Inhaltszusammenfassung zur Seite Nr. 1
Introduction
2
DIGITAL VIDEO
Connections
13
COMBINATION FLAT COLOR
Basic setup
TELEVISION AND DVD VIDEO
18
PLAYER
TV operation
20
Basic playback
28
MD20F51
Advanced playback
31
MD24F51
Function setup
41
OWNER’S MANUAL
Others
47
Illustration of MD24F51
©2005 Toshiba Corporation
Before operating the unit, please read this manual thoroughly.
5S10101A [E] (Cover) 1 2/5/05, 9:41 AM
Inhaltszusammenfassung zur Seite Nr. 2
Introduction IMPORTANT SAFEGUARDS The lightning flash with arrowhead symbol, within an equilat- eral triangle is intended to alert the user to the presence of CAUTION RISK OF ELECTRIC SHOCK uninsulated dangerous voltage within the product's DO NOT OPEN enclosure that may be of sufficient magnitude to constitute a risk of electric shock. CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER The exclamation point within an equilateral triangle is intended (OR BACK). NO USER-SERVICEABL
Inhaltszusammenfassung zur Seite Nr. 3
Introduction 1. READ INSTRUCTIONS All the safety and operating instructions should be read before the unit is operated. 2. RETAIN INSTRUCTIONS The safety and operating instructions should be retained for future reference. 3. HEED WARNINGS All warnings on the unit and in the operating instructions should be adhered to. 4. FOLLOW INSTRUCTIONS All operating and use instructions should be followed. 5. CLEANING Unplug this unit from the wall outlet before cleaning. Do not use liquid cleaners or aeros
Inhaltszusammenfassung zur Seite Nr. 4
Introduction (Continued) IMPORTANT SAFEGUARDS 14. POWER LINES An outside antenna system should not be located in the vicinity of overhead power lines or other electric light or power circuits, or where it can fall onto or against such power lines or circuits. When installing an outside antenna system, extreme care should be taken to keep from touching such power lines or circuits, as contact with them might be fatal. 15. OVERLOADING Do not overload wall outlets and extension cords, as this can r
Inhaltszusammenfassung zur Seite Nr. 5
Introduction 28. DISC Do not use a cracked, deformed, or repaired disc. These discs are easily broken and may cause serious personal injury and product malfunction. 29. NOTE TO CABLE TV SYSTEM INSTALLER This reminder is provided to call the Cable TV system installer’s attention to Article 820-40 of the NEC that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be con- nected to the grounding system of the building, as close to the point of cable e
Inhaltszusammenfassung zur Seite Nr. 6
Wait! Introduction Precautions Notes on handling Notes on moisture condensation 3 When shipping the unit, the original shipping carton Moisture condensation damages the unit. Please and packing materials come in handy. For maximum read the following carefully. protection, repack the unit as it was originally packed at the factory. Moisture condensation occurs, for example, when you 3 Do not use volatile liquids, such as insect spray, near pour a cold drink into a glass on a warm day. Drops of th
Inhaltszusammenfassung zur Seite Nr. 7
Introduction Notes on discs On handling discs Structure of disc contents Do not touch the playback side of the disc. Normally, DVD video discs are divided into titles, and the titles are sub-divided into chapters. Video CDs and Audio CDs are divided into tracks. DVD video disc DVD video disc Title 1 Title 2 Chapter 1 Chapter 2 Chapter 1 Chapter 2 Chapter 3 Playback side Do not attach paper or tape to discs. Video CD/Audio CD Video CD/Audio CD Track 1 Track 2 Track 3 Track 4 Track 5 On cleaning d
Inhaltszusammenfassung zur Seite Nr. 8
Introduction Notes on discs (Continued) About this owner’s manual Playable discs This owner’s manual explains the basic instructions of This unit can play the following discs. this unit. Some DVD video discs are produced in a Disc Maximum manner that allows specific or limited operation during Disc Mark Contents Size playback time playback. As such, the unit may not respond to all operating commands. This is not a defect in the unit. Approx. 4 hours Refer to instruction notes of discs. (single s
Inhaltszusammenfassung zur Seite Nr. 9
Introduction Contents Introduction Advanced playback IMPORTANT SAFEGUARDS............................ 2 Zooming ......................................................... 31 Precautions ....................................................... 6 Locating desired scene .................................. 31 Notes on discs................................................... 7 Marking desired scenes ................................. 32 Contents ...........................................................
