Inhaltszusammenfassung zur Seite Nr. 1
Owner/Operator
Manual
2-Cycle Trimmer
• Safety
• Assembly
• Operation
• Maintenance
Models
TB2000 – 22.5cc Curved Shaft
©2000 MTD SOUTHWEST INC FORM 182821 (1/01) (10201 rev. A)
Printed in U.S.A.
Inhaltszusammenfassung zur Seite Nr. 2
Introduction THANK YOU Thank you for buying this quality product. This modern outdoor power tool will provide many hours of useful service. You will find it to be a great labor-saving device. This operator’s manual provides you with easy-to-understand oper- ating instructions. Read the whole manual and follow all the instructions to keep your new outdoor power tool in top operating condition. PRODUCT REFERENCES, ILLUSTRATIONS AND SPECIFICATIONS All information, illustrations and specifications
Inhaltszusammenfassung zur Seite Nr. 3
Service Information SERVICE INFORMATION Service on this unit both within and after the warranty period should be performed only by an authorized and approved service dealer. Dial: • 1-800-345-8746 for authorized service dealers in the United States Or • 1-800-668-1238 in Canada to obtain the listing of the authorized service dealer nearest you. DO NOT RETURN THE UNIT TO THE RETAILER. NOTE: PROOF OF PURCHASE WILL BE REQUIRED FOR WARRANTY SERVICE. Make sure this manual is carefully read and un
Inhaltszusammenfassung zur Seite Nr. 4
Section 1 Safety The purpose of safety symbols is to attract your attention to possible dangers. The safety symbols, and their explanations, deserve your careful attention Failure to obey a safety warning will result in and understanding. The safety warnings do not by serious injury to yourself or to others. Always fol- themselves eliminate any danger. The instructions or low the safety precautions to reduce the risk of warnings they give are not substitutes for proper fire, electric shock,
Inhaltszusammenfassung zur Seite Nr. 5
Safety (continued) • Always stop the engine and allow it to cool before • Always hold the unit with both hands when operat- filling the fuel tank. Never remove the cap of the fuel ing. Keep a firm grip on both the front and rear han- tank, or add fuel, when the engine is hot. Never dle or grips. operate the unit without the fuel cap securely in • Keep hands, face, and feet at a distance from all place. Loosen the fuel tank cap slowly to relieve any moving parts. Do not touch or try to stop the
Inhaltszusammenfassung zur Seite Nr. 6
Safety (continued) SAFETY AND INTERNATIONAL SYMBOLS This operator's manual describes safety and international symbols and pictographs that may appear on this product. Read the operator's manual for complete safety, assembly, operating and maintenance and repair information. SYMBOL MEANING • SAFETY ALERT SYMBOL Indicates danger, warning, or caution. May be used in conjunction with other symbols or pictographs. • WARNING - READ OPERATOR'S MANUAL Read the Operator’s Manual(s) and follow all warni
Inhaltszusammenfassung zur Seite Nr. 7
Safety (continued) SYMBOL MEANING • ON/OFF STOP CONTROL ON / START / RUN • ON/OFF STOP CONTROL OFF OR STOP • HOT SURFACE WARNING Do not touch a hot muffler, gear housing or cylinder. You may get burned. These parts get extremely hot from operation. When turned off they remain hot for a short time. • SHARP BLADE WARNING: Sharp blade on cutting attachment shield. To prevent serious injury, do not touch line cutting blade. • CHOKE CONTROL A • START position. B • RUN position. • DO NOT USE BLADES
Inhaltszusammenfassung zur Seite Nr. 8
Section 2 Know Your Unit APPLICATIONS As a trimmer; • Cutting grass and light weeds. • Edging • Decorative trimming around trees, fences, etc. Spark Plug Starter Rope Grip Gas Cap Shaft Grip Air Filter Cover Throttle Control On/Off Stop Control D-Handle Shaft Housing Choke Lever Primer Bulb Cutting Attachment Line Cutting Blade Cutting Attachment Shield 8
Inhaltszusammenfassung zur Seite Nr. 9
Section 3 Assembly (4) Screws Shaft Grip (4) Screws Shaft Housing Fig. 3-4 Minimum 6 inches (15.24 cm) On some units, the D-handle may be preinstalled and only require loosening the screws and adjusting the D-Handle D-handle to the operator. Go to step 4 for adjusting the D-handle if preinstalled. Bottom Clamp INSTALLING AND ADJUSTING THE D-HANDLE (4) Nuts 1. Remove the screws, nuts and bottom clamp piece that were installed on the D-handle for shipping. Fig. 3-1 2. Place D-handle the over th
Inhaltszusammenfassung zur Seite Nr. 10
Section 4 Oil and Fuel If unavailable, use a good 2-cycle oil designed for air-cooled engines along with a fuel additive, such as STA-BIL® Gas Stabilizer or an equivalent. Add 0.8 oz. (23 ml) of fuel additive per gallon of fuel according to the instructions on the container. NEVER add fuel addi- + tives directly to the unit's fuel tank. For proper engine operation and maximum relia- UNLEADED GAS TROY-BILT 2 CYCLE OIL bility, pay strict attention to the oil and fuel mix- ing instructions on the
Inhaltszusammenfassung zur Seite Nr. 11
