Inhaltszusammenfassung zur Seite Nr. 1
XDM260
INSTALLATION/OWNER'S MANUAL
AM/FM/CD Receiver with Detachable Face
Inhaltszusammenfassung zur Seite Nr. 2
XDM260 INSTALLATION Preparation Please read entire manual before installation. Before You Start • Disconnect negative battery terminal. Consult a qualified technician for instructions. • Avoid installing the unit where it would be subject to high temperatures, such as from direct sunlight, or where it would be subject to dust, dirt or excessive vibration. Getting Started • Remove trim ring from unit. • Remove 2 transit screws located on top of the unit. • Insert the supplied keys into the s
Inhaltszusammenfassung zur Seite Nr. 3
XDM260 INSTALLATION Wiring Diagram Rear Preamp Output Antenna Connector Connect to amplifier RCA input L-CH R-CH RCA Cable (sold separately) BLUE Remote Turn-On Connect to amplifier or power AMP antenna. Insulate wire if not used. BLACK Ground Connect to vehicle chassis ground. RED Accessory Connect to ignition circuit or switched 12 volt source. 5 AMP AGC Fuse YELLOW Memory Connect to battery circuit or constant 12 volt source. FUSE Right Front Right Rear Violet/Black (-) When replacing the
Inhaltszusammenfassung zur Seite Nr. 4
XDM260 OPERATION Control Locations - Receiver 1 2 3 4 5 6 19 18 17 16 15 14 13 12 11 10 9 8 7 1 Release 11 Preset 3 / Intro 2 Band / Go Back 12 Preset 2 / Random 3 Volume Knob 13 Preset 1 / Repeat 4 Power 14 Display 5 Eject 15 Tune / Track Up 6 USB Port 16 Tune / Track Down 7 Auxiliary Input 17 Mode 8 Preset 6 / Folder Up 18 Audio / Menu 9 Preset 5 / Folder Down 19 Mute 10 Preset 4 / Play / Pause 4
Inhaltszusammenfassung zur Seite Nr. 5
XDM260 INSTALLATION General Operation Press RELEASE and pull away from the left side to remove. Faceplate Removal To re-install, insert right side of faceplate first then push left side to secure. Press or any other button (except EJECT) to turn the unit Power On/Off on. Press to turn the unit off. Press MODE to select between AM/FM, CD player, auxiliary, Mode USB. Modes of operation are shown in the display. NOTE: CD and USB modes will not appear unless a CD is inserted or USB devic
Inhaltszusammenfassung zur Seite Nr. 6
XDM260 OPERATION General Operation - Setup Menu Menu Function Options Action Auto Station Press SELECT to seek and save 6 strong stations in the AUTO STORE Store current band. (Tuner mode only) LOCAL OFF Activates distance tuning (Tuner mode only). Local/Distance Activates local tuning for strong station reception only (Tuner Tuning LOCAL ON mode only). Programs the unit to USA tuner spacing. FREQ USA Tuner (200kHz for FM and 10kHz for AM). (Tuner mode only) Frequency Programs the unit to Eu
Inhaltszusammenfassung zur Seite Nr. 7
XDM260 INSTALLATION General Operation Audio Press AUDIO/MENU momentarily to select between Bass, Treble, Balance and Fader. BASS TREBLE BALANCEE FADER SOURCE LEVEL LOUDNESS EQ Bass Press AUDIO/MENU until BASS appears then rotate volume knob left/right to adjust ( -6 minimum / +6 maximum). Treble Press AUDIO/MENU until TREBLE appears then rotate volume knob left/right to adjust ( -6 minimum / +6 maximum). B
Inhaltszusammenfassung zur Seite Nr. 8
XDM260 OPERATION AM/FM Tuner Operation Seek Tuning Press TUNE or TUNE momentarily to seek to the nn ll next strong station. Manual Tuning Press and hold TUNE or TUNE until "MANUAL" nn ll appears, then press TUNE or TUNE momentarily nn ll to change radio frequency up or down one step at a time. Press and hold to advance quickly. Band Press BAND to select between FM1, FM2, FM3, AM1 and AM2 bands. Storing and Recalling Up to 18 FM stations and 12 AM stations can be stored. To Station P
Inhaltszusammenfassung zur Seite Nr. 9
XDM260 INSTALLATION CD Player Operation Insert CD With the label facing up, insert a standard size CD into the CD slot. The CD will automatically begin playback. Eject CD Press EJECT to eject the CD. The unit will change to previous mode of operation. If the disc is not removed within 10 seconds, the unit will reload the disc. The unit does not have to be turned on to eject CD. Track Select Press TRACK to skip to the beginning of the next ll track. Press TRACK to return to the beginning of
Inhaltszusammenfassung zur Seite Nr. 10
XDM260 OPERATION CD Player Operation - MP3/WMA Files Playing an MP3/WMA CD When an MP3/WMA encoded disc is first inserted, “LEAD" will appear in the display. Depending on the number of files and folders, this may take several seconds. Displaying Information ID3 tag and file/folder information will be automatically changed during playback. Press DISP to view the clock. Default display will resume after five seconds. Character Support Maximum character display information • Track name – 64 cha
