Inhaltszusammenfassung zur Seite Nr. 1
Self-Propelled
Upright
Vacuum Cleaner
Household Type
Owner’s Guide
5180 Series
Index
Important Safeguards ............. 2
General Information ................ 4
Thermal Cut Off ................ 4 & 7
Assemble ................................ 5
Use ....................................... 6-7
Accessories ............................ 8
Dirt Alert Feature .................... 9
Maintenance ......................... 10
Brush Roll and Belt .......... 10-11
Hose Clogs ........................... 12
Dus
Inhaltszusammenfassung zur Seite Nr. 2
IMPORTANT SAFEGUARDS When using an electrical appliance, basic precautions should always be followed, including the following: READ ALL INSTRUCTIONS BEFORE USING THIS VACUUM CLEANER. WARNING To reduce the risk of fire, electric shock, or injury: • Do not use outdoors or on wet surfaces. • Do not leave vacuum cleaner when plugged in. Turn off the switch and unplug the electrical cord when not in use and before servicing. • Do not allow to be used as a toy. Close attention is necessary when used b
Inhaltszusammenfassung zur Seite Nr. 3
CONSEILS DE SÉCURITÉ Lors de l’utilisation d’un appareil électrique, quelques précautions élémentaires doivent être observées, incluant les suivantes: LISEZ TOUTES LES INSTRUCTIONS AVANT D’UTILISER VOTRE ASPIRATEUR. AVERTISSEMENT Pour réduire le risque de feu, de choc électrique, ou de blessure: • Ne pas utiliser à l’extérieur ou sur des surfaces mouillées. • Fermez le commutateur et débranchez l’appareil lorsque vous ne l’utilisez pas ou avant le nettoyage ou l’entretien. • Ne permettez pas qu’
Inhaltszusammenfassung zur Seite Nr. 4
To reduce the risk of electric shock, this appliance has a polarized plug (one blade wider than the other). This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician to install the proper outlet. Do not change the plug in any way. Afin de réduire le risque de choc électrique, cet appareil est muni d’une fiche polarisée (une des lames est plus large). Cette fiche ne peut être ins
Inhaltszusammenfassung zur Seite Nr. 5
HOW TO ASSEMBLE VACUUM CLEANER HANDLE CAUTION: Moving parts, make sure on/off switch is in off position before plugging in. STEP 1 Pull the foam pieces from the ends of the handle and throw away. STEP 2 Find the 2-part bolt in the plastic bag with the owner’s guide. It is the only part needed to assemble the vacuum cleaner handle. See below. 2-Part Bolt Upper Handle Flexible Hose Transmission Cable Lower Handle STEP 3 CAUTION: Do not pinch the transmission cable between the upper and lower han
Inhaltszusammenfassung zur Seite Nr. 6
HOW TO USE THE SELF-PROPELLED VACUUM CLEANER The upright vacuum cleaner is designed to be used on multiple types of carpeting. Do not attempt to use the upright vacuum cleaner on bare floors, as damage to the floor covering may result. When using the attachment tools, place the handle in the upright position. Do not place cleaner on furniture or steps as the brush roll may cause damage. A carpet should be cleaned regularly over heavily travelled areas, and once a week over the entire carpeted ar
Inhaltszusammenfassung zur Seite Nr. 7
Low High HOW TO USE THE SELF-PROPELLED VACUUM CLEANER (continued) How to Adjust the Cleaner Height Setting WARNING: Avoid injury. Keep hair, loose clothing, fingers, and all parts of body away from openings and moving parts (such as the revolving brush roll and power drive On/Off 3 wheel). Turn off the switch and unplug the electrical cord before changing the (I/O) 2 cleaner height setting. 1. Turn off the switch and unplug the electrical cord before changing the cleaner height setting. If you n
Inhaltszusammenfassung zur Seite Nr. 8
HOW TO USE THE ACCESSORIES Crevice tool cleans corners, baseboards, between cushions, sliding door tracks. NOTE: Do not place cleaner on furniture or steps as the brush roll or drive wheel may cause damage. Place cleaner on floor with the handle in storage position while using accessories. 1. Remove hose from rear of cleaner. 2. Place desired accessory onto end of the wand portion of the hose assembly. Dusting Brush is for furniture, blinds, books, lamp shades, shelves. Upholstery nozzle is for
Inhaltszusammenfassung zur Seite Nr. 9
Maintenance of Dirt Alert Feature (On some models) The dirt alert sensor uses infra-red technology to indicate whether or not floors are clean. When debris breaks the light beam, the red light comes on indicating additional cleaning is needed in this area. If there is no break in the light beam, the floor is clean and no light will come on. When using your new vacuum you may be cleaning deep down hidden dirt missed by your old vacuum causing the light to stay red longer. With frequent cleaning,
Inhaltszusammenfassung zur Seite Nr. 10
HOW TO MAINTAIN The instructions in this booklet serve as a guide to routine maintenance. To avoid unnecessary service calls, check the bag, belt, and brush roll often. Brush Roll The brush roll turns as it sweeps and combs the carpet nap. Remove hair and threads from the brush roll so it continues brushing the carpet. To maintain the most efficient cleaning, the bristles must touch the carpet. To test the bristle length, hold a ruler against the underneath side of the cleaner. If the bristles n
