Bedienungsanleitung JL Audio Stealthbox SB-T-TUNCNSL/10W3

Inhaltszusammenfassung zur Seite Nr. 1

TM
STEALTHBOX
SB-T-TUNCNSL/10W3
Fits 1999-UP Toyota Tundra with bucket seats/console
Installation of this Stealthbox requires professional installation skills and tools. Please read this installation guide
thoroughly before beginning the project. It will guide you step by step through the installation. It is absolutely
vital that the enclosure be properly mounted to the vehicle according to these instructions. Failure to mount
the enclosure properly presents two problems: 1) The sub-bass

Inhaltszusammenfassung zur Seite Nr. 2

STEP 7: Flip the console and Stealthbox upside down. Using the existing holes on each side of the console as guides, drill 7/64” pilot holes into the Stealthbox. Picture #4 STEP 8: Secure the console shell to the Stealthbox using the four supplied black pan-head screws. The console is now ready to be installed into the vehicle. Picture #5 STEP 9: Using a 3/8” drill bit, drill out the two front factory console mounting holes. CAUTION: Check under the vehicle for any loose brake lines,

Inhaltszusammenfassung zur Seite Nr. 3

STEP 11: Tuck each carpet fl ap underneath carpet. Picture #8 STEP 12: Reinstall the rear factory console mounting screws to seal up the holes. These screws are no longer used to secure the console. Picture #9 STEP 13: Run speaker wire to the front area of the Stealthbox. Set the Stealthbox in the vehicle and attach the wire to the terminal strip on the Stealthbox and test the Stealthbox for proper operation. Picture #10 STEP 14: Position the console and Stealthbox in place in the veh

Inhaltszusammenfassung zur Seite Nr. 4

STEP 15: Secure Stealthbox from under the vehicle with the supplied bolts, lock washers and fender washers as shown in Diagram #1. These bolts will travel through the holes drilled out in Step #9. Using a bead of silicon sealant between the metal of the vehicle and the fender washer is recommended to prevent rust. THREADED INSERT ENCLOSURE WALL Picture #12 VEHICLE SHEET METAL SILICONE SEALANT FENDER WASHER LOCK WASHER BOLT Diagram #1 The internal volume of this enclosure is 0.65 cubic fe