Inhaltszusammenfassung zur Seite Nr. 1
3-864-133-11(1)
CD Radio
Cassette-Corder
Operating Instructions
CFD-CD777S
CFD-CD777L
1998 by Sony Corporation
Inhaltszusammenfassung zur Seite Nr. 2
Warning To prevent fire or shock hazard, do not expose the player to rain or moisture. To avoid electrical shock, do not open the cabinet. Refer servicing to qualified personnel only. Warning Do not install the appliance in a confined space, such as a bookcase or built-in cabinet. The FUNCTION selector is located at the front. When you turn on the player, the OPR/BATT indicator lights up. 2 Introduction
Inhaltszusammenfassung zur Seite Nr. 3
Basic Operations Table of contents Basic Operations 4 Playing a CD 6 Listening to the radio 8 Playing a tape 10 Recording on a tape 12 Dubbing The CD Player Setting Up 14 Using the display 20 Hooking up the system 15 Locating a specific track 23 Connecting optional components 16 Playing tracks repeatedly 24 Adjusting the audio emphasis (DYNAMIC SOUND SYSTEM) (Repeat Play) 17 Creating your own program (Program Play) Additional Information 25 Precautions The Tape Player 27 Troubleshooting 19 Recor
Inhaltszusammenfassung zur Seite Nr. 4
Basic Operations Playing a CD 14 2,3 For hookup instructions, see pages 20 – 22. 1 Set FUNCTION to CD. FUNCTION CD TV/ LINE IN RADIO DUBBING TAPE CD/RADIO OFF 2 Press 6 PUSH OPEN/CLOSE down to open the lid of the CD compartment and place a CD on the CD compartment. With the label side up 3 Close the lid of the CD compartment. 4 Basic Operations
Inhaltszusammenfassung zur Seite Nr. 5
Basic Operations Display 4 Press ^ (( on the remote). The player plays all the tracks once. Track number Playing time Use these buttons for additional operations FUNCTION =, + ^ 6 PUSH OPEN/CLOSE VOLUME p Level meter Tip To Do this During operation, the adjust the volume Turn VOLUME. level meter shows the frequency level of the stop playback Press p. sound. Adjusting the volume pause playback Press ^. (on the remote, will not affect the level press P.) meter. Press the button again to resume pla
Inhaltszusammenfassung zur Seite Nr. 6
Listening to the radio 12 33 For hookup instructions, see pages 20 – 22. FUNCTION 1 Set FUNCTION to RADIO. CD TV/ LINE IN RADIO DUBBING TAPE CD/RADIO OFF 2 Set BAND to select the band you CFD-CD777L CFD-CD777S want. BAND BAND FM FM SW SW1 MW SW2 LW MW TUNING 3 Turn TUNING to tune in the station you want. FINE TUNING For better SW reception, use FINE TUNING. 6 Basic Operations
Inhaltszusammenfassung zur Seite Nr. 7
Basic Operations Use these buttons for additional operations FUNCTION VOLUME Level meter Tips To Do this • During operation, the level meter shows the adjust the volume Turn VOLUME. frequency level of the turn off the radio Set FUNCTION to TAPE•CD/ sound. RADIO OFF. Adjusting the volume will not affect the level meter. To improve broadcast reception • If the FM broadcast is Reorient the antenna for FM. Reorient the player itself noisy, set ISS•FM for MW or LW. For SW, extend the antenna vertical
Inhaltszusammenfassung zur Seite Nr. 8
Playing a tape 32 1 32 For hookup instructions, see pages 20 – 22. 1 Set FUNCTION to TAPE•CD/ FUNCTION RADIO OFF. CD TV/ LINE IN RADIO DUBBING TAPE CD/RADIO OFF 2 Press p6 to open tape STOP/EJECT compartment and insert a recorded tape. Use TYPE I (normal) tape only. Close the compartment. With the side you want to play facing you 3 Press PLAY (. PLAY The player starts playing. 8 Basic Operations
Inhaltszusammenfassung zur Seite Nr. 9
Basic Operations Use these buttons for additional operations DIRECTION Level meter » á DIR MODE VOLUME 0, ) p6 P 0, ) P p6 Note To Do this During playback, do not adjust the volume Turn VOLUME. press ), 0 or ( on the other deck as this stop playback Press p6. causes excessive wow and flutter. fast-forward or rewind Press ) or 0. the tape Tips pause playback Press P. • During operation, the Press the button again to level meter shows the resume play after pause. frequency level of the sound. play
Inhaltszusammenfassung zur Seite Nr. 10
Recording on a tape 211 3 MIC For hookup instructions, see pages 20 – 22. 1 Press p6 to open the tape STOP/EJECT compartment on deck B and insert a blank tape. With the side you want to record on facing you 2 Select the program source you Display FUNCTION want to record. CD TV/ To record from the CD player, set LINE IN RADIO FUNCTION to CD and insert a DUBBING CD (see page 4). TAPE CD/RADIO OFF FUNCTION To record from the radio, set CD TV/ FUNCTION to RADIO, and tune LINE IN RADIO in the stat
Inhaltszusammenfassung zur Seite Nr. 11
Basic Operations 3 Start recording. Deck B Press r on deck B (( is REC depressed automatically). Notes Use these buttons for additional operations • During recording, do not press ), 0 or p6 P PLAY on deck A as this causes excessive wow and flutter. • While recording from the built-in microphone (MIC), no sound comes from the speakers or the headphones. • When you connect the microphone to the MIX MIC jack, you cannot record from the built-in microphone. Tips • Adjusting the volume or To Press t
