Inhaltszusammenfassung zur Seite Nr. 1
I:\3207456121PCS1WW\01COV.FM masterpage:Sinistra
3-207-456-12 (1)
Video
Communication
System
Operating Instructions
Before operating the unit, please read this manual thoroughly and retain it for
future reference.
PCS-1/1P
© 2003 Sony Corporation
PCS-1/1P
3-207-456-12 (1)
Inhaltszusammenfassung zur Seite Nr. 2
I:\3207456121PCS1WW\02REG.FM masterpage:Left Operation is subject to the following two conditions: (1) This device may not cause Owner’s Record harmful interference, and (2) this device must accept any interference received, The model and the serial numbers are including interference that may cause located at the bottom. Record the serial undesired operation. number in the space provided below. Refer to these numbers whenever you call upon This equipment has been tested and found to your
Inhaltszusammenfassung zur Seite Nr. 3
I:\3207456121PCS1WW\02REG.FM masterpage:Left Gooi de batterij niet weg maar lever deze in als klein chemisch afval (KCA). Lever het apparaat aan het einde van de levensduur in voor recycling, de batterij zal dan op correcte wijze verwerkt worden. If you dispose the unit, consult your nearest Sony Service Center. The built-in battery must be treated as a chemical waste. For the customers in Canada This Class A digital apparatus complies with Canadian ICES-003. 3 PCS-1-1P 3-207-456-12 (1)
Inhaltszusammenfassung zur Seite Nr. 4
I:\3207456121PCS1WW\01COVTOC.FM masterpage:Left Table of Contents Turning Off .................................26 Chapter 1: Installation and Adjusting the Volume on the TV Preparation Monitor ............................26 Displaying the Help ....................27 Using This Manual ............................. 8 Displaying the Versions and Features ..............................................9 Options ............................27 System Components ........................ 10 Setting Up
Inhaltszusammenfassung zur Seite Nr. 5
I:\3207456121PCS1WW\01COVTOC.FM masterpage:Left Registering a New Remote Party 52 Selecting the Input Picture and Sound ............................................... 81 Changing the Contents of the Phone Book ................................54 Switching the Displayed Picture Between the Local and Deleting the Registered Remote Remote Pictures .............. 81 Party ................................55 Selecting the Input Picture ......... 81 Copying the Setting of the Phone Book Menu ....
Inhaltszusammenfassung zur Seite Nr. 6
I:\3207456121PCS1WW\01COVTOC.FM masterpage:Left Saving Still Images Using the Still Operating the System During a Image Menu .................... 97 Conference .....................119 Saving Still Images Using the Displaying the Picture on a Projector or Memory Stick Menu ....... 98 Monitor ...........................................123 Saving Still Images Using the Outputting the Signal to One Communication Monitor ..........................123 Submenu .........................99 Outputti
Inhaltszusammenfassung zur Seite Nr. 7
I:\3207456121PCS1WW\01COVTOC.FM masterpage:Left What is “Broadcast Mode”? .....143 PCS-DSB1 Data Solution Box (Optional) .....................172 Broadcast Modes and Displayed Windows .......................145 PCS-320M1 H.320 MCU Software (Optional) .....................172 Switching the Broadcast Mode .146 PCS-323M1 H.323 MCU Software Receiving the Broadcast Requested (Optional) .....................172 From Any Other Terminal ........................147 Acceptable RGB Input/Output Sign
Inhaltszusammenfassung zur Seite Nr. 8
Chapter 6: Videoconference Using a Whiteboard Chapter 1: This chapter shows how to use a whiteboard with the mimio Xi* attached for a videoconference. Installation and ® * mimio is a registered trademark of Virtual Ink Corporation of the United States. Preparation minio Xi is a trademark of Virtual Ink Corporation of the United States. Chapter 7: Multipoint Videoconference Using This Manual This chapter shows you how to use the Video Communication System to hold a multipoint videoconfe
Inhaltszusammenfassung zur Seite Nr. 9
Chapter 1: Installation and Preparation I:\3207456121PCS1WW\03OVR.FM masterpage:Left Wide range of video/audio Features compression format selectable The Video Communication System supports MPEG4, H.263+, H.263 and H.261 for The PCS-1/1P Video Communication video compression format, and MPEG4 System is a videoconferencing system that Audio, G.722.1, G.722, G.729, G.728, provides natural, face-to-face G.723.1, G.711 for audio compression communications with a remote party by format. Yo
Inhaltszusammenfassung zur Seite Nr. 10
I:\3207456121PCS1WW\03OVR.FM masterpage:Left System Components The PCS-1/1P Video Communication System is composed of basic system components for a basic videoconference, and optional equipment for an enhanced videoconference. Basic System Components The PCS-1/1P Video Communication System is the basic system of the PCS- 1/1P Videoconferencing System. It contains the following components: Unit Description PCS-P1/P1P Communication Contains the video codec, audio codec, echo Terminal canceler,
Inhaltszusammenfassung zur Seite Nr. 11
