconnect ice transp
Inhaltszusammenfassung zur Seite Nr. 8
Installing remote icemaker (automatic load units only) Correct installation of remote icemaker(s) is critical to proper performance of ! icemaker and dispenser. Check to make sure bin signal on icemaker control board is switched to 24 volt connection. Refer to installation manual packed with icemaker for important details on ice transport tube run, ventilation requirements and other installation requirements. Failure to comply with instructions will void warranty. 1. Position icemaker in desire
Inhaltszusammenfassung zur Seite Nr. 9
To start up and operate dispenser 1. Follow detailed cleaning instructions in service manual before operating dispenser. 2. For manual load units, remove front drain pan or rear lid and fill storage area with compatible ice. Follett manual load dispensers can accommodate most cube/cubelet ices up to 26mm square and Follett compressed nugget ice. Crushed, flake, nugget, bagged or ! congealed ice cannot be used. Use of these ices can jam dispenser and void warranty. Separate any “waffle-like” sect
Inhaltszusammenfassung zur Seite Nr. 10
Cleaning bin before use 1. Wipe storage area with Solution A. 2. Rinse thoroughly with clear, potable water. 3. Wipe with Solution B to sanitize. Periodic cleaning of dispenser Recommended daily cleaning of drain pan DO NOT run plastic parts (drain pan, dispense chute cover, dispense wheel) ! through a dishwasher. 1. Remove all debris from drain pan. 2. Pour 1 gallon (4L) hot water into drain pan to keep drain lines clear. Recommended weekly cleaning 1. Remove drain pan and grill and wash with S
Inhaltszusammenfassung zur Seite Nr. 11
Disassembly instructions for periodic cleaning Fig. 1 Dispense chute cover removal Front view 1. Remove top cover. right-hand unit 2. Push chute cover up vertically to slip off holding tab. 3. After clearing tab, pull chute cover forward top cover chute to remove. cover Dispense mechanism assembly drain pan removal assembly 1. Remove top cover. dispense 2. Remove chute cover (see above). chute 3. Remove auger motor assembly (see above). 4. Remove quick release pins from the ice chutes and gat
Inhaltszusammenfassung zur Seite Nr. 12
2 Fig. 3 side view front view auger dispense wheel auger tube auger motor (side view) stationary agitator rotating agitator wheel motor auger bearing plate baffle plate wheel motor mounting plate Service Disassembly instructions for service requirements only – NOT required for any cleaning procedure Dispense wheel motor removal (Fig. 3) 1. Remove drain pan, bin access cover and dispense wheel. 2. Remove stainless steel baffle plate under dispense wheel. 3. Remove two screws holding wheel motor b
Inhaltszusammenfassung zur Seite Nr. 13
Wiring diagrams WATER SWITCH WATER SOLENOID L2 C NO Blk Wht Orn L1 AUGER MOTOR COUNTERCLOCKWISE ROTATION INterlock RELAY DISPENSE RELAY R3 R1 BLK Orn Pur Red Red Blk Wht Pur M1 4 7 47 PL2-1 PL2-2 POWER PL2-3 Blu Blu WHEEL COUNTERCLOCKWISE ROTATION AUTOFILL R2 Pur Red Red Blk Wht M2 1 7 PL3-2 PL3-3 AUTOFILL R2 Orn Blu Blu 6 PL3-1 Blk Wht 220 Volts T1 Red Yel 24 Volts DISPENSE SWITCH DISPENSE RELAY Red Yel Brn R1 EU155N C NO B A Right hand interlock relay white white white Yel dispenser R3 C NO C
Inhaltszusammenfassung zur Seite Nr. 14
Before calling for service 1. Check that there is ice in dispenser and that congealed cubes are not causing a jam. 2. Check that circuit breaker and switches are in “ON” position. 3. Check that drain pan, rear lid and top are on securely. If ajar, dispenser will not operate. When the top is off, auger does not operate, even though the solenoids do. 4. Check that all drains are clear. Note: For units equipped with Follett compressed nugget icemaker, see Icemaker Operation and Service Manual for s
Inhaltszusammenfassung zur Seite Nr. 15
Replacement parts Dispenser exterior Front view Top view right hand (RH) tower unit with right hand (RH) tower (push button dispensing) 8 6 7 17 9 10 2 12 5 14 11 1 13 3 3 15 17 4 4 16 Reference # Description Part # 1 Label, “Follett” 502438 2 Top cover (includes label and magnet) 502905 3 Drain pan (includes magnet) 502903 4 Grille, drain pan 502450 5 Cover, electrical components 502902 6 Lid, rear access (includes magnet) 502904 Not shown Cover, ice storage (under drain pan) 502453 7 Label, ic
Inhaltszusammenfassung zur Seite Nr. 16
Dispense assembly – side view Dispense assembly side view 5 (RH unit shown) 9 3 top view 1 9 6 7 2 11 4 8 10 Reference # Description Part # 1 Gate, dispense 502455 2 Linkage pin, gate/solenoid 502456 3 Pin, quick release, 141mm, dispense gate 502102 4 Solenoid (includes linkage pin) 00120295 5 Dispense mechanism assembly, right hand unit 502458 Not shown Dispense mechanism assembly, left hand unit 502496 6 Spring, dispense mechanism (1 per side) 501950 7 Chute, ice 502457 8 Wrap, dispense mechan
Inhaltszusammenfassung zur Seite Nr. 17
2 Hopper – side view 5 1 7 9 3 8 11 2 6 10 4 left-hand unit shown Reference # Description Part # 1 Auger, LH unit (black, stamped with “1”) 502491 Not shown Auger, RH unit (gray, stamped with “2”) 502492 2 Plate, auger bearing 501696 Not shown Tube, auger, right hand unit 502487 Not shown Tube, auger, left hand unit 502488 3 Wheel, dispense (includes stud and rotating agitator) 501681 4 Baffle (under dispense wheel) 501684 Not shown Drive bar (under dispense wheel) 501682 5Motor, vertical auger
Inhaltszusammenfassung zur Seite Nr. 18
Auger motor side view top view 7 6 3 10 4 6 5 9 1 8 2 11 Reference # Description Part # Auger motor/drive assembly, vertical (includes all items below) 502893 1 Motor, vertical auger (includes gearbox and capacitor) 502889 2 Chain, auger drive #35, 40p 502477 3 Sprocket 35#, 22T 5/8 bore 502478 4 Sprocket 35#, 12T 5/8 bore 502479 5 Drive shaft 502480 6 Bearing, auger, upper and lower 501314 7 Cover and bearing, chain drive (includes 501314) 502912 8 Capacitor, 25mf, 270V 502892 9 Key, Woodruff 5
Inhaltszusammenfassung zur Seite Nr. 19
Electrical components 14 6 11 8 13 1 9 9 15 10 5 11 7 4 3 7 6 15 2 Reference # Description Part # 1 Transformer, 24V 502885 2 Relay, dispense 501826 3 Relay, auto fill 501826 4 Timer, auto fill (automatic fill units) 502471 5Strip, terminal 502472 6 Tube, water dispense, stainless steel 502356 7 Bracket, water solenoid 502611 8 Fitting, outlet, 1/8 MPT x 3/8, compression 502562 9 Valve, solenoid, water 208103 10 Fitting, inlet, plastic, 1/4 barb 502637 11 Tubing, water (sold by the foot) 502356
Inhaltszusammenfassung zur Seite Nr. 20
801 Church Lane • PO Box D, Easton, PA 18044 00120303R00 ® Cool Ideas For Ice Management (610) 252-7301 • FAX (610) 250-0696 • www.follettice.com 10/03