Inhaltszusammenfassung zur Seite Nr. 12
Dubbing 43 24 1 5 1 For hookup instructions, see pages 20 – 22. 1 Insert a recorded tape into deck A STOP/EJECT and a blank tape into deck B. With the side you want to record on facing you 2 Set FUNCTION to DUBBING. FUNCTION CD TV/ LINE IN RADIO DUBBING TAPE CD/RADIO OFF 3 To dub at high speed, press HIGH SPEED HIGH SPEED DUBBING to DUBBING ON. ON OFF To dub at normal speed, press HIGH SPEED DUBBING to OFF. 12 Basic Operations
Inhaltszusammenfassung zur Seite Nr. 13
Basic Operations 4 Press P and then press PLAY on deck A. Deck A PLAY PAUSE 5 Start dubbing. Deck B REC Press r on deck B (( is depressed automatically). Note Use these buttons for additional operations During dubbing, do not set FUNCTION or press p6 p6 HIGH SPEED DUBBING as this causes excessive wow and flutter. Tips • Adjusting the volume or the audio emphasis (see page 24) will not affect the recording level. • For the best results, use the AC power as a power source. • When the tape in deck
Inhaltszusammenfassung zur Seite Nr. 14
The CD Player Using the display You can check information about the CD using the display. DISPLAY Checking the total track number and playing time Check the display in stop mode. Total playing time Total track number Checking the remaining time Press DISPLAY (DISPLAY/ENTER on the player) while playing a CD. To display Press DISPLAY remaining time on the once current track* remaining time on the CD twice and the number of tracks left playing time and the current three times track number * For a t
Inhaltszusammenfassung zur Seite Nr. 15
The CD Player Locating a specific track You can quickly locate any track using the number buttons. You can also find a Number specific point in a track while playing a buttons CD. =, + Note To locate Press You cannot locate a a specific track directly the number button of the track. specific track if “SHUF REP” or “PGM” is lit in a point while listening to + (forward) or = (backward) the display. Turn off the sound while playing and hold down the indication by until you find the point. pressing
Inhaltszusammenfassung zur Seite Nr. 16
Playing tracks repeatedly (Repeat Play) Number You can play tracks repeatedly in buttons normal, shuffle or program play modes (see page 17). MODE ( Tip 1 Set FUNCTION to CD on the player. Press and hold LOOP on the remote during 2 Press MODE (PLAY MODE on the player) until play to repeat a the repeat mode you want appears in the display. selected part of a CD. When you release To repeat Select LOOP, the player a single track REP 1 returns to normal play. all the tracks REP ALL tracks in random
Inhaltszusammenfassung zur Seite Nr. 17
The CD Player Creating your own program (Program Play) Number You can arrange the playing order of up buttons to 20 tracks on a CD. MODE DISPLAY ( On the player 1 Set FUNCTION to CD on the player. 1 Set FUNCTION to CD. 2 Press MODE until “PGM” appears in the display. 2 Press PLAY MODE 3 Press the number buttons for the tracks you want until “PGM” appears to program in the order you want. in the display. 3 Press = or + Playing order then press DISPLAY/ENTER for the tracks you Programed track want
Inhaltszusammenfassung zur Seite Nr. 18
Creating your own program (Program Play) (continued) Tips To cancel Program Play • You can play the same Press MODE until “PGM” disappears from the program again, since display. the program is saved until you open the CD compartment or switch To check the order of tracks before play FUNCTION. Press DISPLAY. • The current program will be erased if you Every time you press the button, the track number switch FUNCTION or appears in the programed order. open the CD compartment. • You can record your
Inhaltszusammenfassung zur Seite Nr. 19
The Tape Player The Tape Player Recording MIX MIC FUNCTION r through a microphone/Using as a PA system an g u iso u s n d d o r c e r a n c Y o u e u s o r d e )i u p s p l n o t( o p h m o r n e ci b u p a s a re y al p Tip Recording through a microphone Y m c C o a n u o D x i r d r o c er d n a s d n u o s oid ar y o u ra d n g d ib y h m e t 1m o c r p i h t h e o n P u e l g o u d a i r h et o r o e ci o v M h t M n e i a X I jo c t k C I h e t o u h g h r t h e t o n n u r t n a d
Inhaltszusammenfassung zur Seite Nr. 20
Setting Up Hooking up the 4 Battery 1 Speaker terminals system compartment AC IN Make sure you turn off the power before making any connections. Right speaker Left speaker Speaker cord 2 to a wall outlet Tips 1 Hooking up the speakers • To detach the speakers, unlock speaker (see B 1 Align the grooves and slide the speaker box down on the diagram) and slide the speaker box all until it snaps into place A. the way up and away from the player. A • Connect the supplied speakers to this player. If y