Chapter 1: Installation and Preparation I:\3207456121PCS1WW\03OVR.FM masterpage:Left Optional Equipment TV monitor A TV or projector, etc. is required to monitor the images for videoconferencing system. Unit Description TV, Projector, etc. Used as a monitor and speakers. Optional equipment especially designed for use with the PCS-1/1P The following optional devices are used to enhance your videoconference. Unit Description PCS-B768 ISDN Unit Used to connect to an ISDN line. Up to six ISDN line
Inhaltszusammenfassung zur Seite Nr. 12
I:\3207456121PCS1WW\03OVR.FM masterpage:Left Unit Description PCS-DS150/DS150P Allows transmission of pictures to the Document Stand Communication Terminal by infrared signals without connecting a cable. PCS-323M1 H.323 MCU Allows use for a multipoint videoconference over Software LAN connection. PCS-320M1 H.320 MCU Allows use for a multipoint videoconference over Software ISDN connection. Connecting cables Use the following connecting cables to connect devices in this system. PCS-1/1P Video
Inhaltszusammenfassung zur Seite Nr. 13
Chapter 1: Installation and Preparation I:\3207456121PCS1WW\03OVR.FM masterpage:Left System Configuration The PCS-1/1P Video Communication System has various system configuration capabilities using the basic components and optional equipment. This section describes six typical examples. System Configuration via a LAN This allows you: To hold a point-to-point videoconference over LAN. To show still images stored in a “Memory Stick”. System configuration 1 PCS-P1/P1P Communication Terminal 2
Inhaltszusammenfassung zur Seite Nr. 14
I:\3207456121PCS1WW\03OVR.FM masterpage:Left System Configuration via an ISDN Connection to ISDN is required to use the PCS-B768 ISDN Unit especially designed for use with this system. This allows you: To hold a point-to-point videoconference over ISDN. To show still images stored in a “Memory Stick”. To hold a videoconference with high speeds and highest quality image transmission by connecting up to six ISDN lines. System configuration 1 PCS-P1/P1P Communication Terminal 2 PCS-C1/C1P C
Inhaltszusammenfassung zur Seite Nr. 15
Chapter 1: Installation and Preparation I:\3207456121PCS1WW\03OVR.FM masterpage:Left System Configuration via a LAN for Multipoint Conference You need to install the optional PCS-323M1 H.323 MCU software. This allows you: To hold a multipoint videoconference among up to ten sites over LAN. To show still images stored in a “Memory Stick”. To show the still images on the second TV monitor or projector. To pick up a large number of participants’ voices using up to two external microphones.
Inhaltszusammenfassung zur Seite Nr. 16
I:\3207456121PCS1WW\03OVR.FM masterpage:Left System Configuration via an ISDN for Multipoint Conference You need to connect the optional PCS-B768 ISDN Unit especially designed for use with this System and to install the optional PCS-320M1 H.320 MCU software. This allows you: To hold a multipoint videoconference among up to six sites over ISDN. To show still images stored in a “Memory Stick”. To show the still images on the second TV monitor or projector. To pick up a large number of p
Inhaltszusammenfassung zur Seite Nr. 17
Chapter 1: Installation and Preparation I:\3207456121PCS1WW\03OVR.FM masterpage:Left System Configuration via a LAN for Multipoint Data Conference You need to connect the optional PCS-DSB1 Data Solution Box especially designed to use with this System and to install the optional PCS-323M1 H.323 MCU software. This allows you: To hold a multipoint videoconference among up to ten sites over LAN. To show still images stored in a “Memory Stick”. To use the data from a computer or external equi
Inhaltszusammenfassung zur Seite Nr. 18
I:\3207456121PCS1WW\03OVR.FM masterpage:Left System Configuration via an ISDN for Multipoint Data Conference You need to connect the optional PCS-B768 ISDN Unit and the PCS-DSB1 Data Solution Box especially designed for use with this System and to install the optional PCS-320M1 H.320 MCU software. This allows you: To hold a multipoint videoconference among up to six sites over ISDN. To show still images stored in a “Memory Stick”. To use the data from a computer or an external equipment.
Inhaltszusammenfassung zur Seite Nr. 19
Chapter 1: Installation and Preparation I:\3207456121PCS1WW\03OVR.FM masterpage:Left System Connections This section describes the typical system connections. Notes Be sure to turn off all the equipment before making any connections. Do not connect/disconnect the camera cable with the power on. Doing so may damage the Camera Unit or Communication Terminal. For safety, do not connect the 100BASE-TX/10BASE-T connector to a network that applies an excess voltage via the 100BASE-TX/10BASE-T
Inhaltszusammenfassung zur Seite Nr. 20
I:\3207456121PCS1WW\03OVR.FM masterpage:Left System Connection via an ISDN Notes Do not connect/disconnect the camera cable or the interface cable with the power on. Doing so may damage the Camera Unit, Communication Terminal or ISDN Unit. Used with the PCS-B768 ISDN Unit for the first time, the Communication Terminal may automatically upgrade the software of the ISDN Unit. While the upgrading message is displayed on the monitor screen, be sure not to turn off the Communication Terminal.
