Inhaltszusammenfassung zur Seite Nr. 1
H- CDM8047
CD/MP3-RECEIVER CD/MP3-
Instruction manual
Inhaltszusammenfassung zur Seite Nr. 2
Dear customer! Thank you for purchasing our product. For safety, it is strongly recommended to read this manual carefully before connecting, operating and/or adjusting the product and keep the manual for reference in the future. Table of contents Tabl of contents...........................................................................................................................................................................2 Importansafeguards..............................................
Inhaltszusammenfassung zur Seite Nr. 3
Important safeguards · Read carefully through this manual to familiarize yourself with this high-quality sound system. · Use only in a 12-volt DC negative-ground electrical system. · Disconnect the vehicle's negative battery terminal while mounting and connecting the unit. · When replacing the fuse, be sure to use one with an identical amperage rating. Using a fuse with a higher amperage rating may cause serious damage to the unit. · DO NOT attempt to disassemble the unit. Laser beams from the o
Inhaltszusammenfassung zur Seite Nr. 4
Installation/ Connections Attention: REMOVE THE TRANSPORT CD STOPPER (2 SCREWS) BEFORE USE. Din front-mount (method 1) · After inserting the holder into the dashboard, select the appropriate tab and bend them inwards to secure the holder in place. · Insert fingers into the groove in the front of frame and remove it. · Insert the levers supplied with the unit to the grooves at both sides. The unit can be installed or removed from the dashboard. 1. Dashboard 2. Nut (5mm) 3. Spring washer 4. Screw
Inhaltszusammenfassung zur Seite Nr. 5
Removing the unit a. Frame b. Insert fingers into the groove in the front of frame and pull out to remove the frame. (When reattaching the frame, point the side with a groove down wards and attach it.) c. Insert the levers supplied with the unit into the grooves at both sides of the unit as shown in figure until they click. Pulling the levers makes it possible to remove the unit from the dashboard. Din rear-mount (method 2) Installation using the screw holes at both sides of the unit. 1. Select
Inhaltszusammenfassung zur Seite Nr. 6
Detachable control panel Detaching the control panel · Turn the Power off. · Press the Panel release button. · Remove the control panel. Attaching the control panel · Insert the right side of the control panel into the main unit. Note: the control panel must be attached into the T-Joint. · Press the control panel on to the left side of middle of it until a click sound is heard. Caution: DO NOT insert the control panel from the left side. It can damage the control panel. The control panel can eas
Inhaltszusammenfassung zur Seite Nr. 7
Electrical connections 7
Inhaltszusammenfassung zur Seite Nr. 8
8
Inhaltszusammenfassung zur Seite Nr. 9
Panel controls 1. Panel release button 2. DSP (preset equalizer) button 3. Power button 4. Volume level control 5. Tuning seek up, down/ Track up, down buttons 6. LCD display 7. Scan button 8. DISP button 9. AF (Alternative Frequencies) button 10. Open button 11. Mode button 12. Menu button/ MP3 enter button 13. AMS (Auto Memory Store) button/ MP3 search button 14. Play/ Pause button 15. Intro play 16. Track repeat play 17. Track random play 18. Track 10 down 19. Track +10 up 20. Preset memory s
Inhaltszusammenfassung zur Seite Nr. 10
General operations Power button [3] Press Power button to turn on/ off the unit. Encoder volume knob [4] When the Menu function is not activated, rotate this knob to change the volume level. When Menu function is activated, rotate this knob to navigate through different menu items. Mode button [11] · Press this button to select different mode, sequence as follow: - Tuner mode (radio) - CDP/ MP3 (only if a CD or MP3 disc is inserted) - USB (only if a USB drive is inserted) - SD/ MMC (only if a SD
Inhaltszusammenfassung zur Seite Nr. 11
VOLUME (VOL) > BASS (BAS) > TREBLE (TRE) > BALANCE (BAL) > FADER (FAD). · Rotate Volume control to adjust desired level within 5 seconds. Note: bass and treble will be skipped if DSP mode is activated. 2. Other operations · Press Menu button for more than 2 seconds to open another set of menu. · Press Menu button repeatedly to navigate through the menu items, while the desired menu item is displayed. · Use Volume control to adjust the selected function: a. TA (Traffic Announcement) mode To deter
Inhaltszusammenfassung zur Seite Nr. 12
