Bedienungsanleitung JL Audio Stealthbox SB-T-CMRY/12W3v3

Inhaltszusammenfassung zur Seite Nr. 1

SB-T-CAM/12W3V3 INSTR_SKU# 011284
Installat Ion

d I F F I C u l t Y :

If you choose to perform the installation yourself, it is absolutely vital that
®
out
the Stealthbox be properly mounted to the vehicle according to these
o F
instructions. Failure to mount the enclosure properly presents two problems:
I n s t a l l a t I o n G u I d e
for the 1) The sub-bass performance will suffer due to the movement of the enclosure
35
caused by the force exerted by the woofer(s).
SB-T-CAM/12

Inhaltszusammenfassung zur Seite Nr. 2

SB-T-CAM/12W3V3 INSTR_SKU# 011284 s t e P 4 S T E P 8 Remove the strap that secured the Jack to the locating foam, Re-install both floor panels that were removed in ste P 2. this will be re-used to secure the jack to the spare tire. Install both of the brackets on the bottom of the enclo- sure as shown s t e P 5 S T E P 9 Remove the spare tire and turn it over. Put the jack inside Remove the trunk liner fastening plug, this will be replaced the wheel and, expand it so that the pressure from

Inhaltszusammenfassung zur Seite Nr. 3

SB-T-CAM/12W3V3 INSTR_SKU# 011284 s t e P 1 2 S T E P 1 6 Attach the upper mounting bracket into the just installed Test the Stealthbox® to ensure proper operation then, 1/4-20 Rivet Nut using One of the supplied 1/4-20 Phillips remount using the supplied three Phillips Head Screws, Split Head Screws. The correct order of the hardware is indicated Lock Washers and, Flat Washers. in the illustration below. s t e P 1 3 S T E P 1 7 The two lower brackets from the Stealthbox® should be con- LOC

Inhaltszusammenfassung zur Seite Nr. 4

SB-T-CAM/12W3V3 INSTR_SKU# 011284 I n C l u d e d H a R d W a R e 3) 1/4-20 Rivet Nut 3) 1/4-20 x 1” Hex Head Bolt 3) 1/4” Split Lock Washer 6) 1/4” Flat Washer 3) 1/4-20 x 5/8” Pan Head Phillips Screw s P e C I F I C a t I o n s Enclosure Type: Acoustic Suspension (sealed) Driver Type: 12W3v3-4 Nominal Impedance: 4 Ohms Continuous Power Handling: 500 Watts P o W e R R e C o m m e n d a t I o n JL Audio recommends using a high quality amplifier such as the JL Audio 250/1v2. The diagram