Bedienungsanleitung Yamakawa M2090 M2095

Inhaltszusammenfassung zur Seite Nr. 1

ENTER
LOUD
SEL VOL VOL
BAND
APS DISP
MUTE
MP3
PTY AF TA 0
EON REG AF TA TP PTY
EQ D-AUD ST D-DIR MONO ME/CR FUNC S-CDP LOUD LOC
MODE
PAUSE SCAN RPT SHF
TUNE TUNE
7 8 9
1 2 3 4 5 6
M2090/M2095
RDS AM/FM Stereo
MP3 with ID3/CD-RW/CD-R/CD Player
Secure Fold Down
Detachable Panel

Inhaltszusammenfassung zur Seite Nr. 2

Inside Covers - Blank

Inhaltszusammenfassung zur Seite Nr. 3

Trouble Shooting Index Before going through the check list, check wiring connection. If any of the problem persist after check list had been made, Installation consult your nearest service dealer. Din-Front Mounting (Method A) 2 Din-Rear Mounting (Method B) 3 Using the Detachable Panel Unit 4 SymptomCause Solution No power The car ignition is not on. If the power supply is properly Operation connected to the car accessory Operating Controls 5 terminal, switch the ignition key to General Oper

Inhaltszusammenfassung zur Seite Nr. 4

Installation Wiring Connection and Specifications DIN-FRONT MOUNTING (METHOD A) 12 VOLTS NEGATIVE GROUND Notes: Installing the unit (U.S. & Others) (Europe) • Select an installation position so that you are not impeded Black Front AM 530-1710 kHz AM 522-1620 kHz by the unit while driving. FM 87.5-108 MHZ FM 87.5-108.0 MHZ Gray Rear (POWER) RED - TURN ON +ACC • Before you fix the unit in position, connect the cables up BLACK - GROUND briefly and check that the unit works! YELLOW -

Inhaltszusammenfassung zur Seite Nr. 5

S S S SE E E EL L L L 1 1 1 1 2 2 2 2 3 3 3 3 4 4 4 4 5 5 5 5 6 6 6 6 Installation Operation MP3 OPERATION DIN-REAR MOUNTING (METHOD B) • Method 1 - By Numerical Track Number • Press "APS" (#18) Once • Playing an MP3 Disc Removing the unit Use the screw holes on the side of the unit during • Then from the key assignment list (Table 1) enter the 1, Insert your MP3 and all tracks will be played installation. 2 or 3 digit track number consecutively consecutively or you can mov

Inhaltszusammenfassung zur Seite Nr. 6

S SE EL L 1 1 2 2 3 3 4 4 5 5 6 6 S SE EL L 1 1 2 2 3 3 4 4 5 5 6 6 S SE EL L 1 1 2 2 3 3 4 4 5 5 6 6 S SE EL L 1 1 2 2 3 3 4 4 5 5 6 6 S SE EL L 1 1 2 2 3 3 4 4 5 5 6 6 Using the Detachable Panel Unit Operation CD and CDC OPERATION Removing the panel unit Inserting the panel unit • Selecting music tracks NOTES ON BLANK CD-Rs AND CD-RWs In CD or CDC mode, the “ ” and “ ” keys (#16 and • With this car radio, you can listen to back-up copies of #17) allow

Inhaltszusammenfassung zur Seite Nr. 7

Operation Operation When you press and hold down the “SEL” (#10) key for a • “BEEP 2ND”, “BEEP ALL” and “BEEP OFF” function few secounds, the following RDS functions will be shown in The volume of the beep tones can be changed using the 7 3 8 10 12 11 13 9 the display and can be used. “AUDIO CONTROL +” key (#11) and the “AUDIO CONTROL –“ key (#12). TA SEEK or ALARM PI SOUND or MUTE • “BEEP 2ND” mode ENTER MASK DPI or ALL RETUNE L or S LOUD SEL VOL VOL When this function

Inhaltszusammenfassung zur Seite Nr. 8

Operation Operation GENERAL OPERATION RDS (RADIO DATA SYSTEM) OPERATION • Electronic equaliser • Traffic announcement mode (TA) • On/Off switch • Activating the RDS function When the “TA” key (#2) (traffic announcement) has been After pressing the “EQ” key (#28), you access control of You can switch on the unit with any key! (Except for the Use the “AF” key (#3) to switch this function on and off. pressed, the CD (MP3) or CDC mode is active, then the the following menu: “OPEN” Key (#7) and t