Bedienungsanleitung JVC KW-XR418

Inhaltszusammenfassung zur Seite Nr. 1

INFORMATION (For U.S.A.)
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no g

Inhaltszusammenfassung zur Seite Nr. 2

Listening to the radio Listening to the disc ~ Ÿ ~ Ÿ “ST” lights up when receiving an FM stereo broadcast with ] “FM” or “AM” ] Turn on the power. sufficient signal strength. Manual search Selecting a preset station All tracks will be played repeatedly until you change the source or “M” flashes, then press the eject the disc. 1 button repeatedly. [Hold] Caution on volume setting: Selecting the playback modes Discs produce very little noise compared with other You can use only one of the fol

Inhaltszusammenfassung zur Seite Nr. 3

Selecting a preset sound mode You can select a preset sound mode suitable for the music genre. Storing your own sound mode Sound element Tone FLAT = NATURAL = DYNAMIC = You can store your own adjustments in memory. Frequency Level Q VOCAL BOOST = BASS BOOST = BASS 60 Hz, 80 Hz, 100 Hz, –06 to +06 Q1.0, Q1.25, 1 USER = (back to the beginning) 200 Hz Q1.5, Q2.0 [Hold] MIDDLE 0.5 kHz, 1.0 kHz, –06 to +06 Q0.75, Q1.0, While listening, you can adjust the tone level of the selected sound 1.5 kHz

Inhaltszusammenfassung zur Seite Nr. 4

Installation This unit is designed to operate on 12 V DC, NEGATIVE ground Prepare these before installation.... (B) Installing with the mounting brackets from the car electrical systems. If your vehicle does not have this system, a voltage inverter is required, which can be purchased at JVC car audio dealers. Audio system originally installed in the car Warnings • To prevent short circuits: – Disconnect the battery’s negative terminal and make all electrical connections before installing th

Inhaltszusammenfassung zur Seite Nr. 5

Electrical connections More about this unit IMPORTANT: A custom wiring harness (separately purchased) which is suitable for your car is recommended General • This unit can recognize a total of 512 files, 255 for connection between the unit and your car. folders, and 8 hierarchical levels. • If you turn off the power while listening to a track, • Consult your JVC car audio dealer or a company supplying kits for details. • This unit can play back files recorded in VBR playback will start from

Inhaltszusammenfassung zur Seite Nr. 6

Troubleshooting Maintenance Moisture condensation To play new discs Symptom Remedy/Cause Moisture may condense on the lens inside the unit. Remove any rough areas from the Sound cannot be heard from the • Adjust the volume to the optimum level. Eject the disc and leave the unit turned on for a few inner and outer edges of the disc. speakers. • Make sure the unit is not muted/paused. (See page 1.) hours until the moisture has evaporated. • Check the cords and connections. “PROTECT” appears on