Inhaltszusammenfassung zur Seite Nr. 1
Operating and Installation
Instructions
Ventilation System
DA 270
To prevent accidents
UV
and machine damage,
read these instructions
before
installation or use. M.-Nr. 05 854 670
Inhaltszusammenfassung zur Seite Nr. 2
Contents Contents IMPORTANT SAFETY INSTRUCTIONS. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Functional description . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 Guide to the hood . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 Operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10 Turning on the fan . . . . .
Inhaltszusammenfassung zur Seite Nr. 3
IMPORTANT SAFETY INSTRUCTIONS Read these Operating Instructions carefully before installing or using the Ventilation System. This appliance is designed to vent This appliance is intended for cooking smoke and odors only. residential use only. Use the Be certain your appliance is appliance only for its intended properly installed and grounded by purpose. The manufacturer cannot a qualified technician. be held responsible for damages To guarantee the electrical safety of this caused by improper us
Inhaltszusammenfassung zur Seite Nr. 4
IMPORTANT SAFETY INSTRUCTIONS This equipment is not designed for Use maritime use or for use in mobile Do not allow children to play with installations such as caravans or air- or operate the appliance or its craft. However, under certain conditions controls. Supervise its use by the it may be possible for an installation in elderly or infirm. these applications. Please contact the nearest Miele dealer or the Technical Be careful when preparing a Service Department with specific flambé beneath t
Inhaltszusammenfassung zur Seite Nr. 5
IMPORTANT SAFETY INSTRUCTIONS , WARNING - TO REDUCE , WARNING TO REDUCE THE RISK OF INJURY THE RISK OF A RANGE TOP TO PERSONS IN THE EVENT OF A GREASE FIRE: RANGE TOP GREASE FIRE, Never leave surface units OBSERVE THE FOLLOWING: unattended at high settings. SMOTHER FLAMES with a close Boilovers cause smoking and greasy fitting lid, cookie sheet, or metal spillovers may ignite. Heat oils slowly tray, then turn off the burner. on low or medium settings. BE CAREFUL TO PREVENT BURNS. Always turn the
Inhaltszusammenfassung zur Seite Nr. 6
IMPORTANT SAFETY INSTRUCTIONS Installation Never connect an exhaust hood to an active chimney, dryer vent, vent , WARNING flue, or room ventilating ductwork. Seek To reduce the risk of fire, only professional advice before connecting use metal ductwork. an exhaust hood vent to an existing, When installing the hood, follow the inactive chimney or vent flue. recommended minimum safety Ducted fans must always be distances between a Miele cooktop and vented outdoors. the hood: Make sure that the air
Inhaltszusammenfassung zur Seite Nr. 7
Functional description The hood offers two modes of operation: Air extraction The air is drawn in and cleaned by the grease filters and directed outside. The hood comes equipped with a non-return flap. This flap automatically closes when the hood is turned off so that no exchange of outside air and room air can occur. When the hood is turned on, the air pressure of the exhaust fan automatically opens the flap blowing the inside air and cooking odors outside. 7
Inhaltszusammenfassung zur Seite Nr. 8
Guide to the hood 8
Inhaltszusammenfassung zur Seite Nr. 9
Guide to the hood a Cover plate b Chimney c Canopy d Indirect lighting e Overhead lighting f Grease filter g Indirect lighting On/Off switch h Overhead lighting button The button turns the light on and off and also dims the light. The lighting can be used independently from the fan. i On/Off button j Fan power selection k Delayed shut down This button activates the Delayed Shut Down feature. The fan can be set to turn off automatically after either 5 or 15 minutes. l Grease filter button The ind
Inhaltszusammenfassung zur Seite Nr. 10
Operation Turning on the fan Fan performance The maximum air flow capacity is 625 cfm. Factors such as narrow duct diameter and bends will affect this value. ^ Press the On/Off button. There will also be a slight decrease in airflow for hoods operated in The fan runs at power level “lI”. recirculation mode due to the active The indicator lights. charcoal filter. Selecting the power level Level 1 operates at 40% capacity Level 2 operates at 60% capacity Level 3 operates at 80% capacity Level 4 op
Inhaltszusammenfassung zur Seite Nr. 11
