Inhaltszusammenfassung zur Seite Nr. 1
Inhaltszusammenfassung zur Seite Nr. 2
Contents Preface.........................................................................................................................2 Installation.................................................................................................................4 Unpacking ...............................................................................................................................................................................4 Viewing Angle Adjustment.............
Inhaltszusammenfassung zur Seite Nr. 3
Preface This manual is designed to assist users in setting up and using the LCD Monitor. Information in this document has been carefully checked for accuracy; however, no guarantee is given to the correctness of the contents. The information in this document is subject to change without notice. This document contains proprietary information protected by copyright. All rights are reserved. No part of this manual may be reproduced by any mechanical, electronic or other means, in any form,
Inhaltszusammenfassung zur Seite Nr. 4
Important Safety Instructions Please read the following instructions carefully. This manual should be retained for future use. 1. To clean the LCD Monitor screen: -- Power off the LCD Monitor and unplug the AC Cord. -- Spray a non-solvent cleaning solution onto a rag. -- Gently clean the screen with dampened rag. 2. Do not place the LCD Monitor near a window. Exposing the monitor to rain water, moisture or sunlight can severely damage it. 3. Do not apply pressure to the LCD sc
Inhaltszusammenfassung zur Seite Nr. 5
User’s Manual Installation Unpacking Before unpacking the LCD Monitor, prepare a suitable workspace for your Monitor and computer. You need a stable and clean surface near a wall power outlet. Make sure that the LCD Monitor has enough space around it for sufficient airflow. Though the LCD Monitor uses very little power, some ventilation is needed to ensure that the Monitor does not become too hot. After you unpack the LCD Monitor, make sure that the following items were included in
Inhaltszusammenfassung zur Seite Nr. 6
Viewing Angle Adjustment +90° The LCD Monitor is designed to allow users to have a -2° comfortable viewing angle. The viewing angle can be adjusted from -2°to +90°.(See fig. 1-1) Figure 1-1 Warning Do not force the LCD Monitor over its maximum viewing angle settings as stated above. Attempting this will result in damaging the Monitor and Monitor stand. M 4mmX11mm screw x 4 Detaching LCD Monitor from Its Stand Unscrew screws the swivel base support column and pull down
Inhaltszusammenfassung zur Seite Nr. 7
Connecting the AC Power 1. Connect the power cord to the LCD Monitor.(See Fig. 1-5) 2. Connect the power cord to an AC power source. Figure 1-5 Connecting the Audio Cable 1. Connect the audio cable to the “LINE OUT “ jack on your PC's audio card or to the front panel's “AUDIO OUT” jack of your CD ROM drive. (See Fig. 1-6) 2. Connect the other end of the audio cable to the LCD Monitor's " LINE IN " jack. Figure 1-6 Connecting the USB Cable 1. Connect the USB cable to th
Inhaltszusammenfassung zur Seite Nr. 8
Display Controls User Controls A brief description and the location of all LCD Monitor functions controls and indicators: Figure 2-1 Power LED will be Green when the monitor is on, Yellow when in power 1 saving mode, and Dark when the monitor is off. Press this button to turn on and turn off the monitor. Function select (clockwise) 2 Function select (counter-clockwise) 3 Audio Volume increase / Adjust increase. 4 Auto adjust (When OSD/Volume control is not activated)
Inhaltszusammenfassung zur Seite Nr. 9
Function Description Icon Function Function Description 101 scales of brightness are available to choose from (0 to 100). Brightness Contrast 101 scales of contrast are available to choose from (0 to 100). H. Position This function let's you adjust the display's horizontal position. V. Position This function let's you adjust the display's vertical position. This function let's you set the transparency of the OSD menu. The transparency is OSD Transparency adjustable from 0 t
Inhaltszusammenfassung zur Seite Nr. 10
