Inhaltszusammenfassung zur Seite Nr. 1
MV-VCR102UM 1/17/02 10:01 AM Page 1
TM
Owner’s Manual
In Vehicle Entertainment System with Drop Down 6.4” TV Screen, Remote Control,
Hi-Fi VCR and Wireless Headphones
MV-1002
Patent Pending
For Operation Assistance or Technical Assistance after Reading the
Troubleshooting Guide in this Manual, Please Call Toll Free (800) 638-3600
Inhaltszusammenfassung zur Seite Nr. 2
MV-VCR102UM 1/17/02 10:01 AM Page 2 Important Safety Instructions This symbol indicates the presence of CAUTION high voltage in the unit. It is dangerous to make any kind of contact with any inside RISK OF ELECTRIC SHOCK part of this product. DO NOT OPEN This symbol alerts you that important lit- CAUTION TO REDUCE THE RISK OF ELECTRIC SHOCK, DO erature concerning operation and main- tenance has been included with this NOT REMOVE COVER (OR BACK). NO USER SER- product. VICEABLE PARTS INSIDE. RE
Inhaltszusammenfassung zur Seite Nr. 3
MV-VCR102UM 1/17/02 10:01 AM Page 3 Table of Contents Important Safety Instructions............................................................................................................................. 2 Important Safeguards......................................................................................................................................... 2 Damage Requiring Service......................................................................................................
Inhaltszusammenfassung zur Seite Nr. 4
MV-VCR102UM 1/17/02 10:01 AM Page 4 Remote Control Battery Install / Replace 1. Slide battery compartment cover out from back of remote 2. Insert two AA batteries as diagrammed. (Supplied) control. 3. Slide battery compartment cover back in. VCR Controls Cassette Compartment For cassette insertion/removal Hi-Fi MOBILE VIDEO SYSTEM HEAD Hi-Fi Stereo VCR POWER Turns VCR PLAY POWER DEW EJECT REC POWER REC SLP HEAT R STOP REW FF on and off STOP REW PLAY F.F. EJECT REC LED Ejects Starts Sto
Inhaltszusammenfassung zur Seite Nr. 5
MV-VCR102UM 1/17/02 10:01 AM Page 5 Programming and Setup To prevent excessive drain on your vehicles battery, the WARNING! You must eject the tape before leaving the TM Movievision system will shut down 20 minutes after you turn the vehicle for extended periods of time. DO NOT leave a ignition key to the “OFF” position. tape in the VCR! Damage to the tape and the VCR will occur. This damage is not covered by any warranty. VCR Tape Playback 1. Turn “ON” the ignition switch and power will be
Inhaltszusammenfassung zur Seite Nr. 6
MV-VCR102UM 1/17/02 10:01 AM Page 6 Using VCR Special Features Audio Output Channel Setup The Audio Output function allows you to select four different When the VCR memorizes all the available channels, you can types of audio output. Press the “MENU” button on the use CH / buttons to select channel. Select the “CHANNEL remote control to access the “on screen menu.” Use the SETUP” using the “SHIFT” and “ENTER” button. “SHIFT” button to select the Audio Output function. Press the “ENTER” but
Inhaltszusammenfassung zur Seite Nr. 7
MV-VCR102UM 1/17/02 10:01 AM Page 7 Viewing Screen Controls and Functions 4. Adjusting the Screen’s Contrast: (CONTR) Rotate the contrast control to the left or the right to change the intensity of the dark colors compared to the light colors and vise versa. Rotating the control to the left (-) will make the screen darker (dark colors will dominate). Rotating the screen to the right (+) will make the screen lighter (lighter colors will dominate). Adjust the contrast of the screen to your vie
Inhaltszusammenfassung zur Seite Nr. 8
MV-VCR102UM 1/17/02 10:01 AM Page 8 Viewing Screen Controls and Functions Car Radio Interface: 7. Transmitter Frequency Selection: TM TM The signal transmitted from the Movievision screen can The Movievision viewing screen transmits a signal that TM be received by the existing FM car radio. This is received by the Movievision headphones and can also listening mode provides a much higher quality of sound for be received by the vehicle’s car radio. There are 3 fre- TM all. To listen to the Movi
