Bedienungsanleitung Oreck XL2090RHM

Inhaltszusammenfassung zur Seite Nr. 1

75400-07 REV B

®
S I M P L Y AMAZING

USER’S GUIDE
XL2090RHM
COMMERCIAL
HIGH SPEED UPRIGHT VACUUM
CLEANER WITH
®
CLEANING SYSTEM
•IMPORTANT•
SAVE THIS BOOKLET!
Includes:
• Safety Warnings
• Warranty
• Operating Instructions
• Trouble Diagnosis
• Accessories

Inhaltszusammenfassung zur Seite Nr. 2

1 2 3 4 Upper Handle Connector Assembly Connector Assembly 5 6 7 8 9 A B 10 11 12 13 14 15 16 17 OLD 18 19 NEW Intake Opening 20 21 22 23 24 Tube Fan Housing Fan Housing Retainer Spring O-ring Intake Opening 25 26 Connector Deflector 1

Inhaltszusammenfassung zur Seite Nr. 3

BEFORE OPERATING CLEANER, IMPORTANT SAFETY READ ALL INSTRUCTIONS IN INSTRUCTIONS THIS MANUAL CAREFULLY. When using an electrical appliance, basic precautions should always be followed, including the following: Table of Contents READ ALL INSTRUCTIONS BEFORE USING THIS VACUUM CLEANER Maintenance and Customer Service, Accessories, Grounding Instructions, Important Safety Instructions . . . . . . . page 2 WARNING Warranty, Unit Specifications, Parts List, To reduce the ris

Inhaltszusammenfassung zur Seite Nr. 4

Bag Cover: XL Filter Knit, heavy duty, reinforced. Convenient pocket in Warranty back for storage of cleaning accessories and extra disposable dust bag. ® ORECK MANUFACTURING COMPANY: (Oreck gives you the following MicroSweep : Cleans bare floors without hoses, adjustments, or limited warranty for this product only if it was originally purchased for attachments. use, not resale, from Oreck or an Oreck Authorized Retail Dealer.) Oreck will repair

Inhaltszusammenfassung zur Seite Nr. 5

4. Although your upright will pick up pins, paper clips, and other CAUTION—Wood Floors, Soft (Vinyl, Asphalt Tile, etc.) Floor small objects, it is recommended that these be removed from the Surfaces and Polished Floor Finishes floor before you vacuum. Failure to do so may result in permanent Use floor and floor finish manufacturer’s recommended methods of damage to the motor suction fan and its housing. cleaning. The metal strip on

Inhaltszusammenfassung zur Seite Nr. 6

fig. 14 Reassemble the belt and the baseplate and check bristle height Troubleshooting Guide above baseplate at each end of brush. If a previous adjustment has already been made and bristle height does WARNING: Unplug cord from electrical not extend above baseplate, a new brush assembly should be ordered. outlet before servicing. IMPORTANT: Unless the brush is worn as indicated above, both bearings must be in the “NEW” position. When rotating, both bear

Inhaltszusammenfassung zur Seite Nr. 7

6

Inhaltszusammenfassung zur Seite Nr. 8

75400-07 REV B ©2005 Oreck Holdings, LLC. All Rights Reserved. All word marks, logos, registered trademarks and product configurations are 05/05 ECN# R-8018 owned and used under the authority of Oreck Holdings, LLC.