Inhaltszusammenfassung zur Seite Nr. 1
CD-RECEIVER
KDC-7018
INSTRUCTION MANUAL
KDC-V7018R
KDC-5018
COMPACT
DIGITAL AUDIO
©B64-1877-00 (MW)
Inhaltszusammenfassung zur Seite Nr. 2
Contents Safety precautions Function.......................................................19 Restricting RDS Region (Region Restrict Safety precautions.............................................3 Function)......................................................33 Tuner features Handling Compact discs....................................5 Auto TP Seek Function....................................33 Tuning..............................................................20 Monaural Reception ..........
Inhaltszusammenfassung zur Seite Nr. 3
Safety precautions IMPORTANT INFORMATION 2WARNING 2CAUTION About the disc changer to be To prevent injury or fire, take the To prevent damage to the machine, connected: following precautions: take the following precautions: To connect a disc changer having the "O-N" • Insert the unit all the way in until it is fully • Make sure to ground the unit to a negative switch to this unit, set the "O-N" switch to locked in place. Otherwise it may fall out of 12V DC power supply. "N". place when jolted. W
Inhaltszusammenfassung zur Seite Nr. 4
Safety precautions • The illustrations of the display and the panel Cleaning the CD Slot NOTE appearing in this manual are examples used As dust tends to accumulate in the CD slot, to explain more clearly how the controls are • If you experience problems during clean it every once in a while. Your CDs can used. Therefore, what appears on the display installation, consult your Kenwood dealer. get scratched if you put them in a dusty CD in the illustrations may differ from what slot. • Press the
Inhaltszusammenfassung zur Seite Nr. 5
Handling Compact discs Playing a CD that is dirty, scratched Storing CDs Checking New CDs for Burrs or warped can cause the sound to • Do not store CDs in areas exposed to direct When playing a new CD for the first time, sunlight (such as a car seat or the check that there are not any burrs stuck to skip and the unit to operate dashboard) or other hot places. A CD-R or the perimeter of the disc or in the central incorrectly, resulting in worsened CD-RW is more susceptible than a music hole. CDs
Inhaltszusammenfassung zur Seite Nr. 6
Handling Compact discs Do Not Load CD Accessories Do Not Use Special Shape CDs Do Not Use CDs with Sticker on the Do not use commercially available CD • Be sure to use round shape CDs only for Labeled Side accessories that can be loaded into the CD this unit and do not use any special shape Do not use the CD with the label sticker slot, such as stabilizers, protective sheets, CDs. Use of special shape CDs may cause stuck on it. or CD cleaning discs, since they can cause the unit to malfunction.
Inhaltszusammenfassung zur Seite Nr. 7
General features Power 5 / ∞ Q SRC / PWR OFF CLK Turning on the power: Press the SRC (source) button. NOTE Turn the power on before carrying out the following procedures. Turning off the power: Press the PWR OFF button for at least one second. NOTE ATT/LOUD DISP FM AM/ The status of the Security Code function (page 28) is displayed Release NF whenever the power is switched on. button 4¢ "CODE ON" : Security Code has been registered KDC-7018/KDC-5018 "CODE OFF" : Security Code has not been regist
Inhaltszusammenfassung zur Seite Nr. 8
General features mode. Switching Modes Pressing 4 or ¢ button during this mode allows you to select "AUX" , "TV" , "VCP" , "GAME" or "PORTABLE" in the AUX mode. Switching Modes: The AUX-name selection mode can be exited by pressing the Each time you press the SRC (source) button, the mode DISP button or doing nothing for 10 seconds. switches as follows: ▼ Tuner mode Loudness ▼ CD mode This function amplifies low and high tones when the volume is ▼ turned down. External disc control mode 1 Th
Inhaltszusammenfassung zur Seite Nr. 9
sound quality parameters: Function of the KDC-7018 Bass center frequency, bass level, bass quality factor, bass Non-Fading Output extend, middle center frequency, middle level, middle quality You can turn the non-fading output on and off. factor, treble center frequency, treble level, non-fading level, high-pass filter frequency for front output, high-pass filter Turning non-fading output On/Off : frequency for rear output, and low-pass filter frequency for non- Press the NF button for at least
Inhaltszusammenfassung zur Seite Nr. 10
General features Theft Deterrent Faceplate The faceplate can be reversed to hide the control panel or detached form the unit, helping to deter theft. Removing the Faceplate: 1 • When the control panel is visible: Press the release button. 2CAUTION • When the control panel has been hidden: Do not set the right side of the faceplate in the faceplate bracket Press the upper side of the faceplate. first, when reattaching the faceplate. Doing so may cause the 2 Holding the center part of the faceplat
Inhaltszusammenfassung zur Seite Nr. 11
