Bedienungsanleitung Aiwa CDC-X227

Inhaltszusammenfassung zur Seite Nr. 1

OPERATING INSTRUCTIONS
MANUAL DE INSTRUCCIONES
CDC-X227 YU
MODE D’EMPLOI
STEREO CAR CD RECEIVER
RADIO-TOCADISCOS DE CD ESTEREOFONICO PARA
AUTOMOVIL
ENGLISH
ESPAÑOL
FRANÇAIS
OWNER’S RECORD
For your convenience, record the model number and
serial number (you will find them on the bottom side of
your set) in the space provided below. Please refer to
them when you contact your AIWA dealer in case of
difficulty.
Model No. CDC-X227
Serial No.
8C-KCG-921-01
011120ATM-OX

Inhaltszusammenfassung zur Seite Nr. 2

PRECAUTIONS TABLE OF CONTENTS • Use only in a 12-volt DC negative-ground electrical THEFT PROTECTION .............................................. 2 system. BASIC OPERATION, AUDIO AND CLOCK •Disconnect the vehicle’s negative battery terminal ADJUSTMENT ..................................................... 2 while mounting and connecting the unit. RADIO OPERATION ................................................. 3 • When replacing the fuse, be sure to use one with an CD PLAYER OPERATION ........

Inhaltszusammenfassung zur Seite Nr. 3

ENGLISH THEFT PROTECTION BASIC OPERATION, Take the front panel with you when leaving the car, and AUDIO AND CLOCK keep it in the supplied carrying case. ADJUSTMENT Detaching the front panel PWR/MUTE SEL Before detaching the front panel, remove the CD to AUDIO CONTROL prevent possible damage to the unit. 1 Press z to remove the CD. 2 Press and hold PWR/MUTE until the unit turns off. 3 Press %. (Hold the panel with one hand to prevent accidentally dropping it.) i/k DISP SRC 4 Remove the panel. BAN

Inhaltszusammenfassung zur Seite Nr. 4

Adjusting sound Setting the clock You can select the following modes for adjusting sound 1Press and hold DISP until the clock indicator depending on the music you listen to: BASS (low flashes in the display. frequencies), TRE (high frequencies), BAL (left/right), 2 Press i (to set hour) or k (to set minute), and FAD (front/ rear) and H-BASS (high bass). then turn AUDIO CONTROL. 1 Press SEL repeatedly to select the mode to be 3 Press DISP. adjusted. Pressing SEL cycles through the modes. The Dis

Inhaltszusammenfassung zur Seite Nr. 5

Monaural mode Presetting stations manually When signals become weak, or reception becomes (Manual Memory) poor, the unit automatically switches to Monaural mode 1 Press BAND repeatedly to select the desired band to reduce noise. (FM1, FM2, FM3, AM1, or AM2). Local mode 2 Press i or k to tune in to a desired station (see Local mode allows you to tune in only to strong stations “Tuning in to a station” as well for another tuning during Seek Tuning. method). 1 Press LO before you start seek tuning.

Inhaltszusammenfassung zur Seite Nr. 6

Note Labeled-side up During Random Play, pressing r allows you to skip only to the beginning of the current track, not to the previous track. AUXILIARY EQUIPMENT Track number Listening to a cassette/MD/MP3 portable player or other equipment You can listen to equipment connected to the unit. Refer to the operating instructions for the corresponding CD indicator Elapsed playing time equipment for more detailed information. Be sure to remove inserted CDs to prevent possible damage to the unit befor

Inhaltszusammenfassung zur Seite Nr. 7

TROUBLESHOOTING SPECIFICATIONS RADIO SECTION Error code (FM) In the following cases the corresponding error code Frequency Range: 87.5 MHz – 108 MHz indication appears. Follow the suggestions below to Usable Sensitivity: 12.7 dBf solve such problems. If the error code indication does 50 dB Quieting Sensitivity: 17.2 dBf not disappear, consult an AIWA service center. IF Rejection: 100 dB Frequency Response: 30 Hz – 15,000 Hz E03 Focus error. Check that the CD is loaded properly S/N Ratio: 70 dB (

Inhaltszusammenfassung zur Seite Nr. 8

Printed in Indonesia