Inhaltszusammenfassung zur Seite Nr. 9
MV-VCR102UM 1/17/02 10:01 AM Page 9 Domelight Operation (Continued) Replacing Domelight Bulbs: To replace a domelight bulb, repeat the following procedure. Warning! in some cases, the domelight maybe hot, proceed with caution. 1. Use your fingernail to pull the lever at the end of the domelight lens forward and downward this will release the lens to expose the bulb. 2. Use a pencil to pry out one end of the bulb then pull the remaining end of the bulb out of it’s clip. Do not use any Removin
Inhaltszusammenfassung zur Seite Nr. 10
MV-VCR102UM 1/17/02 10:01 AM Page 10 Headphone Operation (Continued) 3. Adjust the Headphones to Fit Your Head Repeat the following to adjust the headband to fit: A. Spread the ear pads apart and place the headphones on your head. Observe the “L” and “R” indicators. B. Grab the ear pads and use your thumb and forefinger to slide the adjusters up or down until a comfortable fit is achieved. Standard Headphone Operation 1 PWR OFF RAD MOV 3. Turn OFF the Headphones when Finished TM The bat
Inhaltszusammenfassung zur Seite Nr. 11
MV-VCR102UM 1/17/02 10:01 AM Page 11 Digital Headphone Operation 1. Turn On the Headphones: 3. Listening to What Is Displayed on the Viewing Screen: To turn on the headphones, press the ”PWR” button on the On the right ear pad are 3 pre-programmed buttons marked right side ear pad. The digital display will show radio station 1, 2 and 3. These buttons will tune the headphone radio to the digits when the headphone is on. exact MovieVision signals. Press the buttons one at a time until what you
Inhaltszusammenfassung zur Seite Nr. 12
MV-VCR102UM 1/17/02 10:01 AM Page 12 Cleaning and Maintenance Servicing: VCR Head Cleaning: TM Should your Movievision VCR become inoperative, do not The use of poor quality or old worn tapes can still leave try to correct the problem by yourself. There are no user deposits on the tape head preventing high picture and sound serviceable parts inside. Remove the unit from the vehicle quality. If a streaky or snowy picture (or no picture at all) TM and take it to an authorized Movievision servic
Inhaltszusammenfassung zur Seite Nr. 13
MV-VCR102UM 1/17/02 10:01 AM Page 13 Trouble Shooting Problem: No power Problem: Streaks (noise) or jitter with the VCR in Still mode. Solution: • Make sure the ignition switch is in the on position. Solution: Press “TRK” up or down to adjust the picture. • Check the power connection. • Check the remote for good batteries. Problem: VCR will not Play, Rewind or Fast Forward. Solution: • Check if the VCR is in Still mode. Problem: Videocassette cannot be inserted • Check if the cassette has bee
Inhaltszusammenfassung zur Seite Nr. 14
MV-VCR102UM 1/17/02 10:01 AM Page 14 Warranty ONE (1) YEAR LIMITED WARRANTY Magnadyne Corporation or its authorized agents will within 1 year from the date of sale to you, repair, replace or refund the retail sales price of said product or any part thereof, at the option of the Magnadyne Corporation or its authorized agents, if said product or part is found defective in materials or workmanship, when prop- erly connected and operating on the correct power requirements designated for the speci
Inhaltszusammenfassung zur Seite Nr. 15
MV-VCR102UM 1/17/02 10:01 AM Page 15 Replacement Parts Order Form Send Orders To: Magnadyne Corporation We Accept Checks, Money Orders, Visa and Master Card ATTN: Consumer Parts Sales Make Checks Payable to: Magnadyne Corporation P.O. Box 5365 Carson, CA 90749-5365 SHIP TO: (No P.O. Boxes) LAST NAME FIRST NAME INITIAL STREET ADDRESS (IF PAYING WITH A CREDIT CARD, YOUR BILLING ADDRESS IS REQUIRED) CITY STATE ZIP CODE DAY TIME PHONE NUMBER CREDIT CARD
Inhaltszusammenfassung zur Seite Nr. 16
MV-VCR102UM 1/17/02 10:01 AM Page 16 MV-VCR102UM © Copyright 2001 Rev. B 12-8-00 Magnadyne Corporation