- MASK ALL To mask both PI and strong signal non-RDS station. c. Retune L, retune S To determine the initial time of automatic TA (Traffic Announcement) search. There are 2 modes: RETUNE L and RETUNE L. - RETUNE L:180 seconds. - RETUNE S: 45 seconds. d. Loud mode Use this mode to increase bass output. e. ESP mode (Electronic Shock Protection) You can select the second of ESP as follow: - ESP 12 second: for normal road condition. - ESP 45 second: for road condition extremely unusual. f. Beep mode
Inhaltszusammenfassung zur Seite Nr. 13
Press and hold the Tuning up/ down button to seek the band in up or down direction and stop when a station is received. - SEEK2: Press the Tuning up/ down button briefly to increase or decrease the frequency by 1 step size. Press and hold the Tuning up/ down button increase or decrease the frequency rapidly until the button is released, the different between the same operation at Seek 1 mode is that this time the radio will not stop at any station. h. Stereo mode Use this mode to select stereo o
Inhaltszusammenfassung zur Seite Nr. 14
Tuning up/ down button [5] Press this button to search for radio stations. Depends on whether SEEK1 or SEEK 2 mode is selected, different operations can be performed, refer to Seek mode paragraph for detail. Reset button In case of abnormal operation, use a pencil tip or other non-metallic object to press the Reset button located behind the front panel. Reset button is to be activated for the following reasons: - Initial installation of the unit when all wiring is completed. - All the control fu
Inhaltszusammenfassung zur Seite Nr. 15
Station preset buttons (1-6) [20] You can store and recall six preset radio stations by pressing 1-6 buttons. · To store a station: - Select a band (if needed) - Select a station by Tuning up/ down button - Hold a Preset button which you want store the station for at least 2 seconds. The preset number will appear on the display accompanied by a beeps sound. · To recall a station: - Select a band (if needed) - Press a Preset button briefly to recall the stored station. Band button [23] Press this
Inhaltszusammenfassung zur Seite Nr. 16
current program. When region mode is on, the radio will only switch to a program carrying the exact same PI code. Note: When AF switch is on, at this moment use tuning up/ down to search station will only stop at station which has RDS broadcasting. TA button (Traffic Announcement) [24] - When pressed short, it is activated as TA mode on or off. - When TA mode is on and traffic announcement is transmitted. - When the unit is in CD mode, it will switch to radio mode temporarily. - If the volume le
Inhaltszusammenfassung zur Seite Nr. 17
MP3 playback Notes on MP3 · MP3 is short for MPEG Audio Layer 3 and refers to an audio compression technology standard. · This product allows playback of MP3 files on CD-ROM, CD-R or CD-RW discs. · The unit can read MP3 files written in the format compliant with ISO 9660. However it does not support the MP3 data written by the method of packet write. · The unit can not read an MP3 file that has a file extension other than .mp3 . · If you play a non- MP3 file that has the .mp3 extension, you ma
Inhaltszusammenfassung zur Seite Nr. 18
· With some CD-R or CD-RW media, data may not be properly written depending on their manufacturing quality. In this case, data may not be reproduced correctly. High quality CD-R or CD-RW disc is recommended. · Up to 16 characters are displayed for the name of an Album or a Track. ID3TAG version 1.x and 2.x is required. Note: the unit may not play tracks in the order that you wrote them to the disc. Loading the CD Press the Open [10] to fold down the front panel, insert the disc through CD slot.
Inhaltszusammenfassung zur Seite Nr. 19
Random play button [17] When random play mode is selected, the tracks will be played in random order, press this key one more time to cancel random play mode. Track up and track down buttons [18, 19] Under normal play mode, press the Track up button for less than 1 second to skip the playback to the next track, or press the Track down button for less than 0.5 seconds to return to the beginning of the current track, press this button one more time to skip to the previous track. When any of these
Inhaltszusammenfassung zur Seite Nr. 20
After selecting the desired track number, press Enter button for more than 1 second to confirm, playback will start. - Digit and 3-Digit track number Enter the left-most digit first (for example, if the track number is 123, enter first, following by and ), then press Enter button for less than 1 second to shift the number by one digit, repeat this procedure until all digits has been entered. Long press Enter button for more than 1 seconds to start playing. If a wrong track number is entered, p
