Inhaltszusammenfassung zur Seite Nr. 1
Inhaltszusammenfassung zur Seite Nr. 2
Introduction READ THIS BEFORE OPERATING YOUR UNIT This symbol is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. : TO REDUCE THE RISK OF ELECTRIC CAUTION This symbol is intended to alert the user to the SHOCK, DO NOT REMOVE COVER (OR presence of important operating and maintenance BACK). NO USER-SERVICEABLE PARTS (servicing) instructions in the lite
Inhaltszusammenfassung zur Seite Nr. 3
SAFETY INSTRUCTIONS 1. Read Instructions - All the safety and operating instructions should connection to grounding electrodes, and requirements for the be read before the product is operated. grounding electrode. See Figure 1. 2. Retain instructions - The safety and operating instructions should Figure 1 be retained for future reference. Example of antenna grounding as per 3. Heed Warnings - All warnings on the product and in the operating National Electrical Code, ANSI/NFPA 70 ANTENNA LEAD IN
Inhaltszusammenfassung zur Seite Nr. 4
CONTENTS Introduction READ THIS BEFORE OPERATING YOUR UNIT................................................................................... 2 SAFETY INSTRUCTIONS ......................................................................................................................... 3 System Connections ....................................................................................................................................... 5 Front Panel & Remote Controls .........................
Inhaltszusammenfassung zur Seite Nr. 5
System Connections • Do not plug the AC input cord into the wall AC outlet until all connections are completed. • Be sure to connect the white RCA pin cords to the L(left) and the red RCA pin cords to the R(right) jacks when making audio connections. • Change the position of the FM indoor antenna until you get the best reception of your favorite FM stations. • A 75 Ω outdoor FM antenna may be used to further improve the reception. Disconnect the indoor antenna before replacing it with the outdoo
Inhaltszusammenfassung zur Seite Nr. 6
DIGI- LINK R L A B R L 6
Inhaltszusammenfassung zur Seite Nr. 7
Front Panel & Remote Controls DA S DISCRETE AMPLIFIER STAGE ST TUNED PRESET MEM REMOTE SENSOR KHz MHz SLEEP AB DIGI LINK III System Remote Controls POWER ON STANDBY DIMMER DIMMER SLEEP SPEAKER POWER ON POWER ON STANDBY AB CD TAPE AUX PHONO • You can remotely control not only this receiver but DIMMER DIMMER SLEEP SLEEP SPEAKER SPEAKER also Sherwood compatible components bearing the A B REPEAT TUNER DIGI LINK II or III logo. A/B CD CD TAPE APE AUX AUX PHONO PHONO INTRO • For sy
Inhaltszusammenfassung zur Seite Nr. 8
POWER BUTTON TUNING/PRESET MODE BUTTON In the standby mode, press this button, then this unit is Press this button to select the tuning mode or the preset turned on to enter the operating mode. mode. STANDBY BUTTON NUMERIC BUTTONS(0 ~ 9) In the operating mode, press this button or the POWER Press these buttons to select or to store preset stations button on the front panel, then this unit is turned off to directly. enter the standby mode. TUNING/PRESET UP/DOWN( STANDBY INDICATOR BUTTONS Press th
Inhaltszusammenfassung zur Seite Nr. 9
TAPE DECK SECTION REMOTE SENSOR DECK SELECTOR A, B- for selecting deck A or B This receives the signals from the remote control unit. , - to begin reverse or forward side playback. FLUORESCENT DISPLAY , - to wind up the tape reversely or forwardly. - for recording. - to stop playback or recording. FLUORESCENT DISPLAY MEMORY INDICATOR STEREO INDICATOR TUNED INDICATOR ST TUNED PRESET MEM KHz MHz SLEEP PRESET NUMBER, SLEEP TIME DISPLAY INPUT, FREQUENCY, VOLUME LEVEL, OPERATING INFORMATION, etc. REM
Inhaltszusammenfassung zur Seite Nr. 10