OSD Lock Out Function When monitor is in normal display, you can enable the “OSD Lock Out” function. Option 1: OSD lock – all 4 buttons are locked except the “POWER” button. , and Press and hold the buttons for same time 3 seconds to lock the buttons. The monitor will show an “OSD Lock Out” message for 5~10 seconds and the message will disappear automatically. Repeat this step to unlock. Option 2: OSD & Power button lock – all 5 buttons including the “POWER” button a
Inhaltszusammenfassung zur Seite Nr. 11
Technical Information Specifications LCD Panel Size 15" (38.1 cm) Display Type Active matrix color TFT LCD Resolution 1024 x 768 Display Dot 1024 x (RGB) x 768 Display Area (mm) 304.128 x 228.096 (H x V) Display Color 16.7M (RGB 6 bits+Hi-FRC data) Lamp Voltage (typical) 560 Vrms Lamp Current (typical) 8.0 mA rms. Video Input Signal Analogue RGB 0.7Vp-p Input Impedance 75 Ohm ± 2% Polarity Positive, Negative Amplitude 0 - 0.7 ± 0.05 Vp Multi-mode Supported Horizontal Frequ
Inhaltszusammenfassung zur Seite Nr. 12
Power Management Mode Power Consumption* AC Input LED Color DPM ON 25W maximum 240 VAC GREEN DPM OFF 2W maximum 240 VAC Yellow DC switch off 1W maximum 240 VAC Dark Meeting VESA DPM requirements measured from AC Input end of AC power cord. Sync Input Analogue Signal Separate TTL compatible horizontal and vertical synchronization Polarity Positive and negative Supports VESA DDC2B functions Plug & Play External Connection Power Input (AC input) AC socket 15-pin D-sub connect
Inhaltszusammenfassung zur Seite Nr. 13
Standard Timing Table If the selected timing is NOT included in table below, this LCD monitor will use the most suitable available timing. FH(kHZ) SYNC FRONT SYNC TOTAL ACTIVE BACK PIXEL FV(HZ) WIDTH PORCH PORCH POLARITY (DOT/ (DOT/ FOREQ TIMING LINE) LINE) (DOT/LINE) (DOT/LINE) (DOT/LINE) (MHZ) 640x350 31.469 + 800 640 96 16 48 25.175 VGA-350 70.087 – 449 350 2 37 60 640x400 24.83 – 848 640 64 64 80 21.05 NEC PC9801 56.42 – 440 400 8 7 25 640x400 31.469 – 800 640 96 16 48 25.17
Inhaltszusammenfassung zur Seite Nr. 14
Troubleshooting This LCD Monitor has been pre-adjusted using factory standard VGA timings. Due to the output timing differences among various VGA cards in the market, users may initially experience an unstable or unclear display whenever a new display mode or new VGA card is selected. Attention This LCD Monitor Supports Multiple VGA Modes. Refer to the Standard Timing Table for a listing of modes supported by this LCD Monitor. PROBLEM Picture is unclear and unstable The picture i
Inhaltszusammenfassung zur Seite Nr. 15
Touch Screen Driver Installation The PJT155R/ PJT175R/ PJT195RW is available with USB connection. The touch software is located on the enclosed CD-ROM for these operating systems: Windows® 7, VISTA, XP, 2000, ME, 98, NT4.0, CE, XP Embedded, Linux, Apple® Mac OS Please Note: The PJT155R/ PJT175R/ PJT195RW is Microsoft® Windows® HID (Human Interface Device) compatible if you use the USB touch screen interface. No additional software driver is required for general operation of the touc
Inhaltszusammenfassung zur Seite Nr. 16
PJT155R/ PJT175R/ PJT195RW Install Instructions If you are using a PC running Windows® 7, VISTA, XP, 2000, ME, 98, NT4.0, follow the instructions below: 1. Power on the PC. 2. Be sure the USB cable is connected from the PC to the LCD display. 3. Download the driver online and execute. 4. Follow the step-by-step instructions as shown on the pop-up windows. If you are using a PC running Windows® XP Embedded, follow the instructions below: Express: 1. Power on the computer. 2. Make s
Inhaltszusammenfassung zur Seite Nr. 17
Product Registration and Technical Support Register Your Planar Products Today Thank you choosing Planar. To assure you receive all the benefits of your Planar product and services, register your Planar product today. Visit our website to register your product at http://www.planar.com/support/product_registration.html Cables, Replacement Lamps, Accessories To find cables, replacement lamps and accessories for your Planar projector, LCD monitor, touch screen or other Planar products
Inhaltszusammenfassung zur Seite Nr. 18
Planar Systems,Inc. Customer Service 24x7 Online Technical Support: http://www.planar.com/support 1195 NW Compton Drive Beaverton, OR 97006-1992 Tel: 1-866-PLANAR1 (866-752-6271), or +1 503-748-5799 outside the United States, Hours: 24 hours a day, 7 days a week 2012 Planar Systems, Inc. Planar is a registered trademark of Planar Systems, Inc. Other brands and names are the property of their respective owners. Technical information in this document is subject to change without notice. 020-113
