Inhaltszusammenfassung zur Seite Nr. 1
Installation instructions
and User guide
Slideout rangehood
HS60CSRX2, HS60CSRW2, HS90CSX2, HS60CSW2,
HS60CSX2, HS60CIW2, HS60CIX2 models
NZ AU
Inhaltszusammenfassung zur Seite Nr. 2
Contents Safety and warnings 1 Installation instructions 2 Getting started quickly 6 Cleaning and maintenance 7 Manufacturer’s Warranty 8 Customer Care 9 Important! SAVE THESE INSTRUCTIONS The models shown in this User Guide may not be available in all markets and are subject to change at any time. For current details about model and specification availability in your country, please visit our local website listed on the back cover or contact your local Fisher & Paykel dealer.
Inhaltszusammenfassung zur Seite Nr. 3
1 Safety and warnings Important! Please read the entire set of instructions before installing the rangehood. This rangehood is not intended for use by young children or infirm persons without supervision. Young children should be supervised to ensure that they do not play with the rangehood. There must be adequate ventilation of the room when the rangehood is used at the same time as appliances burning gas or other fuels. (A partial vacuum in the room could result in too high a concent
Inhaltszusammenfassung zur Seite Nr. 4
2 Installation instructions Thank you for purchasing a quality Fisher & Paykel rangehood. Each rangehood is tested and approved before it leaves the factory, ensuring our high standard of quality control is met. Contents of packaging 1 x rangehood 1 x installation instructions 1 x Installation kit - “SIDE FIXING” 1 x Installation kit - “TOP FIXING” 4 x Spacer Tube 25.4 mm 4 x Screw 8x1.5” 4 x Screw 8x1” Typical equipment required: Electric drill Screwdriver Duct tape (if
Inhaltszusammenfassung zur Seite Nr. 5
3 Installation instructions Height of rangehood Please read the entire instructions BEFORE installing the rangehood. Ascertain the desired installation height of the rangehood. When installing the rangehood, the lower edge of the unit must be a minimum of 600 mm (650 mm for gas cooker) above the cooking surface. The recommended position for the hood is 650 mm above the cooktop. Any installation above 750 mm will compromise the Not less than 650 mm extraction performance. Gas Burner A
Inhaltszusammenfassung zur Seite Nr. 6
4 Installation instructions Preparing the rangehood for installation Ensure the overhead cabinets are built according to Fig.5 (below). Before drilling any holes, check that the area behind the surface to be drilled is clear of any electrical cables or pipes etc. Recirculated installation Knockouts (remove for ducted only) If the rangehood is to be installed as a recirculated hood, first ensure the cabinets are built according to Fig. 5 below: 1 Do not remove the knockouts shown in Fig.4.
Inhaltszusammenfassung zur Seite Nr. 7
5 Installation instructions Mounting to cabinetry sides See Installation sheet provided. When mounting to the cabinetry sides, please ensure the correct dowels and screws are used. These can be found in the bag labelled “SIDE FIXING”. Note: using the incorrect screws for the side-fixed mounting method may cause damage to the product. Fix rangehood to your wall units, with 2 screws in each side into the vertical panels. To do this: 1 Slide out the drawer and remove filter. You will see two m
Inhaltszusammenfassung zur Seite Nr. 8
6 Getting started quickly Control panel features Fig.9 Slider Controls Light switch: the light can be operated independently from the fan. Fan switch: the fan can be run at different speeds depending on the cooking requirements.
Inhaltszusammenfassung zur Seite Nr. 9
7 Cleaning and maintenance Caution! Never use abrasive or oil based liquid cleaners. General maintenance The manufacturer is not liable for any damage caused by not following these instructions. The rangehood should be cleaned regularly using warm water with soap or mild liquid detergents. This ensures that no build-up of grease occurs as these deposits are corrosive. Do not use abrasives or harsh detergents/cleaning fluids. Note: in areas of high humidity and coastal environments cleaning
Inhaltszusammenfassung zur Seite Nr. 10
8 Manufacturer’s Warranty You automatically receive a 2 year Manufacturer’s Warranty with the purchase of this Product covering parts and labour for servicing within the country of purchase. Fisher & Paykel undertakes to: Repair or, at its option, replace without cost to the owner either for material or labour any part of the Product, the serial number of which appears on the Product, which is found to be defective within TWO YEARS of the date of purchase. This Warranty DOES NOT cover A Service
Inhaltszusammenfassung zur Seite Nr. 11
9 Customer Care Before you call for service or assistance… Check the things you can do yourself. Refer to your User Guide and check: 1 Your appliance is correctly installed. 2 You are familiar with its normal operation. If after checking these points you still need assistance, please refer to your nearest Fisher & Paykel Authorised Repairer, or contact us through our local website listed on the back cover. In New Zealand if you need assistance...* Call your Fisher & Paykel retailer who is t
Inhaltszusammenfassung zur Seite Nr. 12
Copyright © Fisher & Paykel 2009. All rights reserved. The product specifications in this booklet apply to the specific products and models described at the date of issue. Under our policy of continuous product improvement, these specifications may change at any time. You should therefore check with your Customer Care Centre to ensure this booklet correctly describes the product currently available. www.fisherpaykel.co.nz www.fp.com.au NZ AU Slideout rangehood Installation instructions