Inhaltszusammenfassung zur Seite Nr. 11
XDM260 INSTALLATION CD Player Operation - MP3/WMA Files Media Compatibility The following types of discs/files are compatible: • CD-ROM (ISO), CD-R, CD-RW • CD-DA • MP3 data • WMA data The following types of discs/files are not compatible: • WMA files that are protected by DRM (Digital Rights Management). • WMA lossless format • Discs recorded with Track At Once or packet writing • MP3 PRO format • MP3 playlists • WAV format Playback Order MP3/WMA playback sequence is based on recorded ord
Inhaltszusammenfassung zur Seite Nr. 12
XDM260 OPERATION CD Player Operation - MP3/WMA Files Additional MP3/WMA When playing a disc recorded with regular audio files Information (CD-DA or .WAV) and MP3/WMA files, the unit will play the MP3/WMA files only. Only MP3 files with filename extension (.mp3) can be played. Only WMA files with filename extension (.wma) can be played. Do not attempt to play discs which contain non-MP3/WMA files with the MP3/WMA extension. Sampling Frequency Rates MP3 8kHz ~ 48kHz WMA 8kHz ~ 48kHz Transf
Inhaltszusammenfassung zur Seite Nr. 13
XDM260 INSTALLATION USB Operation Connecting a USB Device To play MP3/WMA files from most USB mass storage (sold separately) devices, line up the USB connector and insert the USB device into the XDM260's USB port. Playing Music When a USB device is first connected, “LEAD” will appear in the display and playback will begin momentarily. Depending on the number of files and folders, it may take several seconds for the device to begin playing. If no valid MP3/ WMA files are detected, “NO FILE”
Inhaltszusammenfassung zur Seite Nr. 14
XDM260 OPERATION USB Operation Character Support Maximum character display information • Track name – 64 character maximum • Directory name – 64 character maximum • *Song title – 64 character maximum • *Artist name – 64 character maximum • *Album name – 64 character maximum *Song title, artist name and album name will only be displayed if included with the MP3/WMA file. Media Compatibility The following types of files are compatible: • MP3 data • WMA data The following types of files are not
Inhaltszusammenfassung zur Seite Nr. 15
XDM260 INSTALLATION USB Operation Additional MP3/WMA Only MP3 files with filename extension (.mp3) can be played. Information Only WMA files with filename extension (.wma) can be played. Do not attempt to play non-MP3/WMA files with the MP3/WMA extension. Sampling Frequency Rates MP3 8kHz ~ 48kHz WMA 8kHz ~ 48kHz Transfer Bit rates MP3 8kbps ~ 320kbps constant Variable bit rates WMA 8kbps ~ 384kbps constant Variable bit rates Note: Some files may not play or be displayed correctly, dependin
Inhaltszusammenfassung zur Seite Nr. 16
XDM260 OPERATION Troubleshooting Problem Cause Action Yellow wire not connected or incorrect Check connections for proper voltage Red wire not connected or Unit will not turn on voltage (11~16VDC) incorrect voltage (no power) Black wire not connected Check connection to ground Fuse blown Replace fuse Speaker wires not connected Check connections at speakers Unit has power Insulate all bare speaker wires One or more speaker wires touching (but no sound) from each other and chassis each
Inhaltszusammenfassung zur Seite Nr. 17
XDM260 INSTALLATION Limited One Year Warranty This warranty gives you specific legal What to do? rights. You may also have other rights 1. Before you call for service, check the which vary from state to state. troubleshooting guide in your owner’s manual. A slight adjustment of any Dual Electronics Corp. warrants this custom controls may save you a service product to the original purchaser to be free call. from defects in material and workmanship for a period of one year from the date of
Inhaltszusammenfassung zur Seite Nr. 18
XDM260 OPERATION FCC Compliance This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. Note: This equipm
Inhaltszusammenfassung zur Seite Nr. 19
XDM260 INSTALLATION Specifications CD Player Frequency response: 20Hz-20kHz Channel separation @ 1kHz: >60dB D/A converter: 1 Bit FM Tuner Tuning range: 87.5MHz-107.9MHz Usable sensitivity: 8.5dBf 50dB quieting sensitivity: 10dBf Stereo separation @ 1kHz: >30dB Frequency response: 30Hz-13kHz AM Tuner Tuning range: 530kHz-1710kHz Usable sensitivity: <42dBu Frequency response: 30Hz-2.2kHz General Speaker output impedance: 4~8 ohms Line output voltage: 2 Volts RMS Dimensions: 7" x 7"
Inhaltszusammenfassung zur Seite Nr. 20
Dual Electronics Corp. Toll Free: 1-866-382-5476 9AM-5PM EST, Monday-Friday www.dualav.com ©2013 Dual Electronics Corp. All rights reserved. Other trademarks and trade names are those of their respective owners. NSA0813-V03