Inhaltszusammenfassung zur Seite Nr. 10
Introduction Identification of controls See the page in for details. Front Illustration of MD24F51 POWER indicator 20 Remote sensor 12 AUDIO (L/R)/VIDEO IN jacks (LINE IN 2) 15 Disc tray 28 HEADPHONE jack 21 VOLUME ( / ) buttons 20 POWER button 18 CHANNEL ( / ) buttons 21 OPEN/CLOSE ( ) button 28 PLAY ( ) button 28 SKIP ( / ) buttons 30 STOP( ) button 28 Model MD24F51 has a door on the front panel. Please open it to access the HEADPHONE jack and the AUDIO (L/R)/ VID
Inhaltszusammenfassung zur Seite Nr. 11
Introduction Remote control The instructions in this manual describe the function on the remote control. See the page in for details. 28 18 28 21 #$%& &’( %) 20 %)%& # *+ ,- . %$ *+ ,- 24 21 31 21 20 36 27 36 15 21 31 35 33 18 *- #$%& #
Inhaltszusammenfassung zur Seite Nr. 12
Introduction Identification of controls (Continued) Inserting batteries Open the battery compart- Install two “R03/AAA” Replace the compartment 12 3 ment cover in the direction of batteries (supplied), paying cover. the arrow. attention to the polarity diagram in the battery compartment. Operation • Aim the remote control at the remote sensor and press control buttons to operate. • Operate the remote control within 30° angle on either side of the remote sensor, up to a distance of approx. 5 mete
Inhaltszusammenfassung zur Seite Nr. 13
Connections Connections Antenna connections If you are using an indoor or outdoor antenna, follow the instructions below that correspond to your antenna system. If you are using a cable TV service (CABLE), see page 14 for Cable TV connections. Combination VHF/UHF antenna (Single 75 ohm cable or 300 ohm twin-lead wire) Connect the 75 ohm cable from the combination Antenna Antenna VHF/UHF antenna to the antenna jack. jack jack If your combination VHF/UHF antenna has a 300 ohm twin-lead wire, the u
Inhaltszusammenfassung zur Seite Nr. 14
Connections Cable TV connections This TV/DVD has an extended tuning range and can tune most cable channels without using a Cable TV converter box. Some cable companies offer “premium pay channels” in which the signal is scrambled. Descrambling these signals for normal viewing requires the use of a descrambler device which is generally provided by the cable company. For subscribers to basic cable TV service Antenna For basic cable service not requiring a converter/descrambler jack box, connect th
Inhaltszusammenfassung zur Seite Nr. 15
Connections INPUT Connecting to optional equipment You can enjoy VCR, camcorder or TV game with connection to external input. To select the external input, press INPUT and select “LINE1” or “LINE2” mode. GAME Using the audio/video inputs Press INPUT repeatedly to select the desired mode. “LINE1”, “LINE2” or TV channel will display on the screen for 4 seconds. TV Channel LINE 1 LINE 2 (Back) (Front) Note: In the DVD mode this key will not operate. To connect the TV/DVD to a VCR Press INPUT
Inhaltszusammenfassung zur Seite Nr. 16
Connections Connecting to optional equipment (Continued) This section uses the following reference mark. You can enjoy high quality dynamic sounds by connecting the * TV/DVD to optional audio equipment. : Front speaker : Center speaker : Rear speaker : Signal flow : Sub woofer Connecting to an amplifier equipped with a Dolby Digital decoder Dolby Digital Dolby Digital is the surround sound technology used in theaters showing the latest movies, and is now available to reproduce this realistic ef
Inhaltszusammenfassung zur Seite Nr. 17
Connections Connecting to an amplifier equipped with an MPEG2 audio decoder MPEG2 sound You can enjoy motion picture and live concert DVD video discs encoded via the MPEG2 recording system with dynamic realistic sound by connecting an amplifier equipped with an MPEG2 audio decoder or MPEG2 audio processor. Illustration of MD24F51 Amplifier equipped with an MPEG2 audio decoder To COAXIAL • Use DVD video discs type digital encoded via the Dolby audio input 75 Ω coaxial cable (not supplied) Digital
Inhaltszusammenfassung zur Seite Nr. 18
Basic setup POWER Starting setup The STARTING SETUP function makes installing your TV/DVD easily. It leads you the Language selection, TV/CABLE selection and auto channel memory automatically. / IMPORTANT: Make sure that the antenna or cable TV system connection ENTER is made! CANCEL Starting setup Press POWER. Now the “AUTO CH MEMORY” starts. The starting setup function begins and the After the starting setup is completed, the TV 4 1 Language setup menu appears on the screen. channel appears on
Inhaltszusammenfassung zur Seite Nr. 19
Basic setup Setting the language This TV/DVD can display the on screen language in English, Spanish or French. Select the language you prefer first, then proceed with the other menu options. ENTER / / / MENU Setting the language Press MENU, then press or to select option. 1 LANGUAGE/IDIOMA/LANGUE ENGLISH ESPAÑOL FRANCAIS /MENU Press or to select the desired language: English (ENGLISH), Spanish (ESPAÑOL) or 2 French (FRANCAIS), then press ENTER. LANGUAGE/IDIOMA/LANGUE ENGLISH ESPAÑOL FRANCAI
Inhaltszusammenfassung zur Seite Nr. 20
TV operation POWER 0–9 TV operation VOL +/– TV operation To turn on the TV/DVD, press POWER. Press Direct channel selection buttons (0–9) The Power indicator will light. to select the channel. 4 1 TV mode direct channel selection When the TV/CABLE selection is in the TV position, all channels can be instantly selected by using two buttons. (for example, to select channel 2, press “0”, Adjust the volume level by pressing VOL + or –. then “2”. If you press only “2”, The volume level will be