Audio control features NOTE Q While the control panel is sliding, only available buttons are 0, ATT, ▲, ▼ and SRC. FM AM 4¢ KDC-7018/KDC-5018 Selecting mode Setting value KDC-V7018R Selecting mode Setting value — 11 —
Inhaltszusammenfassung zur Seite Nr. 12
Audio control features Audio Control Setting Middle Level Adjust various parameters of sound quality. Adjust the middle level. 1 Press the AUD button for at least one second to enter the Display and setting: "Middle"/"MID" : - 8 – + 8 control mode. 2 Selecting mode Press either the FM or AM button. Treble Level Each time the button is pressed, the adjustment mode will Adjust the treble level. change. Please refer to the following for the contents of the Display and setting: adjustment modes. "
Inhaltszusammenfassung zur Seite Nr. 13
Function of the KDC-7018 Function of the KDC-7018 High-pass Filter Frequency for Front Output Phase for Non-Fading Output Adjust the frequency of the High-pass filter for front output. Adjust the phase for Non-Fading output. Display and setting: Display and setting: "HPF F" : Through / 40Hz / 60Hz / 80Hz / 100Hz / 120Hz / "NF Phase" : Normal (0°) / Reverse (180°) 150Hz / 180Hz / 220Hz NOTE You can separately set the high-pass filter for front and rear Volume Offset output, including preouts. The
Inhaltszusammenfassung zur Seite Nr. 14
Tuner features Function of the KDC-V7018R Tuning DISP SRC 1 Press the SRC (source) button repeatedly to select the tuner mode. "TUNER" is displayed when the tuner mode has been selected. 2 Press either the FM or AM button to select the band. Each time you press the FM button, the band switches between the FM1, FM2 and FM3. Press the AM button to select the MW and LW bands. 3 • Auto Seek Tuning #1-6 AM FM Press the ¢ button to seek higher frequencies. 4¢ Press the 4 button to seek lower frequenci
Inhaltszusammenfassung zur Seite Nr. 15
RDS features Function of the KDC-V7018R 2 Press the button (#1-6) that you want to use for the station, for DISP PTY at least two seconds. The button number blinks once in the display to indicate that the data has been stored. Recalling a Preset Station: Press the preset station button (#1-6) for the desired station. The number of the recalled station is displayed. NOTE You can store six stations in each of the FM1, FM2, FM3, and AM (MW and LW) bands. #1-6 TI/ AM FM VOL ADJ 4¢ Switching Display
Inhaltszusammenfassung zur Seite Nr. 16
RDS features Function of the KDC-V7018R Press the TI button to turn the function on and off. RDS (Radio Data System) When the function is on, the TI indicator is turned on. RDS is a digital information system that lets you receive When none is being received, the TI indicator will blink on and signals besides those of regular radio programs, such as off. When a traffic information station is being received, the TI network information being transmitted from radio stations. indicator will turn on.
Inhaltszusammenfassung zur Seite Nr. 17
2 Adjust the volume to the desired level. 3 Press the VOL ADJ button for at least two seconds. The volume level blinks once in the display to indicate that the data has been stored. Future traffic information/news broadcasts are heard at the preset level. NOTE • The volume cannot be lowered by this function during tuner reception. The volume is only set when it is louder than the listening volume of the tuner. •You can arrange only to listen to traffic information or news bulletins with at pres
Inhaltszusammenfassung zur Seite Nr. 18
RDS features Function of the KDC-V7018R 24. Jazz Music (Jazz) Program Type (PTY) Function 25. Country Music (Country) Conduct auto seek tuning only on those stations with selected 26. National Music (Nation M) kinds of programs. 27. Oldies Music (Oldies) 28. Folk Music (Folk M) 1 Press the PTY button. 29. Documentary (Document) "PTY" is displayed, and the Program Type Selection (PTY) Mode (Speech.....1~9,16~23, 29, Music.....10~15, 24~28) entered. • You can select the type of program directly by
Inhaltszusammenfassung zur Seite Nr. 19
Tuner features Function of the KDC-7018/KDC-5018 Changing Language for Program Type (PTY) DISP/NAME.S 38 SRC Function Changing the display language to another language. 1 Press the PTY button. "PTY" is displayed, and the Program Type Selection (PTY) Mode entered. 2 Enter the Changing Language Mode Press the DISP button to enter the changing language mode. #1-6 AUTO/ AM FM 3 Changing the Display Language Reset AME Press the FM or AM button. button 4¢ Each time the button is pressed, the display l
Inhaltszusammenfassung zur Seite Nr. 20
Tuner features Function of the KDC-7018/KDC-5018 received. Tuning You can choose from three tuning modes: auto seek, preset station seek, and manual. The AUTO 1 indicator lights up Station Preset Memory when auto seek tuning is selected, and the AUTO 2 indicator Store the frequency of a station. You can then recall that lights when preset station seek tuning is selected. station with a single touch of a button. Selecting Tuning Mode: 1 Select the band/station that you want to have stored. Press
