Inhaltszusammenfassung zur Seite Nr. 1
WWW.SHARKCLEAN.COM
NV355 Series
Owner’s guide
NV355_NV356E_NV356K_NV357_IB_110714_3.indd 1 11-07-20 9:32 AM
Inhaltszusammenfassung zur Seite Nr. 2
IMPORTANT SAFETY INSTRUCTIONS For Household Use Only WHEN USING AN ELECTRICAL WARNING: APPLIANCE, BASIC SAFETY PRECAUTIONS TO REDUCE THE RISK OF FIRE, ELECTRIC SHOULD ALWAYS BE OBSERVED, SHOCK OR INJURY: INCLUDING THE FOLLOWING: GENERAL ELECTRICAL SAFETY: READ ALL INSTRUCTIONS BEFORE USING ® ™ 1. U nplug from electrical outlet when not in use YOUR SHARK NAVIGATOR and before servicing. ® LIFT-AWAY PRO. 2. DO NOT use vacuum with a damaged cord POLARIZED PLUG: or plug. If appliance is n
Inhaltszusammenfassung zur Seite Nr. 3
English HOSE ATTACHMENTS: DUST CUP/FILTERS/ACCESSORIES: 1. D O NOT use if air flow is restricted; if the air Before turning on the vacuum: paths, the hose, or the accessories become 1. M ake sure that all filters are thoroughly dry blocked, turn the vacuum cleaner off. Remove after routine cleaning. all obstructions before you turn on the 2. Make sure that dust cup and all filters are in unit again. place after routine maintenance. 2. K eep the end of the hose and accessory 3. Make sure
Inhaltszusammenfassung zur Seite Nr. 4
This manual covers model numbers: NV355 NV356E NV356K NV357 TECHNICAL SPECIFICATIONS Voltage: 120V., 60Hz Watts: 1200W Amps: 10A 4 TOLL FREE: 1-800-798-7398 NV355_NV356E_NV356K_NV357_IB_110714_3.indd 4 11-07-20 9:32 AM
Inhaltszusammenfassung zur Seite Nr. 5
English Contents Thank you for purchasing ® Getting Started 6 the Shark ™ Navigator Mode 1: Upright Vac 8 ® Lift-Away ® Mode 2: Portable Lift-Away 10 Pro Above-Floor Cleaning 11 ™ Dust-Away Hard Floor Attachment Use & Care 12 Storage and Maintenance 13 Maintenance 14 Emptying the Dust Cup 14 Cleaning the Pre-Motor Filters 14 Cleaning the Post-Motor HEPA Filter 15 Cleaning the Power Brush 15 Cleaning the Motorized Floor Brush 16 Checking for Blockages 16 Ordering Parts 17 Troubles
Inhaltszusammenfassung zur Seite Nr. 6
Getting Started g a h b Fig. 1 Fig. 2 c i Fig. 3 Fig. 4 d j Fig. 5 Fig. 6 ACCESSORIES: ™ DUST-AWAY HARD FLOOR ATTACHMENT Specialized hard floor attachment vacuums up large k particles, then re-usable micro-fiber pad traps extra e fine dirt and dust for a superior bare floor clean. ® (Fig. 1) Use only in Portable Lift-Away mode. f l CREVICE TOOL Reach deep into narrow spaces and clean between cushions, under radiators and baseboards and in FIRST THING’S FIRST, YOU NEED TO KNOW hard t
Inhaltszusammenfassung zur Seite Nr. 7
English ® ® ™ Y our new Shark Navigator Lift-Away Pro vacuum cleaner can easily be configured into different cleaning modes to meet all your cleaning needs: upright vacuum and portable Lift- ® Away - both with constant suction power. Fig. 6 Fig. 7 MODES: ® 1 UPRIGHT VAC 2 PORTABLE LIFT-AWAY ® Take the Lift-Away with you around the house to U pright vacuuming - floors and carpets. (Fig. 6) clean hard to reach places. (Fig. 7) TOLL FREE: 1-800-798-7398 www.sharkclean.com 7 NV355_NV356E_NV35
Inhaltszusammenfassung zur Seite Nr. 8
Mode 1: Upright Vac T o reduce the risk of electric shock, unplug the unit before assembling, adding or removing attachments or converting modes. ® WARNING: The On/Off switch is on the top of the Lift-Away canister. Always ensure the power is OFF (“O” position) before plugging and unplugging. b d a Upper Cord e Storage Wrap c Fig. 8 Fig. 9 Fig. 10 5 P ush the handle (b) onto the top of the extension TO ASSEMBLE: wand until you hear it click into place. (Fig. 10) 1 P lace the floor nozzle
Inhaltszusammenfassung zur Seite Nr. 9
English Suction Release Collar c a Release suction for easier push & pull on high pile carpets and area rugs. b Fig. 11 Fig. 12 TO USE: 4 Gently press the floor nozzle down with your foot while you grasp the handle and tilt it back towards 1 R otate the cord release to quickly release the you. (Fig. 12) power cord. NOTE: The rotating brush on the motorized 2 Secure the power cord in the cord hook. floor brush will not spin unless the nozzle is flat against the floor and the handle
Inhaltszusammenfassung zur Seite Nr. 10
® Mode 2: Portable Lift-Away You can carry your vacuum cleaner in both modes by the carry handle located on top of the dust cup. a a b Fig. 13 Fig. 15 Fig. 14 ® PORTABLE LIFT-AWAY 3 Attach desired accessory onto the end of either the extension wand or the handle. ® 1 Separate the portable Lift-Away canister from 4 P ress the On/Off switch to the “I” position to the floor nozzle by pressing the red release turn the vacuum on for above-floor cleaning and button (a) on the side of the ca
Inhaltszusammenfassung zur Seite Nr. 11
