Bedienungsanleitung Kicker KS25

Inhaltszusammenfassung zur Seite Nr. 1

Inhaltszusammenfassung zur Seite Nr. 2

Introduction KS-Series Tweeters Owner’s Manual Models: KS25 / KS20 / KS13 Congratulations! Attention: You have purchased one of the most advanced separate tweeter and outboard Please record your purchase information in the area crossover systems in car audio. below. We recommend attaching the original sales The KS-Series Tweeters were designed by receipt to this manual for future reference. the award-winning KICKER speaker design team, tested in the judging lanes of If you require service on th

Inhaltszusammenfassung zur Seite Nr. 3

Features
Newly Designed Passive Crossover Network allows
High-Power Tinsel Lead Wires eliminate broken leads and detailed imaging and pin-point sound staging of the critical high power loss, due to the common use of “insufficient-gauge” lead frequencies. wires.
Aluminum Dome Tweeter with Neodymium Magnet
Felt Damping Plug behind the Tweeter’s Diaphragm featured in the KS25 provides a smooth high frequency dissipates standing waves, quickens spectral decay and response with fast, det

Inhaltszusammenfassung zur Seite Nr. 4

Specifications Performance Model: KS13 KS20 KS25 Speaker Design High Frequency Transducer High Frequency Transducer High Frequency Transducer Rated Impedance, ohm 4 4 4 DC Resistance, ohm 3 3 3 Sensitivity [SPLo], dB @ 1W, 1m 92 92 94 Resonance Frequency [fo], Hz 2970 1770 1560 Power Range, Watts RMS 6-75 6-95 6-150 Peak Power Handling, Watts 150 190 300 Effective Frequency Range, Hz 4500-21k 4500-21k 3500-22k Top-Mo

Inhaltszusammenfassung zur Seite Nr. 5

Installation Tweeter Mounting If custom door mounting locations for the KS-Series Tweeters are desired, be careful to avoid interference from the window and door lock mechanisms. The first step is to find a location on the door panel that will accept the dimensions of the speaker. Then remove the door panel from the door, and check for operational clearance of the window. Cycle the window all the way down and up. If metal must be cut to mount the speakers, avoid structural metal and braces. An o

Inhaltszusammenfassung zur Seite Nr. 6

Installation Installation all the parts in unison until the tweeter is angled in the desired direction. Secure the assembly by tightening the longer tweeter mounting nut, as outlined in Figure 5. Figure 3 Figure 4 Clearance Hole 2.5" Shorter Tweeter Door Body Mounting Nut Mounting Nut Tweeter Door Panel Tweeter Wire Panel 2" Hole Wiring There are two lengths of wires attached to the Kicker KS-Series Tweeter Crossover. One set is labeled “INPUT” and is designed to connect to the source unit or am

Inhaltszusammenfassung zur Seite Nr. 7

WHAT IS NOT COVERED? Acoustics LIMITED WARRANTY This warranty is valid only if the product is used for the purpose for which it was Kicker warrants this product to be free from defects in material and workmanship designed. under normal use for a period of THREE (3) MONTHS from date of original It does not cover: purchase with receipt. When purchased from an Authorized KICKER Dealer it is warranted for ONE (1) YEAR from date of original purchase with receipt. In all cases • Damage due to impr

Inhaltszusammenfassung zur Seite Nr. 8