Bedienungsanleitung PYLE Audio PLVW1445R

Inhaltszusammenfassung zur Seite Nr. 1

1

Inhaltszusammenfassung zur Seite Nr. 2

TABLE OF CONTENT 1. INSTALLATION GUIDE 2. FUNCTION KEYS 2.1 FUNCTIONS OF FRONT PANEL 2.2 FUNCTIONS OF REMOTE CONTROL 3. TROUBLE SHOOTING 3.1 NO POWER 3.2 REMOTE CONTROL NOT FUNCTIONING 3.3 NO DISPLAY OR PICTURE NOT CLEAR 4. ACCESSORIES 5. SPECIFICATIONS 2

Inhaltszusammenfassung zur Seite Nr. 3

1. INSTALLATION GUIDE 1. On a towel or soft cloth, gently place the monitor unit "facedown" on a stable work surface. 2. Locate the pigtail with the DIN connector. 3. Connect the DIN connector to the interface cable provided. 4. Connect the RED wire to the positive (+) battery terminal. 5. Connect the Black wire to a chassis electrical ground point. 6. Connect the cable with YELLOW RCA jack to Video Input sources for your Video Program material. 7. Connect the cable with RED and WHITE

Inhaltszusammenfassung zur Seite Nr. 4

2. FUNCTION KEYS 2.1 FRONT PANEL FUNCTIONS POWER: 1. Press the "POWER" button once, it will be "POWER ON." Press it again, it will be "POWER OFF." MENU: 1. Pop up the OSD menus. Press the "Menu" button again to enter the OSD menus. When in sub-menu, press. "EXIT" to go back to the main menu. UP/DN: 1. Press the "UP/DOWN" key to increase or decrease value 2. Make item selection in OSD menus to increase or decrease

Inhaltszusammenfassung zur Seite Nr. 5

2.2 FUNCTIONS OF REMOTE CONTROL Brightness: → adjust Brightness. Contrast: → adjust Contrast. Display adjust: → Sharpness hue, saturation adjustment OSD display: → OSD adjustment and display methods Input select: → Switch between AV1 and AV2 Inputs. Audio: → Mutes the Audio Signal Recall: → Return to the main menu Exit: → Exit’s the menu Press the "Menu key", to display a crosswise bar with digits. Use the INC/DEC keys to adjust the value, and then press the

Inhaltszusammenfassung zur Seite Nr. 6

3. TROUBLE SHOOTING 3.1 NO POWER 1. Make sure the power cable has been pluged in. 2. Make sure the plug has 12V~14V, may use another electrical appliance to test it. 3.2 NO FUNCTION OF REMOTE CONTROL 1. Make sure the batteries are in good condition and installed properly. 2. Make sure the remote control is aiming at the receiver, and there are no obstacles in between. 3. Perhaps, it is too far away from the receiver. Normal distance is within 7 meters. 3.2 NO DISPLAY OR NOT CLEA

Inhaltszusammenfassung zur Seite Nr. 7

5. SPECIFICATIONS ITEM DESCRIPTION LCD Panel 14.1" TFT Active Area: 285.7 (W) x 214.3 (H) mm Resolution: 1024(H) x 3(RGB) x 768(V) Display Colors: 262,144 colors Pixel Pitch (mm): 0.279 (H) x 0.279 (V) mm Backlight Unit: CCFL Side-light type (four lamp) Contrast Ratio: 300 : 1 Brightness (cd/m2): 300 O O Viewing Angle: Horizontal:63 (typ.,Lift side), 63 (typ.,right side) O O Vertical: 45 (typ.,up side), 30 (typ.,down side) Power Supply: DC12V + 10% less than 2A IR Transmitter: