Inhaltszusammenfassung zur Seite Nr. 1
USER’S INFORMATION MANUAL
SINGLE AND MULTI-ZONE DUCTLESS SYSTEM
AIR CONDITIONER OR HEAT PUMP
MODELS: 16 & 22 SEER
TABLE OF CONTENTS
GENERAL . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 GENERAL OPERATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .6
SAFETY . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 REMOTE CONTROL BATTERIES REPLACEMENT . . . . . . . . . . . . .6
DUCT
Inhaltszusammenfassung zur Seite Nr. 2
898147-UUM-B-0713 MULTI-SPLIT SYSTEM SAFETY A multi-zone system consists of a single outdoor unit and two to five indoor units. Each zone is controlled separately by a remote control (included with the indoor unit). ELECTRICAL SHOCK, FIRE, OR EXPLOSION HAZARD. • This product must be installed and serviced by a qualified EQUIPMENT MODEL NUMBERS installer or service agency. Improper or incomplete installation, TABLE 1: adjustment, alteration, service or maintenance could cause per- sonal injury,
Inhaltszusammenfassung zur Seite Nr. 3
ON/OFF 898147-UUM-B-0713 1. AUTO Mode - Cooling Operation - If the indoor ambient tempera- DUCTLESS SYSTEM OPERATION ture is greater than 77°F (25°C), the ductless system will operate in MUTI-SPLITS APPLICATION ONLY cooling mode and will continue to run until the indoor ambient tem- perature reaches 75°F (24°C). At this point, the outdoor unit's com- In a multi-split application, the operating mode is determined by the pressor and outdoor fan will operate for another 60 seconds, then zone that i
Inhaltszusammenfassung zur Seite Nr. 4
898147-UUM-B-0713 MULTI-SPLITS AIR IN 1 INDOOR UNIT 2 5 AIR OUT 3 4 8 1. Front Panel 2. Filter 3. Guide Louver 4. Wall Pipe 6 5. Bind Tape 6. Connection Wire 7 7 Drainage Pipe 8. Remote Control 42 KBTU OUTDOOR UNIT (TWO TO FIVE ZONES) OUTDOOR UNIT 30 KBTU OUTDOOR UNIT (TWO TO FOUR ZONES) 24 KBTU OUTDOOR UNIT 18 KBTU OUTDOOR UNIT (TWO TO THREE ZONES) (ONE TO TWO ZONES) FIGURE 2: Multi-Split Units 4 Johnson Controls Unitary Products
Inhaltszusammenfassung zur Seite Nr. 5
898147-UUM-B-0713 I FEEL BUTTON REMOTE CONTROL OPERATION Press the I FEEL button to activate the I FEEL feature. When the I FEEL icon appears, the system will satisfy your cooling or heating (heat The wireless remote control gives the home- pump only) setpoint temperatures where the remote control is located. owner the ability to operate their ductless sys- Press the I FEEL button again to deactivate. When I FEEL function is tem at the touch of a button. The indoor unit deactivated, the system
Inhaltszusammenfassung zur Seite Nr. 6
898147-UUM-B-0713 TIMER ON BUTTON 9. Use X-FAN button to turn on and off extended fan operation feature in cooling and DRY modes. Use the TIMER ON button to initiate or cancel a single timed ON event. 10. Use TURBO button to speed up cooling or heating. Use this feature to bring the system on when you return home or when 11. Use I FEEL button to control your setpoint temperature from the you wake up in the morning. Press the TIMER ON button once. The remote control in cooling and heating modes.
Inhaltszusammenfassung zur Seite Nr. 7
898147-UUM-B-0713 NOTICE The TEST button is for the technicians' testing, which should not be used by our user. MAINTENANCE OUTDOOR UNIT 1. Ensure power is off before cleaning. 2. It may be necessary to wash the outdoor coil more frequently if it is Fig. A exposed to substances which are corrosive or which block airflow across the coil (e.g., pet urine, cottonwood seeds, fertilizers, fluids Fig. B that may contain high levels of corrosive chemicals such as salts). 3. Outdoor Coil (Sea Coast) - M
Inhaltszusammenfassung zur Seite Nr. 8
898147-UUM-B-0713 * The temperature readout (either temperature setpoint or indoor ambient) 72 will be replaced by an error code if there is a malfunction. If multiple errors are detected, the display will alternate between each error code. NOTE: No history is kept on past error codes. FIGURE 4: Indoor Unit Front Panel Indicators TABLE 2: Problem Possible Cause Unit does not operate immediately after Unit control initiates a 3 minute delay at the end of each cycle to protect the compressor fr
Inhaltszusammenfassung zur Seite Nr. 9
898147-UUM-B-0713 Limited Warranty WARRANTY TERMS: Johnson Controls Unitary Products (hereinafter “Company”) warrants this product to be free from defects in factory workman- ship and material under normal use and service and will, at its option, repair or replace any parts, without charge, subject to the exclusions below, that prove to have such defects according to the terms outlined in this warranty. Company reserves the right, at its sole discretion, to provide a replacement unit in the plac
Inhaltszusammenfassung zur Seite Nr. 10
EXCLUSIONS: This warranty does not cover any: 1. Shipping, labor, or material charges or damages resulting from transportation, installation, or servicing. 2. Damage or repairs required as a consequence of mishandling, faulty installation, misapplication, abuse, improper servicing, unauthorized altera- tion, or improper operation. 3. Damages or failure to start resulting from improper voltage conditions, blown fuses, open circuit breakers, or other inadequacy or interruption of electrical servic