Inhaltszusammenfassung zur Seite Nr. 11
How To Replace Brush Roll Belt (continued) Belt Detail 7 9 End Cap Brush Roll (Left) 8 7. Place new belt around motor pulley. 8. Place belt around the pulley at the right end of the brush roll. 9. Align left end cap of brush roll with square in base. See Detail 9. Slide end cap into place. 11 10 12 Rotate End Cap End Cap (Left) (Right) 10. Pull right side of brush roll to stretch belt. Secure right 11. Rotate the brush roll at least three revolutions to seat end cap of brush roll into base. the
Inhaltszusammenfassung zur Seite Nr. 12
HOW TO CLEAR HOSE CLOGS NOTE: Turn off the switch and unplug the electrical cord before clearing hose. 1. Remove the front bag cover. 2. Step on handle release. 3. Release the hose from the unit. See Detail 6. To release the hose, grasp the hose adapter at depression and rotate to the left to release. Pull upward to remove from unit. 4. Lower handle until the cleaner is resting flat on the s floor. 5. Turn the cleaner over so the back side faces upward. 6. Lift the cleaner and rest it against a
Inhaltszusammenfassung zur Seite Nr. 13
Bag Change Indicator (on selected models only) Bag Change Some models feature a Bag Change Indicator to remind you to change the bag. The Indicator indicator on the bag cover moves into the window as the airflow through the bag decreases. Certain types of fine particles like powder, plaster dust, or fine road dust can restrict airflow very quickly. The fine particles will decrease performance even before the bag appears to be full. Change the dust bag to restore maximum performance. Be sure to u
Inhaltszusammenfassung zur Seite Nr. 14
How To Replace Filters: Motor Filter Check the motor filter with each disposable dust bag change. Cleaning the motor filter is recommended between filter changes. To Clean Motor Filter 1. Remove the front bag cover. 2. Remove filter from inside the bag compartment (lower left side). 3. Shake filter to remove excess dust. If necessary, the filter can be cleaned by vacuuming with another cleaner. 4. Reinstall filter when completely dry. 5. Replace the front bag cover. HEPA Filter (on selected mode
Inhaltszusammenfassung zur Seite Nr. 15
How to Change Light Bulb (only for models with a headlight) NOTE: Turn off the power switch and disconnect the electrical cord before changing light bulb. 1. Lower handle to remove two screws from lens cover. 2. Lift lens cover from cleaner. Lens 2 Cover Handle 1 Release 3. Push light bulb into socket; turn to release. 4. Place new light bulb into socket; turn to secure. 5. Make sure bulb will not touch lens cover. 6. Replace lens cover. 3 7. Secure with two screws. 4 Use 15 watt replacement lig
Inhaltszusammenfassung zur Seite Nr. 16
PROBLEM SOLVING NOTE: Turn off the switch and unplug the electrical cord before servicing. PROBLEM CAUSE SOLUTION Motor suddenly stops. 3 Thermal Cut Off Refer to page 7. Does not clean the 3 Hose Remove any clogs from the hose that restrict the carpet. airflow. Check short hose in the base and long hose. If the clog is hard to remove, check the brush roll area. Remove the hood and clear the hose inlet in the brush roll area. 3 Disposable Dust Bag Change the bag and clean or replace the filter(s
Inhaltszusammenfassung zur Seite Nr. 17
3/00 The Eureka Company P.O. Box 2799 ORDER FORM Bloomington, IL 61702-2799 VACUUM CLEANERS (Not applicable in Canada) Name Name S S O H Address (street address needed for UPS) Address (street address needed for UPS) L I D P City State Zip City State Zip T T Telephone (Day) (Eve) (Fax) Telephone (Day) (Eve) (Fax) O O IMPORTANT: Part No. Qty. Price (USD) Total Be sure to include Genuine Eureka Bags, Belts and Filters your model, type, and serial numbers. Disposable dust bags, package of 3 - Style
Inhaltszusammenfassung zur Seite Nr. 18
Inhaltszusammenfassung zur Seite Nr. 19
THE EUREKA LIMITED WARRANTY hat This Warranty Covers W Your Eureka cleaner is warranted to be free from all defects in material and workmanship in normal household use for a period of one year. The warranty is granted only to the original purchaser and members of his or her immediate household. The warranty is subject to the following provisions. hat This Warranty Does Not Cover W • Parts of the cleaner that require replacement under normal use, such as disposable dust bags, filters, drive belts
Inhaltszusammenfassung zur Seite Nr. 20
Questions? Do Not Return To Store Call 1-800-282-2886 7 a.m. to 8 p.m., Central Standard Time, Monday through Saturday Accessory Items in This Carton 1 upholstery nozzle 1 dusting brush 1 crevice tool 2 wands Thank you for selecting a Eureka cleaner. Don’t Forget to Use Genuine Eureka Bags and Belts Caution: Damages caused by the use of non-genuine Eureka bags are not covered by the Eureka Limited Warranty. ©1999 White Consolidated Industries, Inc. Part No. 59185C (4/00) Printed in U.S.A.
