Inhaltszusammenfassung zur Seite Nr. 1
XDVD8130
INSTALLATION/OWNER'S MANUAL
DVD Multimedia Receiver with 2.5” TFT Display
Safety Note:
The DVD video display of the in-dash unit will not operate while the vehicle
is moving. This is a safety feature to prevent driver distraction. In-dash DVD
video functions will only operate when vehicle is in Park and the parking
brake is engaged. It is illegal in most states for the driver to view video
while the vehicle is in motion.
Inhaltszusammenfassung zur Seite Nr. 2
XDVD8130 PREPARATION Table of Contents Page DVD Region Management . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Safety Information/Precautions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Mounting/Wiring . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-7 Control Locations - Receiver . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Inhaltszusammenfassung zur Seite Nr. 3
XDVD8130 PREPARATION Safety Information Please read all instructions carefully before attempting to install or operate. Due to its technical nature, it is highly recommended that your DUAL XDVD8130 is installed by a professional installer or an authorized dealer. This product is only for use in vehicles with 12VDC negative ground only. Safety Notes: The DVD video display of the in-dash unit will not operate while the vehicle is moving. This is a safety feature to prevent driver distraction.
Inhaltszusammenfassung zur Seite Nr. 4
XDVD8130 INSTALLATION Preparation Please read entire manual before installation. Before You Start • Disconnect negative battery terminal. Consult a qualified technician for instructions. • Avoid installing the unit where it would be subject to high temperatures, such as from direct sunlight, or where it would be subject to dust, dirt or excessive vibration. Getting Started • Remove trim ring from unit. • Insert the supplied keys into the slots as shown, and slide the unit out of the mount
Inhaltszusammenfassung zur Seite Nr. 5
XDVD8130 INSTALLATION Wiring Diagram - Inputs/Outputs FUSE When replacing the fuse, make sure new fuse is the correct type and amperage. Using an incorrect fuse could damage the radio. The XDVD8130 uses one 10 amp ATM fuse located beside the wiring connector. 5
Inhaltszusammenfassung zur Seite Nr. 6
XDVD8130 INSTALLATION Wiring Diagram - Power/Speakers Wiring Notes: Connecting the parking brake lead (Yellow/Blue - ) The Yellow/Blue lead MUST be connected for the in-dash monitor to operate properly. The DVD video display of the in-dash unit will not operate while the vehicle is moving. This is a safety feature to prevent driver distraction. In-dash DVD video functions will only operate when vehicle is in Park and the parking brake is engaged. It is illegal in most states for the
Inhaltszusammenfassung zur Seite Nr. 7
XDVD8130 INSTALLATION Wiring Diagram - Optional A/V Connections The diagram above illustrates the connection capabilities of the XDVD8130. Two separate Audio/Video inputs allow the connection of a DVD player or game console. The video output provides signal to external monitors - such as an overhead or headrest type. A rear view camera can be connected to provide assistance when backing up your vehicle. Visit your local DUAL dealer for more details. * All items shown above are optional and
Inhaltszusammenfassung zur Seite Nr. 8
XDVD8130 OPERATION Control Locations - Receiver 1 2 3 4 7 10 5 6 8 9 11 12 19 18 17 16 15 14 13 Open Eject 1 11 Rotary Volume Tune/Track Up 2 12 Reset Auto Store/Preset Scan 3 13 Power Navigation Mode 4 14 Menu/Audio EQ 5 15 TFT LCD Display 6 16 Band/Play/Pause Infrared Sensor 7 17 8 Mode 18 Tilt Control/Video Mode 9 Tune/Track Down 19 Mute 10 Loudness/Sub On/Off Caution • Due to its highly technological design, the XDVD8130 faceplate is NOT removable. Do not attempt to remove the faceplate.
