Bedienungsanleitung PYLE Audio VIEW PLVW1045R

Inhaltszusammenfassung zur Seite Nr. 1

10.4" Flip Down TFT-LCD Color
Monitor with IR
PLVW1045R

Inhaltszusammenfassung zur Seite Nr. 2

TABLE OF CONTENT INSTALLATION GUIDE 1. 2. FUNCTION KEYS 2.1 FUNCTIONS OF FRONT PANEL 2.2 FUNCTIONS OF REMOTE CONTROL TROUBLE SHOOTING 3. 3.1 NO POWER 3.2 NO FUNCTION OF REMOTE CONTROL 3.3 NO DISPLAY OR NOT CLEAR ACCESSORIES 4. SPECIFICA TIONS 5. 1

Inhaltszusammenfassung zur Seite Nr. 3

1. INSTALLATION GUIDE 1. On a towel or soft cloth, gently place the monitor unit "face down" on a stable work surface. 2. Locate the pigtail with the DIN connector. 3. Connect the DIN connector to the interface cable provided. 4. Connect the RED wire th the positive (+) battery terminal. 5. Connect the Black wire to a chassis electrical ground point. 6. Connect the cable with YELLOW RCA jack to Video Input sources for your Video Program m

Inhaltszusammenfassung zur Seite Nr. 4

2. FUNCTION KEYS 2.1 FUNCTIONSOF FRONT PANEL 1. Press the "POWER" button once, it will be "POWER ON." POWER: Press it again, it will be "POWER OFF." MENU: 1. Pop up the OSD menus. Press the "Menu" button again to enter the OSD menus. When in sub-menu, press. "EXIT" to go back to the main menu. UP/DN: 1. Press the "UP/DOWN" key to increase or decrease value 2. Make item selection in OSD menus to increase or decrease parameters as well.. 3

Inhaltszusammenfassung zur Seite Nr. 5

2.2 FUNCTIONS OF REMOTE CONTROL POWER Inc / Dec KEY MENU MENU MUTE AV1/AV2 REMOTE CONTROLLER Brightness: Brightness, contrast adjustment Video Control: RGB color density, deviation, sharpness adjustment OSD Function: OSD adjustment and display methods Image: Switch the source of signal AV1 and AV2

Inhaltszusammenfassung zur Seite Nr. 6

3. TROUBLE SHOOTING 3.1 NO POWER 1. Make sure the power cable has been pluged in. 2. Make sure the plug has 12V~14V, may use another electrical appliance to test it. 3.2 NO FUNCTION OF REMOTE CONTROL 1. Make sure the batteries are in good condition and installed properly. 2. Make sure the remote control is aiming at the receiver, and there are no obstacles in between. 3. Perhaps, it is too far away from the receiver. Normal

Inhaltszusammenfassung zur Seite Nr. 7

5. SPECIFICATIONS DESCRIPTION ITEM LCD Panel Type 10.4" a-Si TFT active matrix Screen Size: 26.4cm diagonal (10.4 inch) Display Resolution (dot): 640(H) x 3(RGB) x 480(V) Active Area: 165(W) x 95(H) Pixel Pitch: 0.33(H) x 0.33(V)mm Back Light: CCFL (Cold cathode filament tube) LCD Profile Ratio: 4 : 3 Contrast Ratio: 200 : 1 Brightness: 220 cd/m2 + Power Input Consumption: DC12V 10% less than 0.8A - System: NTSC and PAL auto switch SCEAM is available Video Input: Composite video signal 1Vp-