Operation Turning off the fan Delayed Shut Down If odors or smoke remain in the kitchen after cooking has been completed, the Delayed Shut Down feature can be selected to allow the hood to continue ^ Press the On/Off button to turn the running for either 5 or 15 minutes. fan off. The indicator goes out. Automatic Safety Shut Off ^ Press the Delayed Shut Down button The fan will turn off automatically 10 while the fan is still running. hours after the last button was activated. The lighting howev
Inhaltszusammenfassung zur Seite Nr. 12
Operation Turning the lighting on/off Indirect lighting The overhead lighting can be turned on and off independently of the fan. ^ Press the indirect lighting switch to "I" to turn on the indirect lighting. ^ Press the light button briefly to turn ^ Press the indirect lighting switch to on the lighting. "O" to turn off the indirect lighting. The light button indicator illuminates. ^ Press the light button briefly again to turn off the lighting. The light button indicator will go out. Dimming th
Inhaltszusammenfassung zur Seite Nr. 13
Operation Filter timers Checking the filter timers To check the percentage of time Grease filters already used: A timer monitors the hours of operation. ^ Press the On/Off button to turn the The indicator for the grease filter will fan on. light after 30 hours of fan operation. The grease filters must then be cleaned. After the grease filters have been cleaned and put in place, the grease filter timer must be reset. ^ Press the grease button. ^ To do this, press the grease filter The number of f
Inhaltszusammenfassung zur Seite Nr. 14
Operation Reprogramming the grease The indicator for the grease filter and one of the_ indicators will flash. filter timer The grease filter timer is preset to 30 hours. This time can be lengthened or shortened to 20, 30, 40 or 50 hours. – A time of 20 hours should be programmed in kitchens with The lit indicator shows the programmed frequent pan or deep frying. time: – A time of 20 hours should also be 1st indicator from the left = 20 hours programmed if the kitchen is only 2nd indicator from t
Inhaltszusammenfassung zur Seite Nr. 15
Cleaning and Care Stainless steel Before cleaning or servicing the hood, disconnect it from the power Stainless steel surfaces can be cleaned supply by either removing the fuse, using a non-abrasive stainless steel unplugging it from the outlet or cleaner. manually "tripping" the circuit To help prevent resoiling, a conditioner breaker. for stainless steel can be applied. Cleaning the casing Stainless steel colored controls Warning: Never use abrasive clean- These controls may become dis- ers, s
Inhaltszusammenfassung zur Seite Nr. 16
Cleaning and Care Grease filters Cleaning the grease filters The reusable metal grease filters ^ Clean the filters remove solid particles from the vented kitchen air (grease, dust, etc). - by hand: use a scrub brush in warm water with a mild detergent. - in a dishwasher: place the filters vertically in the lower basket, making sure that the spray arm is not blocked. The grease filters should be cleaned every 3 - 4 weeks or whenever the Depending on the detergent, clean- grease filter indicator l
Inhaltszusammenfassung zur Seite Nr. 17
Cleaning and Care Inserting the grease filters When putting the grease filters back make sure that the locking clips are visible facing the cooking surface. If the filters are incorrectly installed, insert a small screwdriver into the slit along its edge to disengage it from the casing. ^ After returning the grease filters, press the grease filter button for 3 seconds to reset the timer. The indicator light will go out. ^ If the grease filters are cleaned before the grease filter timer has reach
Inhaltszusammenfassung zur Seite Nr. 18
Cleaning and Care Changing the light bulb Before changing the light bulbs, disconnect the hood from the power supply by either removing the fuse, unplugging it, or manually "tripping" the circuit breaker. When in use halogen bulbs become extremely hot, and they can burn your hands. Do not attempt to ^ To change the halogen bulb first change the bulbs until they have remove the lamp cover,a. had sufficient time to cool down. ^ Pull the bulb,b, out of its socket and replace with a new one. Do not
Inhaltszusammenfassung zur Seite Nr. 19
After Sales Service In the event of a fault which you cannot correct yourself please contact: – Your Miele Dealer or – The Miele Technical Service Department USA 1-800-999-1360 techserv@mieleusa.com CDN 1-800-565-6435 service@miele.ca When contacting the Technical Service Department, please quote the model and serial number of your appliance. These are shown on the data plate which is visible when the grease filter is removed. 19
Inhaltszusammenfassung zur Seite Nr. 20
20
