Bedienungsanleitung Kambrook KFH200

Inhaltszusammenfassung zur Seite Nr. 1

Kambrook - Australia Kambrook - New Zealand
Building 2, Port Air Industrial Estate Private Bag 94411
1A Hale Street Botany, Manukau
Botany NSW 2019 Auckland 2163
Australia New Zealand
Customer Service Line 1300 139 798 Customer Service Line/
Customer Service Fax 1800 621 337 Spare Parts 0800 273 845
Customer Service Fax 0800 288 513
www.kambrook.com.au
www.kambrook.co.nz
Upright
Fan Heater Instruction Booklet
Due to continual improvement in design or otherwise, the product you
purchase may dif

Inhaltszusammenfassung zur Seite Nr. 2

Contents Kambrook Recommends p4 Safety First Your Upright Fan Heater p6 Quick Start Guide p7 Using Your Upright p8 Fan Heater Care and Cleaning p10 Important Please retain your instruction book for future use. In the event that you need some assistance with your Kambrook appliance, please contact our Customer Service Department on 1300 139 798 (Australia) or 0800 273 845 (New Zealand). Alternatively, visit us on our website at www.kambrook.com.au or www.kambrook.co.nz

Inhaltszusammenfassung zur Seite Nr. 3

• To disconnect heater turn the control switch to • Regularly inspect the supply cord, plug, control OFF. Turn off at the power outlet then remove settings, air inlets and outlets and main housing the plug from its outlet. for any damage in any way. Immediately cease Kambrook Recommends Safety First use of the heater and return to Kambrook or an • Do not insert or allow foreign objects to pass authorised service agent for inspection or repair. through the inlet or outlet openings. This may

Inhaltszusammenfassung zur Seite Nr. 4

Your Kambrook Upright Fan Heater Quick Start Guide 1. 2400 watt heating element Not Shown Setting T urning the Turning the 2. Convenient carry handle • Safety tip-over cut-out switch the heat (at back) heater on heater off • ThermoGuard protection for temperature 3. 2 heat settings, plus fan peace of mind only setting Ensure heater is Plug the cord Turn the Heat Turn the heater off set to ‘0’ for OFF into a 230V or Setting dial to by turning the Heat position. 240V power setting ‘I

Inhaltszusammenfassung zur Seite Nr. 5

Using Your Upright Fan Heater Before First Use ThermoGuard Overheating NOTE: To avoid an electrical Remove any promotional material Safety Device circuit overload, it is and packaging from the heater. recommended that no other Unwind the cord to its full length appliances are plugged into and place the heater on a firm, level the same circuit as your heater, surface in a stable, upright position. when it is in use. Visually inspect the air inlet and outlets Your heater is fitted with a

Inhaltszusammenfassung zur Seite Nr. 6

Care and Cleaning Notes Ensure that the heater is switched off and disconnected from the power point before cleaning. Use a clean, dry cloth to clean the external surfaces of the heater. If the heater has collected dust or dirt inside the unit or around the elements, have the unit cleaned by a qualified service agent. Do not operate the heater in this condition. Do not attempt to open the case of the heater at any time as there are no customer serviceable parts inside. When not in use,