Inhaltszusammenfassung zur Seite Nr. 1
Operating instructions
Vacuum cleaner
S 4000
UV
To prevent accidents
and machine damage,
read these instructions
before installation and use. M.-Nr. 06 579 361
Inhaltszusammenfassung zur Seite Nr. 2
Contents IMPORTANT SAFETY INSTRUCTIONS. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Guide to the machine. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 Before using the vacuum cleaner. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10 Using the included accessories . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13 Operation . . . . . . . . . . . . . . . . . . . . . . . . . . .
Inhaltszusammenfassung zur Seite Nr. 3
IMPORTANT SAFETY INSTRUCTIONS When using an electrical appliance, basic precautions should always be followed, including the following: READ ALL INSTRUCTIONS BEFORE USING THIS APPLIANCE The manufacturer cannot be held responsible for any damage caused by non-compliance of these Important Safety Instructions. WARNING- To reduce the risk of electric shock, To reduce the risk of fire, electric this appliance has a polarized plug shock or injury: (one blade is wider than the other.) This plug will f
Inhaltszusammenfassung zur Seite Nr. 4
IMPORTANT SAFETY INSTRUCTIONS Use Do not pull or carry by the cord, use the cord as a handle, close a Do not use on people door on the cord, or pull the cord or animals. around sharp edges or corners. Do not Do not use outdoors or on wet run the appliance over the cord. Keep surfaces. Only dry surfaces should the cord away from heated surfaces. be vacuumed. Do not unplug by pulling on the Use only as described in this cord. To unplug, grasp the plug, manual. not the cord. Use only Miele recommen
Inhaltszusammenfassung zur Seite Nr. 5
IMPORTANT SAFETY INSTRUCTIONS Do not use the vacuum cleaner to Unwind the cord completely to aid pick up liquids, this could impair the vacuum in dissipating heat. the electrical safety of the vacuum A temperature limiter automatically cleaner. Wait for freshly shampooed switches off the vacuum cleaner if carpets to dry. it gets too hot, see "Frequently asked Do not vacuum anything that is questions". burning or smoking, such as On the underside of the vacuum cigarettes, matches, or hot ashes. h
Inhaltszusammenfassung zur Seite Nr. 6
IMPORTANT SAFETY INSTRUCTIONS Accessory use Maintenance and care To avoid the risk of injury when A damaged power cord must only vacuuming with a Miele be replaced with a genuine Miele Electrobrush do not touch the rotating cord by an authorized service agent. roller. Clean only with a dry or slightly Use only attachments specified by damp cloth when disconnected Miele. Do not use the blower to from the power supply. Never operate paint sprayers or similar submerge in water. devices that emit vo
Inhaltszusammenfassung zur Seite Nr. 7
IMPORTANT SAFETY INSTRUCTIONS FCC and Industry Canada Note: information: This equipment has been tested and found to comply with the limits for a This device complies with part 15 of the Class B digital device, pursuant to Part FCC Rules. Operation is subject to the 15 of the FCC Rules. These limits are following two conditions: (1) This device designed to provide reasonable may not cause harmful interference, protection against harmful interference and (2) this device must accept any when the e
Inhaltszusammenfassung zur Seite Nr. 8
Guide to the machine Some models come standard with one of the following accessories, which are not shown in this figure. – Turbobrush – Cordless Rechargeable Powerbrush ACCU NOVA A separate Operating manual of the respective accessory is supplied with the vacuum. 8
Inhaltszusammenfassung zur Seite Nr. 9
Guide to the machine a Handpiece (some models may include an air inlet valve) * b Suction power buttons + / –* c Standby switch * d LED * e Locking button f Accessory clip * g Telescopic wand release button * h Dust compartment lid release i Telescopic wand * j Dust bag k Carrying handle l Floor tool * m Transport/storage holder n Dust compartment filter (motor protection) o Exhaust filter * p Suction power selector * q Standby indicator * r Thermo indicator , * s Exhaust filter change indicator
Inhaltszusammenfassung zur Seite Nr. 10
Before using the vacuum cleaner Attaching the suction hose ^ Insert the elbow into the suction socket until it clicks. Use the inlet guides to direct insertion. Removing the suction hose ^ Press the release buttons at the sides of the elbow and lift the hose from the socket. Connecting the handpiece and telescopic wand ^ Insert the handpiece into the telescopic wand until it clicks. Use the inlet guides to direct insertion. ^ To release the handpiece from the telescopic wand press the locking bu
Inhaltszusammenfassung zur Seite Nr. 11