English Above-Floor Cleaning Release suction when dusting delicate a objects, furniture or draperies. Fig. 16 Suction Release Collar CLEAN ABOVE THE FLOOR IN UPRIGHT VAC OR 4 P ress the On/Off switch to the “I” position to turn ® the vacuum on for above-floor cleaning. PORTABLE LIFT-AWAY MODE 1 P ress the handle release button and pull the IMPORTANT: Ensure vacuum is in upright handle up or press the extension wand release position. Do not use position “II” when cleaning button and p
Inhaltszusammenfassung zur Seite Nr. 12
™ Dust-Away Hard Floor Attachment - Use and Care IMPOR TANT: Use only in ® Portable Lift-Away mode. Fig. 18 Fig. 17 ATTACH PAD 2 Do not use bleach or fabric softeners as they may damage or leave a coating that will reduce the Slip two of the tabs between the suction nozzle cleaning performance of the pads. ™ and the Dust-Away base and attach them to 3 Tumble dry low or line dry to extend the life of the the front fasteners on the base. Then pull the other two tabs tightly around t
Inhaltszusammenfassung zur Seite Nr. 13
Storage and Maintenance Quick Cord Release Lower Cord Storage Clip Fig. 19 STORE YOUR VACUUM SAFELY To reduce the risk of electric shock, unplug the unit 1 C onvert your vacuum back to upright vac mode. before performing any cleaning, maintenance, or troubleshooting checks. 2 Rotate the upper quick cord release to its upright position and coil the power cord loosely around Reassemble all parts securely before operating the two clips. Clip the plug onto the cord to vacuum. secure. (F
Inhaltszusammenfassung zur Seite Nr. 14
Maintenance COMPONENT MAINTENANCE SCHEDULE 1 Dust Cup Empty each time you vacuum. Pre-Motor Foam Filter Rinse and air dry every 3 months under normal use. 2 Pre-Motor Felt Filter Rinse and air dry every 3 months under normal use. 3 4 Post-Motor HEPA Filter Clean once every 2 years or as needed. IMPOR TANT: Loss of Suction may occurif foam filters are not cleaned every 3 months. Rinse and allow to air dry completely. Foam filters may appear dirty after Fig. 20 use - this is normal. Fig.
Inhaltszusammenfassung zur Seite Nr. 15
Maintenance - cont’d a Fig. 24 Fig. 27 Fig. 28 CLEANING THE POWER BRUSH (model NV355 only) 1 Slide the locking latch (a) forward and tilt the bottom cover upward to remove. (Fig. 27) 2 Carefully remove any blockage or debris and Fig. 25 Fig. 26 cut away any build-up of hair or string wrapped around the rotating bristle brush with scissors. CLEANING THE POST-MOTOR HEPA FILTER 3 To reassemble, insert the tabs on the front edge of the bottom cover into the matching holes in the 1 R emove t
Inhaltszusammenfassung zur Seite Nr. 16
English Maintenance - cont’d Make sure you are working in a well lit area and use a flashlight to help search for blockages. Rotating Brush Fig. 32 Fig. 31 CHECKING FOR BLOCKAGES CLEANING THE MOTORIZED FLOOR BRUSH Blockages may cause your vacuum to overheat and When your motorized floor brush needs cleaning or locks onto an object, it automatically shuts down to shut down. To prevent this from happening, check potential blockage areas after heavy use or if you prevent damage to your lifeti
Inhaltszusammenfassung zur Seite Nr. 17
Maintenance - cont’d Ordering Parts 1 2 3 4 7 Fig. 33 5 8 6 9 Fig. 34 PART PART NO. 1 Pre-Motor Filter Set XFF350 4 Hose and Connections to Vacuum 2 HEPA Filter XHF350 • D etach the stretch hose from the back of the 3 Dusting Brush 112FFJ ® portable Lift-Away canister by squeezing & Crevice Tool the tabs together and pulling up. (Fig. 32) Straighten out the hose and look inside for 4 Turbo Brush (NV356E, NV356K, NV357) 119FFJC blockages. 5 Turbo Brush (NV355) 137FFJ • R emove the
Inhaltszusammenfassung zur Seite Nr. 18
English Troubleshooting Guide PROBLEM POSSIBLE REASONS & SOLUTIONS Check filters to see if they need cleaning. Follow instructions for rinsing and drying the filters before re-inserting back into the vacuum. (See “Maintenance” sections for instructions.) Vacuum is not Dust cup may be full; empty dust cup. picking up dirt. Check hose and hose connections for blockages; clear blockages if required. If dust cup is empty, and attachment inlets are clear, check for other blockages. (See “Checking
Inhaltszusammenfassung zur Seite Nr. 19
EURO-PRO FIVE-YEAR (5) LIMITED WARRANTY EURO-PRO Operating LLC warrants this product to be free from material defects and workmanship for a period of five (5) years from the date of purchase when utilized for normal household use, subject to the following conditions, exclusions and exceptions. The liability of EURO-PRO Operating LLC is limited solely to the cost of the repair or replacement of the unit at our option. This Limited Warranty does not cover normal wear of parts and does not apply
Inhaltszusammenfassung zur Seite Nr. 20
EURO-PRO Operating LLC U.S.: Newton, MA 02459 Canada: Ville St. Laurent, Québec H4S 1A7 1-800-798-7398 www.sharkclean.com Copyright © Euro-Pro Operating LLC 2011 Printed in China Illustrations may differ from actual product. NV355.NV356E.NV356K.NV357.110714.3 NV355_NV356E_NV356K_NV357_IB_110714_3.indd 20 11-07-20 9:32 AM