Operations LISTENING TO A PROGRAM SOURCE Turn the power on. 1 • Then this unit is turned on to enter the STANDBY operating mode. POWER ON POWER ON ST STANDBY ANDBY POWER ON STNADBY • In the operating mode, when the POWER SPEAKER DIMMER SLEEP A B button on the front panel or the AUX CD TAPE PHONO or STANDBY button on the remote control is REPEAT TUNER A/B A/B pressed, the unit is turned off to enter the CD INTRO standby mode. A • In the standby mode, the STANDBY ON/STANDBY DECK SEL. DECK SEL. T
Inhaltszusammenfassung zur Seite Nr. 11
POWER ON STANDBY SLEEP SPEAKER DIMMER AB CD TAPE VIDEO TV/AUX REPEAT TUNER A/B To mute the sound. To listen with the headphones. INTRO A DECK SEL. PHONES 6 7 B TREBLE TREBLE BASS BASS + + T/P T/P MUTE MUTE MUTE VOL. VOL. TUNE TUNE TUNE TUNE MEMO MEMO + FM MODE FM MODE P.SCAN P.SCAN VOL. VOL. “MUTE” lights up and flickers. To resume the previous sound level, press this button Be sure to switch off both A and B speakers. POWER ON STANDBY again. 12 3 4 5 SPEAKER DIMMER SLEEP AB CD TAPE VIDEO TV/AUX
Inhaltszusammenfassung zur Seite Nr. 12
LISTENING TO RADIO BROADCASTS Auto tuning Select the tuner and then the desired band. POWER ON ST STANDBY ANDBY 1 MHz DIMMER DIMMER SLEEP SLEEP SPEAKER SPEAKER A B FM/AM CD CD TAPE APE AUX AUX PHONO PHONO REPEA REPEAT TUNER TUNER TUNER BAND FREQUENCY A/B A/B CD INTRO INTRO or • Each time this button is pressed, the band is changed A DECK SEL. DECK SEL. TAPE to FM or AM. B POWER ON STANDBY TREBLE BASS POWER ON STANDBY SPEAKER DIMMER SLEEP AB T/P MUTE CD TAPE VIDEO TV/AUX SPEAKER DIMMER SLEEP VOL.
Inhaltszusammenfassung zur Seite Nr. 13
Select the desired preset number (1~30) Repeat the above steps 1 to 3 to memorize and press the MEMORY button. other stations. 3 4 T/P T/P TUNE TUNE TUNE TUNE MEMO + MEMORY TREBLE TREBLE + BASS BASS + or MUTE MUTE VOL. VOL. TUNE TUNE TUNE TUNE MEMO MEMO + FM MODE FM MODE P.SCAN P.SCAN VOL. VOL. MEMORY BACKUP FUNCTION • When using the NUMERIC buttons on the remote control. The following items, set before the receiver is turned 3 Examples) For “3” : off, are memorized. within 2 seconds • I
Inhaltszusammenfassung zur Seite Nr. 14
POWER ON STANDBY SPEAKER DIMMER SLEEP AB CD TAPE AUX PHONO REPEAT TUNER A/B INTRO A DECK SEL. B TREBLE BASS T/P MUTE VOL. RECORDING TUNE MEMO TUNE FM MODE P.SCAN VOL. The volume, tone(bass, treble) and balance settings have no effect on the recording signals. 12 3 4 5 67 8 9 0 When you select tuner, CD or PHONO as a recording source, recording may be made on TAPE or AUX, or both REMOTE CONTROL RM-110 simultaneously. Recording with TAPE Recording with AUX Select the desired input as a recording S
Inhaltszusammenfassung zur Seite Nr. 15
Troubleshooting Guide If a fault occurs, run through the table below before taking your receiver for repair. If the fault persists, attempt to solve it by switching the receiver off and on again. If this fails to resolve the situation, consult with your dealer. Under no circumstances should you repair the receiver yourself as this could invalidate the warranty. PROBLEM POSSIBLE CAUSE REMEDY No power • The AC input cord is disconnected. • Connect the cord securely. • Check the outlet using a lam
Inhaltszusammenfassung zur Seite Nr. 16
Specifications AMPLIFIER SECTION Power output, stereo mode, 8 Ω, THD 0.08 %, 20 Hz~20 kHz ................................................................................ 2X100 W Total harmonic distortion, 8 Ω, 100 W, 20 Hz~20 kHz ................................................................................................ 0.04 % Intermodulation distortion 60 Hz : 7 kHz= 4 : 1 SMPTE, 8 Ω, 100 W ...................................................................................................
Inhaltszusammenfassung zur Seite Nr. 17