Before using the vacuum cleaner Depending on your model, the vacuum will include one of the following telescopic wands: – Fitted wand (CDN only) – Telescopic wand – XXL telescopic wand Inserting the fitted wand Both sections of the telescopic wand have locating arrows to guide insertion. Adjusting the telescopic wand One section of the telescopic wand is inside the other and can be adjusted for comfortable vacuuming. ^ Press the telescopic wand release button (see arrow) to release the tubes and
Inhaltszusammenfassung zur Seite Nr. 12
Before using the vacuum cleaner Attaching the floor tool/brush ^ Insert the wand into the floor brush and twist until it locks with a click. ^ To release the floor brush from the telescopic wand, press the locking button (see arrow) and pull the wand out of the floor brush. Observe the cleaning instructions of the floor manufacturer. SBB 300-3 Floor brush The floor brush is suitable for cleaning all hard flooring. SBD 450-3 Floor tool The floor tool is suitable for cleaning carpets, rugs, and ha
Inhaltszusammenfassung zur Seite Nr. 13
Using the included accessories The following accessories are included a Crevice nozzle b Dusting brush c Upholstery tool d Accessory clip for the respective included accessories e Filter frame The filter frame is supplied only with those models which are fitted with an "ActiveAirClean" or "Active HEPA" exhaust filter as standard. The filter frame is required to replace one of these filters with a "SUPER air clean" filter (see "Maintenance and care - Replacing one type of filter with another"). A
Inhaltszusammenfassung zur Seite Nr. 14
Using the included accessories Floor brush SBB 300-3 (depending on model) For cleaning all hard flooring. Especially suitable for vacuuming niches and tight spaces. Floor tool SBD 450-3 (depending on model) The standard floor brush can be used for normal cleaning of carpets, rugs, hard surfaces, carpeted stairs, etc. 14
Inhaltszusammenfassung zur Seite Nr. 15
Using the included accessories Crevice nozzle For cleaning in folds, crevices and corners. Upholstery nozzle For cleaning upholstery, mattresses, cushions, curtains, covers, etc. Dust brush with natural bristles For cleaning moldings, decorative or carved items, etc. The head of the dusting brush can be swiveled to attain the best cleaning position. For dusting particularly delicate objects. 15
Inhaltszusammenfassung zur Seite Nr. 16
Operation Power cord ,Unwind the cable completely to aid the vacuum in dissipating heat. Unwinding ^ Hold the plug and pull the power cord out to the required length (maximum 18 ft / 5.5 m). , To reduce the risk of electric shock, the vacuum has a polarized plug (one blade is wider than the other). This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. Do not alter the plug
Inhaltszusammenfassung zur Seite Nr. 17
Operation Models with radio frequency controls The operating state is shown by the Standby indicator on the vacuum. The vacuum can be switched to a standby mode during pauses. ^ Press the Standby button on the handpiece. To turn the vacuum on again: ^ Press the Standby button on the handpiece. The vacuum cleaner turns on to the last selected power level. ^ Press – to turn the vacuum cleaner on at the lowest power level. ^ Press + to turn the vacuum cleaner on at the highest power level. Every pu
Inhaltszusammenfassung zur Seite Nr. 18
Operation While vacuuming The vacuum cleaner can also stand on its end for vacuuming stairs, drapes etc. ,To prevent static electricity your hand must touch the metal inlay on the underside of the vacuum handpiece. Be certain to continuously touch this inlay when vacuuming fine dust, flour or sawdust as these materials are more likely to create a static discharge. To further prevent static discharge while vacuuming, pull the vacuum along by the hose with one hand while continuing to hold the han
Inhaltszusammenfassung zur Seite Nr. 19
Operation The controls vary from model to model, and are described as follows. Rotary selector ^ Turn the rotary selector to the desired suction power setting. + / – controls Press the controls until the light bar above the desired suction power setting is illuminated. ^ Press the + control to select a higher setting. ^ Press the – control to select a lower setting. + / – at the radio handpiece Press the controls until the desired suction power is shown in the vacuum display on the canister. ^ P
Inhaltszusammenfassung zur Seite Nr. 20
Operation Opening the air inlet valve (not available in models with radio handpiece) The air inlet valve is designed to provide a quick, convenient reduction of suction power, e.g. when moving from a carpet to an area rug. ^ Open the air inlet valve far enough to reduce the power. Opening the air inlet valve reduces the power to the tool being used. 20
