Inhaltszusammenfassung zur Seite Nr. 14
® Clarke LIMITED U.S. WARRANTY This Clarke Industrial/Commercial Product is warranted to be free from defects in materials and workmanship under normal use and service for a period of one year from the date of purchase, when operated and maintained in accordance with Clarke's Maintenance and Operations instructions. This warranty is extended only to the original purchaser for use of the product. It does not cover normal wear parts such as electrical cable, rubber parts, hoses and motor brushe
Inhaltszusammenfassung zur Seite Nr. 1
LV-30
Operator's
Manual
LV-30H
READ THIS BOOK
This book has important information for the use and safe operation of this machine. Failure to read this
book prior to operating or attempting any service or maintenance procedure to your Clarke machine
could result in injury to you or to other personnel; damage to the machine or to other property could occur
as well. You must have training in the operation of this machine before using it. If your operator(s) cannot
read this manual, have it expl
Inhaltszusammenfassung zur Seite Nr. 2
Table of Contents Table of Contents Table of Contents Table of Contents Table of Contents Operator Safety Instructions .....................................................................3 Introduction & Machine Specifications.........................................................4 How to Prepare the Machine for Operation ..................................................5 How to Check the Oil .....................................................................5 How to Fill the Gasoline Tank
Inhaltszusammenfassung zur Seite Nr. 3
OPERATOR SAFETY INSTRUCTIONS WARNING AVERTISSEMENT ADVERTENCIA DANGER means: Severe bodily injury or death can occur to you or other personnel if the DAN- GER statements found on your machine or in your Owner's Manual are ignored or are not adhered to. Read and observe all DANGER statements found in your Owner's Manual and on your machine. WARNING means: Injury can occur to you and to other personnel if the WARNING statements found on your machine or in your Owner's Manual are ignored or are no
Inhaltszusammenfassung zur Seite Nr. 4
Introduction and Machine Specifications The LV-30 Litter Vac is powered by a 6hp gasoline engine and generates 900 CFM to handle the toughest cleaning jobs. This commercial vacuum cleaner can clean debris from large indoor and outdoor areas. The LV-30 is designed for uneven terrain and with a hose and wand attachment its versatility is greatly enhanced. Large 11 cu. ft. bag with side zipper ◆ disposal system. ◆ Non-rusting fan housing allows easy passage of debris to bag. Heavy duty impeller pi
Inhaltszusammenfassung zur Seite Nr. 5
How to Prepare The Machine for Operation 1. Before assembling the Litter Vac, remove all parts of the machine from the two cartons. Fasten the handles and the filter bag to the main frame. Follow the instructions in the handle carton. HOW TO CHECK THE OIL WARNING: Do not check the engine oil level when the engine is running. Failure to check the oil level before you use the machine can destroy the engine. Always make sure the machine has the correct amount of oil. Follow this procedure to ch
Inhaltszusammenfassung zur Seite Nr. 6
How to Prepare The Machine for Operation How To Start Your Vacuum To start your vacuum follow this procedure: 1. Make sure the spark plug is connected to the plug. 2. Move the throttle lever to the half throttle position. See figure 3. Figure 3 3. If the engine has not run for a period of time, move the choke lever to the second detent toward the "Arrow" mark. See figure 4. 4. Pull the starting cord handle. 5. When the engine starts, move the choke lever to the "OFF" position. NOTE: If the engi
Inhaltszusammenfassung zur Seite Nr. 7
HOW TO OPERATE THE MACHINE Move the machine over the area to be cleaned. To lift objects too large to go under the intake housing, pull the intake door handle. See figure 5. See figure 6. The scraper (1) and the shield (2) can be adjusted to three positions. When the vacuum is being used on an uneven outdoor surface, do the following: 1. Make sure the scraper is .06 of an inch above the surface. 2. Make sure the shield is in the lowest position above the surface. To adjust the scraper and
Inhaltszusammenfassung zur Seite Nr. 8
MAINTENANCE PROCEDURES Keep the vacuum clean, it will have longer life and need fewer repairs. When To Change The Oil To change the oil, follow this procedure: 1. Drain the oil from the engine after the first two hours of use. 2. Fill with 19 ounces of clean oil. NOTE: See the engine manual for the correct type of oil. 3. After the first change of oil, drain the oil after every 25 hours of use. Fill with 19 ounces of clean oil. CAUTION: Never operate the engine when the level of oil is below t
Inhaltszusammenfassung zur Seite Nr. 9
LV-30 LV-30H Section II Parts and Service Manual (70463A) ® Clarke Operator's Manual LV-30 Page 9
Inhaltszusammenfassung zur Seite Nr. 10
® Clarke Model LV-30 & LV-30H Model LV-30 & LV-30H Model LV-30 & LV-30H Model LV-30 & LV-30H Model LV-30 & LV-30H Assembly Drawing - 11/02 Assembly Drawing - 11/02 Assembly Drawing - 11/02 Assembly Drawing - 11/02 Assembly Drawing - 11/02 79A 84A 83 89 84A 90 49 48 47 46 50 45 80 10 52 43 53 44 39 54 51 38 55 41 69 66 61 40 32 57 58 67 62 59 69 2 68 36 1 63 35 65 71 31 60 42 3 6 30 4 37 72 64 70 34 5 29 73 19 74 88 33 7 77 8 75 9 10 77 76 28 91 27 11 18 19 78 13 26 83 86 12 79 14 16 25
Inhaltszusammenfassung zur Seite Nr. 11
® Clarke Model LV-30 & LV-30H Model LV-30 & LV-30H Model LV-30 & LV-30H Model LV-30 & LV-30H Model LV-30 & LV-30H Parts List - 9/03 Parts List - 9/03 Parts List - 9/03 Parts List - 9/03 Parts List - 9/03 Ref. Ref. Ref. Ref. Ref. Part No. Part No. Part No. Part No. Part No. Description Description Description Description Description Qty. Qty. Qty. Qty. Qty. Ref. Ref. Ref. Ref. Ref. Part No. Part No. Part No. Part No. Part No. Description Description Description Description Des
Inhaltszusammenfassung zur Seite Nr. 12
NOTES
Inhaltszusammenfassung zur Seite Nr. 13
CLARKE PRODUCT SUPPORT BRANCHES U. S. A. Locations European Locations CORPO PRODUCTION FACILITIES PRODUCTION FACILITIES ALTO Danmark A/S, Aalborg ® Clarke , Springdale, Arkansas Blytaekkervej 2 2100 Highway 265 DK-9000 Aalborg Springdale, Arkansas 72764 +45 72 18 21 00 (479) 750-1000 Customer Service - 1-800-253-0367 ALTO Danmark A/S, Hadsund Technical Service - 1-800-356-7274 Industrikvarteret DK-9560 Hadsund ® American Lincoln , Bowling Green, Ohio 43402 +45 72 18 21 00 1100 Haskins Ro
