Inhaltszusammenfassung zur Seite Nr. 1
Operating and installation instructions
Ventilation System
DA 210-3
DA 220-3
To prevent accidents
UV
and machine damage,
read these instructions
before
installation or use. M.-Nr. 05 853 490
Inhaltszusammenfassung zur Seite Nr. 2
Table of Contents IMPORTANT SAFETY INSTRUCTIONS Guide to the appliance DA 210-2 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 DA 220-2 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 Functional description Operation Main power switch . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11 Turning on the fan . . . .
Inhaltszusammenfassung zur Seite Nr. 3
IMPORTANT SAFETY INSTRUCTIONS Read these Operating Instructions carefully before installing or using the Ventilation System. This appliance is designed to vent This appliance is intended for cooking smoke and odors only. residential use only. Use the Be certain your appliance is prop- appliance only for its intended erly installed and grounded by a purpose. The manufacturer cannot qualified technician. be held responsible for damages To guarantee the electrical safety of this caused by improper
Inhaltszusammenfassung zur Seite Nr. 4
IMPORTANT SAFETY INSTRUCTIONS This equipment is not designed for Use maritime use or for use in mobile Do not allow children to play with installations such as caravans or air- or operate the appliance or its craft. However, under certain conditions controls. Supervise its use by the it may be possible for an installation in elderly or infirm. these applications. Please contact the nearest Miele dealer or the Miele Tech- Be careful when preparing a nical Service Department with specific flambé b
Inhaltszusammenfassung zur Seite Nr. 5
IMPORTANT SAFETY INSTRUCTIONS , WARNING - TO REDUCE , WARNING TO REDUCE THE RISK OF INJURY THE RISK OF A RANGE TOP TO PERSONS IN THE EVENT OF A GREASE FIRE: RANGE TOP GREASE FIRE, Never leave surface units unat- OBSERVE THE FOLLOWING: tended at high settings. Boilovers SMOTHER FLAMES with a close cause smoking and greasy spillovers fitting lid, cookie sheet, or metal may ignite. Heat oils slowly on low or tray, then turn off the burner. medium settings. BE CAREFUL TO PREVENT BURNS. Always turn h
Inhaltszusammenfassung zur Seite Nr. 6
IMPORTANT SAFETY INSTRUCTIONS Installation Never connect an exhaust hood to an active chimney, dryer vent, vent , WARNING flue, or room ventilating ductwork. Seek To reduce the risk of fire, only professional advice before connecting use metal ductwork. an exhaust hood vent to an existing, When installing the hood, follow the inactive chimney or vent flue. recommended minimum safety dis- Ducted fans must always be tances between a Miele cooktop and vented outdoors. the hood: Make sure that the a
Inhaltszusammenfassung zur Seite Nr. 7
Guide to the appliance DA 210-2 7
Inhaltszusammenfassung zur Seite Nr. 8
Guide to the appliance DA 220-2 8
Inhaltszusammenfassung zur Seite Nr. 9
Guide to the appliance a Cover plate h Light button This button turns the light on and off b Chimney and also dims the light. The lighting can be used independently c Canopy of the fan. d Grease filters i On/Off button e Overhead lighting j Fan power level buttons Four fan speed selection. f Control panel k Delayed Shut Down g Main power switch This button activates the Delayed Shut Down feature. The fan can be set to turn off automatically after either 5 or 15 minutes. l Grease filter button Th
Inhaltszusammenfassung zur Seite Nr. 10
Functional description The ventilation hood works by air ex- traction. The air is drawn in and cleaned by the grease filters and di- rected outside. The hood comes equipped with a non-return flap. This flap automatically closes when the hood is turned off so that no exchange of outside air and room air can occur. When the hood is turned on, the air pressure of the ex- haust fan automatically opens the flap blowing the inside air and cooking odors outside. 10
Inhaltszusammenfassung zur Seite Nr. 11
Operation Main power switch Intensive setting Level "4" (yellow indicator) should be used for a short period when frying or cooking food with a strong aroma. Fan performance Press the main power switch to "I". The fan and the lighting can now be oper- The maximum air flow capacity is ated. 625 cfm. Factors such as narrow duct diameter and bends will affect this If the appliance is not going to be used value. for a long period of time (e.g. while va- cationing) turn the appliance off by Level 1 o