Section 5 Operation Avoid accidental starting. Be in the starting Start/ position whenever pulling the starting rope. To On (I) avoid serious personal injury, the operator and unit must be in a stable position while starting. STARTING INSTRUCTIONS Stop/ 1. Mix gas with oil. Fill fuel tank with fuel/oil mixture. Off (O) See Section 4, Oil and Fuel. On/Off Stop Control 2. Put the On/Off Stop Control in the START (I) Fig. 5-1 position (Fig. 5-1). 3. Fully press and release primer bulb slowly 5 to
Inhaltszusammenfassung zur Seite Nr. 12
Operation (continued) Do not remove or alter the line cutting blade assembly. Excessive line length will make the clutch overheat. This may lead to serious person- al injury or damage to the unit. Some line breakage will occur from: • Entanglement with foreign matter • Normal line fatigue • Attempting to cut thick, stalky weeds • Forcing the line into objects such as walls or fence posts TIPS FOR BEST TRIMMING RESULTS • Keep the cutting attachment parallel to the ground. Fig. 5-4 • Do not force
Inhaltszusammenfassung zur Seite Nr. 13
Operation (continued) DECORATIVE TRIMMING Decorative trimming is accomplished by removing all vegetation around trees, posts, fences, etc. Rotate the whole unit so that the cutting attachment is at a 30° angle to the ground (Fig. 5-5). Fig. 5-5 Section 6 MAINTENANCE NOTE: Some maintenance procedures may require special tools or skills. If you are unsure about these procedures take your unit to an authorized service To prevent serious injury, never do maintenance dealer. or repairs with unit r
Inhaltszusammenfassung zur Seite Nr. 14
Maintenance (continued) LINE INSTALLATION This section covers both Membrane line and standard single line installation. Always use manufacturer’s 0.080 inch (2.03 mm) Tab replacement line. Line other than specified may make the engine overheat or fail. Never use metal-reinforced line, wire, chain, or rope, etc. These can break off and become a dangerous projectile. PRESS TABS TO REMOVE There are two methods to replace the trimming line. Fig. 6-1 • Wind the inner reel with new line • Install a
Inhaltszusammenfassung zur Seite Nr. 15
Maintenance (continued) 12. Insert the ends of the line into the two holding slots Slotted (Fig. 6-6). Leave about 4 inches (102 mm) of line Hole beyond the holding slots. 13. Insert the ends of the line through the eyelets in the outer spool and place inner reel inside the outer spool (Fig. 6-7). 14. While holding the inner reel and outer spool, grasp the ends and pull firmly to release the line from the holding slots in the inner reel. 15. Push the bottom cover into the outer spool until it
Inhaltszusammenfassung zur Seite Nr. 16
Maintenance (continued) AIR FILTER MAINTENANCE Cleaning the Air Filter Carburetor/ Air Filter Cover To avoid serious personal injury, always turn your trimmer off and allow it to cool before you clean or do any maintenance on it. Tab Clean and re-oil the air filter every 10 hours of opera- tion. It is an important item to maintain. Not maintain- ing the air filter will VOID the warranty. Fig. 6-9 1. Remove the carburetor/air filter cover by pushing on the tab on top of the cover (Fig. 6-9). 2.
Inhaltszusammenfassung zur Seite Nr. 17
Maintenance (continued) If after checking the fuel mixture and cleaning the air REPLACING THE SPARK PLUG filter the engine still will not idle, adjust the idle speed Use a Champion RCJ6Y spark plug (or equivalent). The screw as follows. correct air gap is 0.025 inch (0.655 mm). Remove the 1. Start the engine and let it run at a high idle for a plug after every 50 hours of operation and check its minute to warm up. condition. 2. Release the throttle trigger and let the engine idle. If 1. Stop
Inhaltszusammenfassung zur Seite Nr. 18
Maintenance (continued) ACCESSORIES/REPLACEMENT PARTS LONG TERM STORAGE If the unit will be stored for an extended time, Spark Plug . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 181765 1. Drain all fuel from the gas tank into a container. Do Spark Arrestor . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 182153 not use fuel that has been stored for more than 60 Replacement Line Cartridge . . . . . . . . . . . . . . . . 49U0333L063 days. Dispose of the old fuel
Inhaltszusammenfassung zur Seite Nr. 19
Section 7 Troubleshooting ENGINE WILL NOT START CAUSE ACTION On/Off Stop Control is in STOP position Turn On/Off Stop Control to START Empty fuel tank Fill fuel tank with properly mixed fuel Primer bulb wasn't pressed enough Press primer bulb fully and slowly 5-7 times Engine flooded Use starting procedure with choke lever in the RUN position, Pg. 11 Old or improperly mixed fuel Drain gas tank / Add fresh fuel mixture Fouled spark plug Replace or clean the spark plug ENGINE WILL NOT IDLE CAUSE
Inhaltszusammenfassung zur Seite Nr. 20
Section 8 Specifications ENGINE Engine Type . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Air-Cooled, 2-Cycle Displacement . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1.37 cu. in. (22.5 cc) Clutch Type . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
