Bedienungsanleitung Oreck XL2090RSM

Inhaltszusammenfassung zur Seite Nr. 1

75376-07 REV B

®
S I M P L Y AMAZING

USER’S GUIDE
XL2090RSM
COMMERCIAL
HIGH SPEED UPRIGHT VACUUM
CLEANER WITH
®
CLEANING SYSTEM
•IMPORTANT•
SAVE THIS BOOKLET!
Includes:
• Safety Warnings
• Warranty
• Operating Instructions
• Trouble Diagnosis
• Accessories

Inhaltszusammenfassung zur Seite Nr. 2

Upper 1 2 3 Handle Connector Assembly Connector Assembly 4 5 6 7 8 A B 9 10 11 12 13 14 15 16 OLD 17 18 NEW Intake Opening 19 20 21 22 23 Tube Fan Housing Fan Housing Retainer Spring O-ring Intake Opening 24 25 Connector Deflector 1

Inhaltszusammenfassung zur Seite Nr. 3

BEFORE OPERATING CLEANER, IMPORTANT SAFETY READ ALL INSTRUCTIONS IN INSTRUCTIONS THIS MANUAL CAREFULLY. When using an electrical appliance, basic precautions should always be followed, including the following: Table of Contents READ ALL INSTRUCTIONS BEFORE USING THIS VACUUM CLEANER Maintenance and Customer Service, Accessories, Grounding Instructions, Important Safety Instructions . . . . . . . page 2 WARNING Warranty, Unit Specifications,Parts List, To reduce the risk

Inhaltszusammenfassung zur Seite Nr. 4

Bag Cover: XL Filter Knit, heavy duty, reinforced. Convenient pocket in Warranty back for storage of cleaning accessories and extra disposable dust bag. ® ORECK MANUFACTURING COMPANY: (Oreck gives you the following MicroSweep : Cleans bare floors without hoses, adjustments, or limited warranty for this product only if it was originally purchased for attachments. use, not resale, from Oreck or an Oreck Authorized Retail Dealer.) Oreck will repair or

Inhaltszusammenfassung zur Seite Nr. 5

5. WARNING: Do not use your vacuum cleaner on damp or wet CAUTION—Wood Floors, Soft (Vinyl, Asphalt Tile, etc.) Floor surfaces. This will cause damage to the vacuum cleaner and is Surfaces and Polished Floor Finishes dangerous to the user. Use floor and floor finish manufacturer’s recommended methods of 6. REPLACE THE BELT EVERY 6 MONTHS. cleaning. The metal strip on the base of the cleaner could be damaged if used on concrete or

Inhaltszusammenfassung zur Seite Nr. 6

IMPORTANT: Unless the brush is worn as indicated above, both Troubleshooting Guide bearings must be in the “NEW” position. When rotating, both bearings must be in the “OLD” position. Unmatched settings will cause damage to your machine. WARNING: Unplug cord from electrical outlet before servicing. ® Using An Oreck Fresh Air Tab SAVE SERVICE CALLS...CHECK THESE FIRST: fig. 17 Your ORECK XL vacuum cleaner has a special Oreck Fresh • Is the disposable filter

Inhaltszusammenfassung zur Seite Nr. 7

6

Inhaltszusammenfassung zur Seite Nr. 8

75376-07 REV B ©2005 Oreck Holdings, LLC. All Rights Reserved. All word marks, logos, registered trademarks and product configurations are 05/05 ECN# R-8018 owned and used under the authority of Oreck Holdings, LLC.