Inhaltszusammenfassung zur Seite Nr. 12
Operation Turning off the fan Turning the lighting on/off The overhead lighting can be turned on and off independently of the fan. ^ Press the On/Off button to turn the fan off. The indicator goes out. ^ Press the light button briefly to turn on the lighting. Automatic Safety Shut Off The light button indicator illuminates. The fan will turn off automatically ^ Press the light button briefly again to 10 hours after the last button was acti- turn off the lighting. vated. The lighting however will
Inhaltszusammenfassung zur Seite Nr. 13
Operation Grease filter timer Checking the grease filter timer A timer monitors the hours of fan opera- To check the percentage of time al- tion. The indicator for the grease filter ready used: will light after 30 hours of operation. The grease filters must then be cleaned. After the grease filters have been cleaned and put in place, the grease fil- ter timer must be reset. ^ Press the On/Off button to turn the fan on. ^ To do this, press the grease filter but- ton for about 3 seconds. ^ Press t
Inhaltszusammenfassung zur Seite Nr. 14
Operation Reprogramming the grease filter timer The grease filter timer is preset to 30 hours. This time can be lengthened or The indicator for the grease filter and shortened to 20, 30, 40 or 50 hours. one of the_ indicators will flash. – A time of 20 hours should be pro- The lit_ indicator shows the pro- grammed in kitchens with frequent grammed time: pan or deep frying. 1st indicator from the left = 20 hours – A time of 20 hours should also be 2nd indicator from the left = 30 hours programmed
Inhaltszusammenfassung zur Seite Nr. 15
Cleaning and care Stainless steel Before cleaning or servicing the hood, disconnect it from the power Stainless steel surfaces can be cleaned supply by either removing the fuse, using a non-abrasive stainless steel unplugging it from the outlet or man- cleaner. ually "tripping" the circuit breaker. To help prevent resoiling, a conditioner for stainless steel can also be used. Cleaning the casing Apply sparingly with even pressure. ,Never use abrasive cleaners, Stainless steel colored controls sc
Inhaltszusammenfassung zur Seite Nr. 16
Cleaning and care Grease filters ^ Clean the filters - by hand: use a scrub brush in The reusable metal grease filters re- warm water with a mild detergent. move solid particles from the vented - in a dishwasher: place the filters in kitchen air (grease, dust, etc). the lower basket, making sure that the spray arm is not blocked. Depending on the detergent, clean- ing the grease filters in a dishwasher may cause permanent discoloration The grease filters should be cleaned of the filter surface.
Inhaltszusammenfassung zur Seite Nr. 17
Cleaning and care Changing the light bulb To change a bulb: Before changing the light bulbs, dis- connect the hood from the power supply by either removing the fuse, unplugging it, or manually "tripping" the circuit breaker. When in use halogen bulbs become extremely hot, and they can burn your hands. Do not attempt to change the bulbs until they have had sufficient time to cool down. ^ Remove the outer ring,a. Do not touch the bulb surface. Fin- gerprints or body oils deposited on ^ Support the
Inhaltszusammenfassung zur Seite Nr. 18
After Sales Service In the event of a fault which you cannot correct yourself please contact: – Your Miele Dealer or – The Miele Technical Service Department USA 1-800-999-1360 techserv@mieleusa.com CDN 1-800-565-6435 service@miele.ca When contacting the Technical Service Department, please quote the model and serial number of your appliance. These are shown on the data plate which is visible when the grease filter is removed. 18
Inhaltszusammenfassung zur Seite Nr. 19
Installation instructions
Inhaltszusammenfassung zur Seite Nr. 20
Table of Contents Caring for the environment Structural support Electrical data Appliance dimensions DA 210-2 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 24 DA 220-2 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 25 Installation Air extraction 20