Inhaltszusammenfassung zur Seite Nr. 9
XDVD8130 OPERATION Mode Select Control Locations - Remote 1 21 2 22 3 4 23 5 24 6 7 25 8 26 9 10 27 11 28 12 29 13 30 14 15 31 32 16 33 17 34 18 19 35 36 20 37 XDVD8130 Power XNAV9525 Power* Tune/Track/Chapter Up 1 14 26 DVD Menu Preset #2/System* Display 2 15 27 Band/Play/Pause Preset #1/Escape* Title 3 16 28 4-Way Up Preset #4/Volume Down* Subtitle 4 17 29 4-Way Left Key #8/Function 2* Random 5 18 30 4-Way Down Key #7/Function 1* Repeat 6 19 31 Mute Slow/Function 4* Preset #3/Menu* 7 20 32 V
Inhaltszusammenfassung zur Seite Nr. 10
XDVD8130 OPERATION General Operation Power On/Off Press PWR or any other button (except EJECT or OPEN) to turn the unit on. Inserting a disc will turn the unit on automatically. Press PWR to turn the unit off. Reset Press RESET the unit upon initial installation or if abnormal operation occurs. Refer to page 8 for the reset button location. Mode Press MODE to select between tuner, DVD player and auxiliary input. Modes of operation are indicated in the display. Video (AUX) Press VID to
Inhaltszusammenfassung zur Seite Nr. 11
XDVD8130 OPERATION General Operation Programmable Press and hold PWR for 3 seconds to program currently Turn-On Volume selected volume level. "ON VOL" and the current volume level will momentarily appear in the display. The unit will return to this volume level anytime the unit turned on. Loudness Press LOUD to activate and deactivate loudness contour curve. Subwoofer Output Press and hold LOUD for more than 2 seconds to activate the subwoofer output. The SUB icon will illuminate in the
Inhaltszusammenfassung zur Seite Nr. 12
XDVD8130 OPERATION General Operation - Audio Settings Audio Adjustments Press AUD to select between Volume (default), Bass, Treble, Balance, Fader & Subwoofer (if activated). Bass Press AUD until BAS appears Rotate encoder left/right or use the VOL to adjust (-6 minimum / +6 maximum) Treble Press AUD until TRE appears Rotate encoder left/right or use the VOL to adjust (-6 minimum / +6 maximum) Balance Press AUD until BAL appears Rotate encoder left/right or use the VOL to adjust (B
Inhaltszusammenfassung zur Seite Nr. 13
XDVD8130 OPERATION General Operation - Setup Menu Audio/Video Menu Press MENU/AUD for more than 3 seconds to access the Audio/Video setup menu and adjust the following settings: Beep Confirmation Press MENU/AUD until Beep appears. Rotate encoder to turn the confirmation beep on or off. Rear View Image Press MENU/AUD until Rear View appears. Rotate encoder to select the V3 input to be mirrored (On) or normal (Off). TFT Brightness Press MENU/AUD until Bright appears. Rotate encoder to adjust (
Inhaltszusammenfassung zur Seite Nr. 14
XDVD8130 OPERATION AM/FM Tuner Operation Seek Tuning Press TUNE or TUNE momentarily to seek the nn ll next strong station. Manual Tuning Press TUNE or TUNE for more than 2 seconds, nn ll then release. "MANU" will momentarily appear in the display. Press TUNE or TUNE momentarily to nn ll move radio frequency up or down one step at a time. Press and hold to advance quickly. If tuning is not adjusted for 5 seconds, the unit will return to seek tuning mode (default) and "AUTO" will mome
Inhaltszusammenfassung zur Seite Nr. 15
XDVD8130 OPERATION DVD Setup Menu Access DVD Setup Menu With a disc inserted, press SETUP to access DVD setup menu. Press or to select between menu pages and / / / to adjust settings and or levels. When selectable, the menu item will be highlighted in blue. The current setting is indicated by a . Press ENTER to select/confirm each setting. Exit Setup Menu Press SETUP to save settings and exit the setup menu. Press / II to save settings and return to DVD playback. l Notes Some
Inhaltszusammenfassung zur Seite Nr. 16
XDVD8130 OPERATION General Operation - DVD Setup Menu Press or to select DISPLAY setup page and to Display Setup Page select options. Press or to select 4:3 or 16:9. This option also affects TV Aspect the composite video output signal. Press or to select Letterbox or Panscan. This option is Display Mode only available when the aspect ratio is set to 4:3. Display Setup Page 16
Inhaltszusammenfassung zur Seite Nr. 17
XDVD8130 OPERATION General Operation - DVD Setup Menu Audio Setup Page Press or to select AUDIO setup page and to select options. Dolby Digital Press or to select Bitstream or PCM. This option is only available when the Digital Output is turned on. Sample Freq. Press or to select 48kHz or 96kHz sampling frequency. This option is only available when the Digital Output is turned on. Digital Output Press or to select On or Off. The Digital Output must be turned on to select
Inhaltszusammenfassung zur Seite Nr. 18
XDVD8130 OPERATION DVD Setup Menu Press or to select LOCK setup page and to select Lock Setup Page options. Press or to select desired parental control level Rating (default setting is Unlock). The Unlock setting provides no (Parental Control) parental control. After a password is set, a password is required to change the parental controls setting. See below for details. Press or to select New. Enter a 4-digit password and Password press ENTER. Enter the 4-digit password ag
Inhaltszusammenfassung zur Seite Nr. 19
XDVD8130 OPERATION DVD Setup Menu Others Setup Page Press or to select OTHERS setup page and to select options. Load Default Press to load default factory settings. The DVD must be (Factory Settings) fully stopped before loading the default factory settings. See page 20 for details. Last Play Press or to select On or Off. Selecting Last Play On will remember the DVD playback position (for up to 10 DVDs) after the DVD has been ejected and re-inserted. Others Setup Page 19
Inhaltszusammenfassung zur Seite Nr. 20
XDVD8130 OPERATION DVD Operation Insert Disc Press EJECT to allow the rear panel to slide down. With the label facing up, insert a disc at least half way into the disc slot. The disc will auto-load and the rear panel will close. Some discs will play automatically when inserted. Eject Disc Press EJECT to allow the rear panel to slide down and eject the disc. If the disc is not removed within 10 seconds, the unit will reload the disc automatically. The unit does not have to be turned on. Pla
