Inhaltszusammenfassung zur Seite Nr. 1
Inhaltszusammenfassung zur Seite Nr. 2
CONTENTS CAUTIONS .......................................................................... 1-2 SAFETY PRECAUTIONS ..................................................... 3 FEATURES AND FUNCTIONS ............................................ 4 NAME OF PARTS ................................................................... 5 INTRODUCTION TO SPARE PARTS................................. 6-7 INSTALLATION...................................................................... 8 REMOTE CONTROLLER OPERAT
Inhaltszusammenfassung zur Seite Nr. 3
CAUTIONS All these valuable materials may be taken to Disposal of the old air conditioner a waste collecting center and used again after Before disposing an old air conditioner that adequate recycling. goes out of use, please make sure it's inoperative and safe. Unplug the air Consult your local authorities for the name conditioner in order to avoid the risk of and address of the waste materials collecting child entrapment. centers and waste paper disposal services nearest to your house. It must
Inhaltszusammenfassung zur Seite Nr. 4
CAUTIONS For the purpose of safety, the air Specifications conditioner must be properly grounded in The refrigerating circuit is leak-proof. accordance with specifications. When installation in under ceiling, dial switch "K1" in the PC board to "D" Always remember to unplug the air position. When installation in floor conditioner before opening inlet grill. console, dial switch to "L" position (Brand Never unplug your air conditioner by new unit is in "D" position).For series 14, p
Inhaltszusammenfassung zur Seite Nr. 5
SAFETY PRECAUTIONS WARNING! For series 14,18, if the power supply cord of this air conditioner is damaged, it must be replaced by the manufacturer its authorized service personnel only. For series 24,28,36,42, the breaker of the air conditioner should be all-pole switch; and the distance between its two contacts should be no less 3mm. Such means for disconnection must be incorporation in the fixed wiring. Use copper wire only. All the cables shall have got the European authentication certificat
Inhaltszusammenfassung zur Seite Nr. 6
FEATURES AND FUNCTIONS AUTOMATIC OPERATION COOLING TYPE Merely press the ON/OFF button, and the unit will begin automatic operation in the Cooling or dry modes as appropriate, in accordance with the thermostat setting and the actual temperature of the room. HEAT & COOL TYPE Merely press the ON/OFF button, and the unit will begin automatic operation in any of the Heating, Cooling and Blow modes as appropriate, in accordance with the thermostat setting and the actual temperature of the room. SLEE
Inhaltszusammenfassung zur Seite Nr. 7
NAME OF PARTS 1 10 11 POWER 4 OPER 5 TIMER 6 COMP 3 7 EMER 2 9 3 Fig.2 8 Fig.1 12 for series 14,18 3 Fig.3 2 EMER POWER OPER TIMER 4 5 6 for series 36,42 Fig.1 Indoor Unit Fig.3 1 Operating Control Panel (Fig.2) 2 Emergency switch 3 Remote Control Signal Receiver 4 Power Indicator Lamp (Red) 5 OPERATION Indicator Lamp (Green) 6 TIMER Indicator Lamp (Yellow) 7 Compressor Run Lamp (Green) 8 Intake Grill (Fig.3) 9 Air Filter for series 24,28 10 UP/DOWN Air Direction Flaps 11 RIGHT/LEFT A
Inhaltszusammenfassung zur Seite Nr. 8
INTRODUCTION TO SPARE PARTS Operation Buttons and display of the remote controller. Power ON/OFF TEMP Used for unit start and Used to select your stop. desired temp. SWING FAN Used to set auto fan direction. Used to select fan speed: LO, MID, HI, AUTO MODE Used to select AUTO run, COOL,DRY,HEAT and SET FAN operation. Used to confirm Timer and Clock settings. CLOCK Used to set correct time. Used to set correct time. SLEEP Used to select sleep mode. TIMER Used to select TIMER ON, TIMER OFF, HOUR
Inhaltszusammenfassung zur Seite Nr. 9
Inhaltszusammenfassung zur Seite Nr. 10
INSTALLATION Please ask the dealer or specialist to install, never try by the users themselves. After the installation please be sure of the following conditions. WARNING ! Please call dealer to install the air-conditioner. Incorrect installation may cause water leaking, shock and fire hazard. CAUTION ! Air-conditioner can't be installed in the envi- Connect earthing wire. ronment with inflammable gases because the Earthing wire should not be con- inflammable gases near to air-conditioner may ne
Inhaltszusammenfassung zur Seite Nr. 11
REMOTE CONTROLLER OPERATION Remote controller's operation When in use, put the signal transmission head directly to the receiver hole on the indoor unit. The distance between the signal transmission head and the receiver hole should be within 7m without any obstacle as well. Don't throw the controller, prevent it from being damaged. When electronic-started type fluorescent lamp or change-over type fluorescent lamp or wireless telephone is installed in the room, the receiver is apt to be disturb
Inhaltszusammenfassung zur Seite Nr. 12
Inhaltszusammenfassung zur Seite Nr. 13
Inhaltszusammenfassung zur Seite Nr. 14
Inhaltszusammenfassung zur Seite Nr. 15
Inhaltszusammenfassung zur Seite Nr. 16
GUIDE TO OPERATION TIMER ON-OFF (1)After unit start, select your desired operation mode Operation mode will be displayed on LCD. Power indicator on indoor unit lights up. (2)Press TIMER button to change TIMER mode Every time the button is pressed, display changes as follows: blank TIMER ON TIMER OFF TIMER ON-OFF Select TIMER ON-OFF, "ON" will flash. (3)Time setting for TIMER ON Press HOUR button. Every time the button is pressed, time increases 10min. If button is kept depressed, time will
Inhaltszusammenfassung zur Seite Nr. 17
GUIDE TO OPERATION Adjusting up/down air flow direction Up/down direction can be adjusted by using the SWING button on the remote controller. Each time pressing this button, the mode changes in the following sequence. SWING No indication (louver stopped) Change to the AIRFLOW mode. SWING LOUVER STOPPED When the LOUVER button is pushed during SWING mode, it stops swinging at the just angle. Louver moves in upward and downward directions continuously. Recommendable stopping angle of th
Inhaltszusammenfassung zur Seite Nr. 18
Inhaltszusammenfassung zur Seite Nr. 19
GUIDE TO OPERATION Remote Control: There is a telecommunication interface for remote control on the control panel of the indoor unit. After the peripheral equipment have been installed in accordance with the instruction manual of the selected remote control detector, the air conditioner will be computerized and controlled from a far-away place. Power Failure Compensation (to be applied for a necessary situation) : After the power failure compensation is set, if power failure suddenly oc
Inhaltszusammenfassung zur Seite Nr. 20
CLEANING AND CARE Before cleaning the air conditioner ,be sure to turn it off and disconnect CAUTION! the Power Supply Cord. Be sure the Intake Grill is installed securely. When removing and replacing the air filters, be sure not to touch the heat exchanger, as personal injury may result. 4. Re-attach the Air Filters to the Intake Grill. 1 The Filters fit onto the inside of the intake Cleaning the Air Filter Grill. (figure 1) 2 The bottom edges of the Air Filters should (For Series 14,18) fit i
